Italiano dropdown-ico

Manuale per l’uso Telex USR-100

26 pagine 0.38 mb
Scarica

Vai alla pagina of 26

Summary
  • Telex USR-100 - page 1

    T elex Operating Instructions USR-100 ...

  • Telex USR-100 - page 2

    Table of Contents General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 USR-100 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Frequency Agility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Channel Lockout . . . . . . . . . . . . . . . . . . . . ...

  • Telex USR-100 - page 3

    Table of Contents (continued) SH-100 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Power Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Battery Test Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Battery Meter . . . . . . . . . . . . . . . . . . . . ...

  • Telex USR-100 - page 4

    GENERAL INFORM ATION The Telex Model USR-100 Receiver and associated Transmitters is a 100 Channel, frequency-selectable full diversity system operating within the frequency range of 668.0 to 746.0 MHz on specific pre-set frequen - cies. Systems consisting of the USR-100 and its companion transmitter are capable of operating on at least 5 frequenci ...

  • Telex USR-100 - page 5

    Posi Phase Diversity The USR-100 receiver utilizes Telex’s patented Posi Phase auto diversity circuit. Unlike other types of diversity which receive with only one antenna at a time, Posi Phase utilizes both antennas at all times. This results in a stronger signal from the microphone for cleaner audio and greater range. If the microphone signal be ...

  • Telex USR-100 - page 6

    Displays The 7 Segment LED channel display already mentioned (00 to 99). 2. A 5 segment LED light array for AF, that aids in setting micro - phone gains and monitoring receiver microphone and line level outputs. Light numbers 4 and 5 have a Peak Hold feature. 3. A 5 segment LED light array for R F , that aids in checking the transmitter and monitor ...

  • Telex USR-100 - page 7

    USR-100 Receiver Specifications RF Frequency Range . . . . . . . . . . . . . . . 668.0 to 746.0 MHz Channels . . . . . . 100 (0-99) (within TV Ch. 47/48 & 58/59) R.F. Stability . . . . . . . . . . . . . . . . . . . . . . . . 0.005% or better Modulation Type . . . . . . . . . . . . . . . . . FM, 40 KHz nominal Type . . . . . . . . . . . . . . . ...

  • Telex USR-100 - page 8

    Model SH-100 Transmitter Specifications Frequency of operation . . . . . . . . . 668.000 to 746.000 MHz. (Current models operate in 2 frequency ranges.) 668.000 to 679.500 MHz and 734.100 to 745.500 MHz. Number of Channels . . . . . . . . 100 User Selectable Channels in each range. Power Output (Terminated) . . . 10 mW, High switch setting, 1.0 mW ...

  • Telex USR-100 - page 9

    Model LT-100 Transmitter Specifications Frequency of operation . . . . . . . . . 668.000 to 746.000 MHz. (Current models operate in 2 frequency ranges.) 668.000 to 679.500 MHz and 734.100 to 745.500 MHz. Number of Channels . . . . . . . . . . . . . . . . 100 User Selectable Channels in each range. Power Output (Terminated) . . . . 10 m W, High swit ...

  • Telex USR-100 - page 10

    Figure 1 Front Panel Power Switch: When turned on, the channel display illuminates and one of the diversity lights will come on. Channel Select Buttons: Push once to increase display by one. Push and hold to increase display more than one. Left button changes “10’s”, Right button changes “1’s”. Channel Lockout: To enable/disable Channel ...

  • Telex USR-100 - page 11

    Figure 2 Rear Panel Antenna Jacks: Two antenna jacks for posi phase diversity recep - tion. Attach an antenna to each jack. Audio Output: XLR type jack connects to audio sound system (Amplifier/Mixer). Pin 1 ground, Pin 2 +, Pin 3 -. Audio Adjust: Screwdriver adjustable potentiometer, controls audio output. Use supplied screwdriver to adjust to des ...

  • Telex USR-100 - page 12

    Receiver Set-up Connect the supplied AC power adapter to an AC outlet supplying 105 to 125 volts AC, 60 Hz. The 230 volt export model should connect to an AC outlet supplying 210-240 VAC, 50-60 Hz. Connect the USR-100 to your equipment: Insert a 3 pin female “XLR” audio connector and cable into the Audio Output receptacle on the rear of the USR ...

  • Telex USR-100 - page 13

    Figure 4 SH-100 Bottom View -10- ...

  • Telex USR-100 - page 14

    SH-100 Power Switch: Located on the bottom of the handle. Battery Test Button: Press to check the remaining life of the batteries. Battery Meter: The number of segments that light when the Battery Test Button is pushed indicate the approximate time of battery life remaining. Channel Select Switches: Control the transmit channel. Must be set to matc ...

  • Telex USR-100 - page 15

    Figure 5 LT-100 LT-100 Power Switch: Located on the top of the case. Battery Test Button: Press to check the remaining life of the batteries. Battery Meter: The number of segments that light when the Battery Test Button is pushed indicate the approximate time of battery life remaining. Microphone Connector: wired as follows: Top View Back View Pin ...

