Manuale per l’uso Snapper P217018BVE

32 pagine 1.86 mb
Scarica

Vai alla pagina of 32

Summary
  • Snapper P217018BVE - page 1

    Safety Instructions & Operator’s Manual for 21” STEEL DECK WALK MOWERS SERIES 18 MODEL NUMBER EXPLANATION P 21 70 18 B V E SELF-PROPELLED ENGINE OPTION CUTTING WIDTH ENGINE DESIGNATION ENGINE HORSE POWER * SERIES DESIGNATION R – Recycling Model P – Self Propelled Model 18 - Series Designation 21 – 21” Cutting Width 60 – 6.0 HP (En ...

  • Snapper P217018BVE - page 2

    2 IMPORTANT SAFETY INSTRUCTIONS WARNING: This pow erful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply w ith the follow ing SAFETY instructions could result in serious injury or death to the operator or other persons. The owner of the machine must understand these in ...

  • Snapper P217018BVE - page 3

    3 IMPORTANT SAFETY INSTRUCTIONS SAFE HANDLING OF GASOLINE (Continued From Previous Page) 3. DO NOT remove fuel cap or add fuel w ith the engine running. Allow the engine to cool before refueling. 4. DO NOT refuel the machine indoors. 5. DO NOT store the machine or fuel container inside w here there is an open flame, spark or pilot light such as on ...

  • Snapper P217018BVE - page 4

    4 IMPORTANT SAFETY INSTRUCTIONS MAINTENANCE AND STORAGE (Continued From Previous Page) 9. Mow er blades are sharp and can cut. Wrap the blades or w ear heavy leather glov es and use CAUTION w hen handling them. 10. DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine. 11. Have machine ser ...

  • Snapper P217018BVE - page 5

    5 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ...................................................................... 2 - 4 TABLE OF CO NTENTS ...................................................................................................... 5 SECTION 1 - FAMI LIARIZATI ON...................................................................... ...

  • Snapper P217018BVE - page 6

    6 Section 1 - FAMILIARIZATION FIGURE 1.1 1.1 INTRODUCTION This manual has been prepared for the operators of the SNAPPER WALK BEHIND MOWERS. Its purpose, aside from recommending operating and routine service requirements, is to promote safety through the use of accepted operating practices. Read, Understand and Follow the “IMPORTANT SAFETY INSTRU ...

  • Snapper P217018BVE - page 7

    7 Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened. 2.1.2. Check blade control, wheel drive control, and engine speed control to insure they w ...

  • Snapper P217018BVE - page 8

    8 Section 2 - OPERATING INSTRUCTIONS 2.2 STARTING & OPERATION 2. 2. 1. EN GI NE & BLADE (Kawasaki Engine) 1. Make sure fuel valve on engine is open. See Figure 2.5. FIGURE 2.5 2. Move engine speed control past “Fast” detent to “C ho ke ” position. See Figure 2.4 and “FAMILIARIZATION”. 3. Pull blade control against handle. 4. Pul ...

  • Snapper P217018BVE - page 9

    9 Section 2 - OPERATING INSTRUCTIONS 2. Set all wheels at the same cutting height. The highest cutting position is Notch 6. The lowest cutting position is Notch 1. See Figures 2.8 & 2.9. FIGURE 2.9 2.6 INSTALLATION of GRASS BAG ADAPTER WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and ...

  • Snapper P217018BVE - page 10

    10 Section 2 - OPERATING INSTRUCTIONS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 2.8 INSTALLATION of GRASS BAG ( ...

  • Snapper P217018BVE - page 11

    11 Section 2 - OPERATING INSTRUCTIONS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. FIGURE 2.16 2.11 INSTALLATION o ...

  • Snapper P217018BVE - page 12

    12 Section 3 – MAINTENANCE 3.1 INTRODUCTION To retain the quality of the mower, use genuine SNAPPER replacement parts only. Contact a local SNAPPER dealer for parts and service assistance. For the correct part or information for a particular mower, always mention model and serial number. WARNING DO NOT attempt any maintenance, adjustments or serv ...

  • Snapper P217018BVE - page 13

    13 Section 3 – MAINTENANCE WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves w hen handling ...

  • Snapper P217018BVE - page 14

    14 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves w h ...

  • Snapper P217018BVE - page 15

    15 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4. Sharpen blade on a grindin ...

