-
APart MA200CDR - page 1
INFO@AP ART -A UDIO .COM MANU AL MA200CDR ...
-
APart MA200CDR - page 2
WWW .AP ART -AUDIO .COM Safety First! • Read all documentation before operating your equipment. • Retain all documentation for future reference. • Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. • Do not spill water or oth ...
-
APart MA200CDR - page 3
INFO@AP ART -A UDIO .COM Content 1. APart MA200CDR Mixing Amplier 2. Front Panel 3. Rear Panel 4.T uner Controls 5. Inside Settings 6. Overview Of The MA200 Series 7. How T o Deal With 100V Loudspeakers Systems 8. T echnical Specications 9. Block Diagram ...
-
APart MA200CDR - page 4
WWW .AP ART -AUDIO .COM The MA200CDR is a professional 4 zone P A mixing amplier for commercial and industrial applica- tions. Rarely seen on its competitors, all microphone inputs have integrated speech lters and they are high-class transistor-balanced type, allowing good control of hum and noise over long cables. He’s able to drive 8-ohm ...
-
APart MA200CDR - page 5
INFO@AP ART -A UDIO .COM 7 11 12 13 14 5 4 1 2 3 1) Power switch: Here you can switch the power on and off. 2) Overload indicator: This red LED illuminates when one of the protections have been activated. No or distorted sound will be heard. This will be in case of overheating, being the result of drawing too much power from your amplier , or th ...
-
APart MA200CDR - page 6
WWW .AP ART -AUDIO .COM 3. Rear P anel 15) V oltage selector . Set the local voltage: If any doubt, contact your dealer . The unit is shipped with the selec- tor set to 230V AC. 16) Mains socket: The unit can be connected to the mains circuit by a standard IEC type power cord. This socket contains a 6,3A T , slow blow fuse. Use a screw driver to ? ...
-
APart MA200CDR - page 7
INFO@AP ART -A UDIO .COM 24) CD stereo input, 500mV : Here you can feed a line level signal. Y ou have to make your choice with the selector at the front (see 12). Stereo signals will be summed together . 25) AUX input, 500mV: Use this stereo RCA input to connect a line level source such as CD player , MD player , BGM computer , etc…. Y ou have t ...
-
APart MA200CDR - page 8
WWW .AP ART -AUDIO .COM 4. Tuner Controls AM / FM mode switch: Each time you press this button, the tuner will switch from FM to AM and the other way round. The actual radio band will be displayed at the left. Scan up / down: By pressing “UP” or “DOWN” a few seconds, the tuner will start to search the next/previous radio station with suf ...
-
APart MA200CDR - page 9
INFO@AP ART -A UDIO .COM 5. Inside Settings JP3 JP4 JP5 JP1 1 Phantom Power MIC1 : JP3 MIC2 : JP4 MIC3 : JP5 MIC4 : JP1 1 Phantom on / off jumper The MA200CDR has been shipped with these jumpers in the OFF position. For each microphone input a jumper is available. When you put a jumper to the ON position, phantom power will be supplied to the micro ...
-
APart MA200CDR - page 10
WWW .AP ART -AUDIO .COM MA200CDR • High quality 200 W atts 100 V olt mixing amplier • Integrated AM/FM tuner and CD/MP3 player • 4 mic (phantom via internal switch), 4 line inputs • 3 level priority system, 24V priority output • Integrated 2-tone chime (adjustable volume) • 4 output zones. (Zone 4: Mic / music selection) • Build in ...
-
APart MA200CDR - page 11
INFO@AP ART -A UDIO .COM In fact working with 100V loudspeakers is rather simple, when done in the right way . Each 100V loudspeaker has a 100V transformer which can be set to a certain power , for example: 1,5 3 or 6W . As the example shows, the sum of all loudspeaker settings should never exceed the amplier ’s power specications. Never us ...
-
APart MA200CDR - page 12
WWW .AP ART -AUDIO .COM PHANTOM 2 3 1 PHANTOM 2 3 1 MUTE JP4 PHANTOM 2 3 1 MUTE JP5 PHANTOM 2 3 1 MUTE JP11 MUTE VOX MUTE + - + - + - + - AUX CD TUNER Pre Amp Pre Amp Pre Amp Pre Amp + - CHIME REQ OUT PreAmp OUT PowerAmp IN + - MASTER TONE MUTE + - + - POWER AMP AUTO GAIN CONTROL 100V 70V 50V 8 ohm COM 24V/1A PRIORITY - + + Z1 + Z2 + Z3 DIN5 + MUSI ...
-
APart MA200CDR - page 13
INFO@AP ART -A UDIO .COM FREQUENCY RESPONSE 40HZ 25KHZ (+1/-3 DB) DISTORTION <0,3% @ -6DB, 1KHZ BASS CONTROL +/- 10DB, 100 HZ TREBLE CONTROL +/- 10DB, 10 KHZ S/N amplier: better than 95dB, 22Hz 22kHz line: better than 80dB, 22Hz 22kHz mic: better than 65dB, 22Hz 22kHz LED INDICA TORS limiter active, red signal 100%, yellow signal -25 dB, gree ...
-
APart MA200CDR - page 14
WWW .AP ART -AUDIO .COM MIC INPUT 1; ¼” TRS PHONE JACK A T THE FRONT XLR3 COMBO, DIN5; EURO BLOCK SENSITIVITY 1,5 MV IMPEDANCE 600 Ω S/N ( AT MAX. VOLUME) > 65 dB PHANTOM POWER 14 V (internal jumper) FREQUENCY RESPONSE > 80Hz->15Khz (+1/-3 dB) VOX MUTE trigger level 0,6 mV , 1Khz, mutes mic 2,3,4+music, > 40 dB Mic input 2,3 & ...
-
APart MA200CDR - page 15
INFO@AP ART -A UDIO .COM SPEAKER SELECTOR ZONE 1 3 on/off ZONE 4 paging on/off music on/off SPEAKER ZONE OUTPUT , EURO BLOCK HIGH Z ZONE 1-2-3-4 100 V SPEAKER OUT ; EURO BLOCK HIGH Z 50 (12,5 Ω) 70 (24,5 Ω) 100 V (50 Ω) LOW Z 8 Ω PHANTOM POWER MIC 1-2-3-4 14 V; internal jumpers PRE AMP OUT LEVEL 1 V TUNER (RCA MONO)(MOH) LEVEL 300 mV RECORD ...
-
APart MA200CDR - page 16
WWW .AP ART -AUDIO .COM AN Y S UGGESTION? They are well appreciated and eventually rewarded! Send your ideas or suggestions to suggestions@apart-audio.com MA200CDR is developed by Audioprof nv Lanteernhofstraat 90 BE-2100 Deurne BELGIUM ...
Hai una domanda su APart MA200CDR?
Utilizza il modulo sottostante
Se non hai risolto il problema con APart MA200CDR con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con APart MA200CDR è probabile che voglia condividere il modo di risolverlo.