  • Telex USR-100 - page 16

    Channel Select Switches: Control the transmit channel. Must be set to match the channel of the receiver. Microphone Gain: Controls the gain of the audio circuit to prevent under or over modulation. Transmit Power Switch: Set to high for maximum range. Set to low to prolong battery life. Set-Up NOTE: Do not use carbon-zinc batteries. Ni-Cad batterie ...

  • Telex USR-100 - page 17

    System Set-Up NOTE: Whe employing two or more wireless microphones, the transmitters should be a minimum of 10-15 feet away from the receiver(s) to prevent “front-end” overload. Turn on the receiver. Set the Channel to the number desired on both the transmitter and receiver. Check the RF lights. If any light except light #1 is on, this indicate ...

  • Telex USR-100 - page 18

    Remote mounting antennas will increase the effective reception range when appropriately positioned. The two 1/4 wave antennas supplied are not ground independent and therefore not appropriate for remote mounting. See the accessories section of this manual for remote- mountable antenna options. The diversity antenna system operates most efficiently ...

  • Telex USR-100 - page 19

    Figure 7 Antenna Placement with Accessory Brackets and Cables If possible, do not mount the brackets on a wall. See Figure 7 for bracket and antenna placement. Antenna Connection Attach the two antenna cables to the back of the USR-100. Be sure the connectors are tightened securely. Route the cable to the antennas and attach in the same manner. -16 ...

  • Telex USR-100 - page 20

    Installing Rack Mounts The USR-100 is supplied with rack mounts for both double and single mounting in a 19" equipment rack. For single mounting, the long and short rack “ears” are used. For dual mounting, use the short “ears and the mid brackets from two USR-100’s. Figure 8 Assembly of Rack Mount Assembly To assemble the rack mount to ...

  • Telex USR-100 - page 21

    Double Mounting: Align the mid brackets (Item No. 2) with the holes on the adjacent sides of each unit. Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining holes. Tighten all screws securely. Place the two assemblies side by side with the mid brackets together. (The left brack ...

  • Telex USR-100 - page 22

    ACCESSORIES AND REPLACEMENT PARTS Model AB-2 Combination Antenna Bracket with hardware and 10 foot (3 meter) coaxial cable TNC Connectors. Use with Model CAL-X Antennas. Order No. 71138000 AC Power Supply 120 V olt, 60 Hz Order No. 730131 1/4 Wave Replacement Antenna Part No. 879010 Model CLA-X - 1/2 Wave Antenna - for remote mounting Model Part No ...

  • Telex USR-100 - page 23

    Model ALP-450 450-900 MHz Directional Log Periodic Antenna includes mounting hardware and 10 foot (3 meter) coaxial cable with TNC Connectors. 9 1/2" long x 11" high. Unique forward coverage pattern increases signal gain up to 5 db. Covers all frequencies and increases range. Order No. 71147000 Model UAD-2 Four Way Antenna Splitter Order ...

  • Telex USR-100 - page 24

    FCC INFORM ATION The TELEX Model USR-100 receiver is authorized under Part 15 of the Federal Communication Commission. Licensing of TELEX equip - ment is the user’s responsibility and licensability depends upon the user’s classification, and frequency selected. TELEX strongly urges the user to contact the appropriate telecommunications authorit ...

  • Telex USR-100 - page 25

    CUSTOMER SERVICE INFORMATION If your receiver or transmitter should need servicing under the warranty, please contact: Customer Service Department TELEX COMMUNIC ATIONS, INC. 8601 East Cornhusker Highway, P.O. Box 5579, Lincoln, Nebraska 68505-5579 U.S.A. Phone: (402) 467-5321 or 465-7021 FAX: (402) 467-3279 All claims of defect or shortage should ...

  • Telex USR-100 - page 26

    TELEX COMMUNICATIONS, INC. 8601 East Cor nhusker Highway w P.O. Box 5579 w Lincoln, Nebraska 68505-5579 PN 801585-1 JUNE 1998 ...

Fabbricante Telex Categoria Microphone

I documenti che otteniamo dal fabbricante del dispositivoTelex USR-100 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Telex
- manuali per l’uso USR-100
- schede prodotto Telex
- opuscoli
- o etichette energetiche Telex USR-100
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Telex USR-100.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Telex USR-100, manuali di manutenzione, brevi manuali o manuali utente Telex USR-100. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Telex USR-100.

Manuali per l’uso simili

Manuale completo del dispositivo Telex USR-100, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Telex USR-100 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Telex USR-100.

Il manuale per l’uso completo Telex, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Telex USR-100 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Telex USR-100, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Telex USR-100 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Telex USR-100 - che ci dovrebbe aiutare nei primi passi durante l'uso Telex USR-100
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Telex USR-100
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Telex USR-100 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Telex USR-100?

Utilizza il modulo sottostante

Se non hai risolto il problema con Telex USR-100 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Telex USR-100 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)