  • Snapper P217018BVE - page 16

    16 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3 DRIVEN AND DRIVE DISC SER ...

  • Snapper P217018BVE - page 17

    17 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.3. DRIVEN DISC ADJUSTMENT ...

  • Snapper P217018BVE - page 18

    18 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.4. Replacing Rubber Drive ...

  • Snapper P217018BVE - page 19

    19 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.6. Replacement Of Bearing ...

  • Snapper P217018BVE - page 20

    20 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.4.1. Engine Drive Belt Repl ...

  • Snapper P217018BVE - page 21

    21 Section 4 - REPAIR & ADJUSTMENTS 4.5. BATTERY SERVICE 4.5.1. NEW BATTERY PREPARATION 1. Remove battery from carton. 2. Place battery in a well ventilated area on a level non-concrete surface. 3. Remove battery cell caps. Fill cells as required with electrolyte (supplied with battery) to proper level. Filling battery with electrolyte will bri ...

  • Snapper P217018BVE - page 22

    22 TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not Start 1. Fuel tank empty. 1. F ill fuel tank w ith fresh fuel. Using Recoil Starter 2. Engine needs choking or priming. 2. Choke/Prime. Check Engine Manual for Instructions. 3. Spark plug wire disconnected. 3. Place spark plug w ire onto spark plug. 4. Kawasaki Engines Only ...

  • Snapper P217018BVE - page 23

    23 SERVICE SCHEDULE ITEM SERVICE PERFORMED REF. EACH USE 5 HRS 25 HRS 50 HRS 100 HRS EACH SEASON Engine Oil Check Oil Level Page 7 X Initial Oil Change Page 12 X Periodic Oil Change Page 13 X* Air Pre-Cleaner Clean Sponge Element Engine Manual X** Air Cleaner Clean or Replace Engine Manual X** Spark Plug Replace Engine Manual X Engine Cooling Syste ...

  • Snapper P217018BVE - page 24

    24 2 YEAR LIMITED WARRANTY For two (2) years from purchase date for the orig inal purchaser's residential, non-commercial use, SNAPPER , through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at McDonough, Georgia, to be defective in materi ...

  • Snapper P217018BVE - page 25

    25 PRIMARY MAINTENANCE ...

  • Snapper P217018BVE - page 26

    26 PRIMARY MAINTENANCE ...

  • Snapper P217018BVE - page 27

    27 PRIMARY MAINTENANCE ...

  • Snapper P217018BVE - page 28

    28 PRIMARY MAINTENANCE ...

  • Snapper P217018BVE - page 29

    29 SNAPPER PRODUCT REGISTRATION FORM IMPORTANT: KEEP THIS INFORMATION FOR YOUR PERSONAL RECORDS (Complete the following informa tion on your Snapper purchase) Model Number _____________________________________________________________ Serial Number _____________________________________________________________ Date of Pu rchase ______________________ ...

  • Snapper P217018BVE - page 30

    30 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper P217018BVE - page 31

    31 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper P217018BVE - page 32

    32 Safety Instructions & Operator’s Manual for 21” STEEL DECK WALK BEHIND MOWERS SERIES 18 IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contai n very important emissions information and critical safety warnings. Read, Unders ...

Fabbricante Snapper Categoria Lawn Mower

I documenti che otteniamo dal fabbricante del dispositivoSnapper P217018BVE possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Snapper
- manuali per l’uso P217018BVE
- schede prodotto Snapper
- opuscoli
- o etichette energetiche Snapper P217018BVE
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Snapper P217018BVE.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Snapper P217018BVE, manuali di manutenzione, brevi manuali o manuali utente Snapper P217018BVE. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Snapper P217018BVE.

Manuali per l’uso simili

Manuale completo del dispositivo Snapper P217018BVE, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Snapper P217018BVE dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Snapper P217018BVE.

Il manuale per l’uso completo Snapper, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Snapper P217018BVE - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Snapper P217018BVE, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Snapper P217018BVE che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Snapper P217018BVE - che ci dovrebbe aiutare nei primi passi durante l'uso Snapper P217018BVE
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Snapper P217018BVE
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Snapper P217018BVE in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Snapper P217018BVE?

Utilizza il modulo sottostante

Se non hai risolto il problema con Snapper P217018BVE con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Snapper P217018BVE è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)