-
Wagner SprayTech 9140S - page 1
English Printed in the U. S. A. M ODELS 9140, 9140S, 9150, 9170, 9190 AND 9210 H IGH P ERFORMANCE A IRLESS S PRA YER T ABLE OF C ONTENTS : SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 COMPONENTS AND DESCRIPTION . . . . . . . . . . . . . . . . . . 4 SETUP . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
-
Wagner SprayTech 9140S - page 2
HAZARD: INJECTION INJUR Y A high pressure paint stream produced by this equipment can pierce the skin and underlying tissues, leading to serious injury and possible amputation. SEE A PHYSICIAN IMMEDIA TEL Y . DO NOT TREA T AN INJECTION INJUR Y AS A SIMPLE CUT! Injection can lead to amputation. See a physician immediately . The maximum operating ran ...
-
Wagner SprayTech 9140S - page 3
HAZARD: GENERAL Can cause severe injury or property damage. PREVENTION: • Read all instructions and safety precautions before operating equipment. • Follow all appropriate local, state, and national codes governing ventilation, fire prevention, and operation. • The United States Government Safety Standards have been adopted under the Occupati ...
-
Wagner SprayTech 9140S - page 4
Spray gun Spray tip Spray hose Pail bracket Lubricating area (on front face plate) Hose bracket Handle Motor housing Return tube Suction tube Suction set screen ON/OFF switch O = OFF l = ON PRIME/ SPRA Y knob Fluid section O l SPRA Y PRIME SPRA Y PRIME PRIME/SPRA Y knob PRIME position SPRA Y position Customer Service: 800-880-0993 4 © 2003 W agner ...
-
Wagner SprayTech 9140S - page 5
© 2003 W agner Spray T ech - All rights reserved. 5 Customer Service: 800-880-0993 English T OOLS N EEDED F OR S ETUP • T wo adjustable wrenches • 3/16” allen wrench • Extension cord (refer to Important Electrical Information (page 3) . Do not plug in the unit until setup is complete. A TT ACHING THE H ANDLE ( CART MODELS ) 1. Position the ...
-
Wagner SprayTech 9140S - page 6
P LUGGING I N THE S PRA YER 1. Check that the ON/OFF switch is in the OFF position. 2. Plug the sprayer into a heavy duty grounded extension cord. Refer to Important Electrical Information, page 3). P RESSURE R ELIEF P ROCEDURE Be sure to follow the pressure relief procedure (page 6) when shutting the unit off FOR ANY PURPOSE. This procedure is use ...
-
Wagner SprayTech 9140S - page 7
© 2003 W agner Spray T ech - All rights reserved. 7 Customer Service: 800-880-0993 English P URGING & P RIMING P URGING AND P RIMING THE P UMP 1. Place a full container of paint underneath the suction tube. 2. Secure the return tube into a waste container . 3. T urn the pressure control dial to maximum pressure (+). 4. T urn the PRIME/SPRA Y k ...
-
Wagner SprayTech 9140S - page 8
P RACTICE Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges. 1. Switch the pump ON (l) and turn the PRIME/SPRA Y knob to SPRA Y . 2. T urn the pressure contol dial to its highest setting (+). The spray hose should stiffen as paint begins to flow through it. 3. When the motor shuts off, unlock the spray gun a ...
-
Wagner SprayTech 9140S - page 9
© 2003 W agner Spray T ech - All rights reserved. 9 Customer Service: 800-880-0993 English U NCLOGGING THE S PRA Y T IP Do not attempt to unclog or clean the tip with your finger . Do not use a needle or other sharp pointed instrument to clean the tip. The hard tungsten carbide can chip. If the spray pattern becomes distorted or stops completely w ...
-
Wagner SprayTech 9140S - page 10
I MPORT ANT C LEANING N OTES ! R EAD T HESE N OTES AND W ARNINGS B EFORE Y OU S T ART T O C LEAN Y OUR S PRA YER ! • When using latex paints, clean your sprayer and components using warm, soapy water . When using oil-based paints, use mineral spirits. • Do not use mineral spirits on latex paint, or the mixture will turn into a jelly-like substa ...
-
Wagner SprayTech 9140S - page 11
© 2003 W agner Spray T ech - All rights reserved. 11 Customer Service: 800-880-0993 English C LEANUP ( CONTINUED ) 1. Make sure the pump is switched OFF (O), the PRIME/SPRA Y knob is turned to PRIME, and unplug the sprayer . 2. Remove spray gun from the paint hose using adjustable wrenches. 3. Remove filter from spray gun (refer to Cleaning the Sp ...
-
Wagner SprayTech 9140S - page 12
S HORT -T ERM S T ORAGE ( UP T O 16 HOURS ) S HUTDOWN 1. Lock the spray gun off. 2. T urn the PRIME/SPRA Y knob to PRIME. 3. Switch the pump OFF , and unplug the sprayer . 4. Pour 1/2 cup water slowly on the top of the paint to prevent the paint from drying. 5. Wrap the spray gun assembly in a damp cloth and place it in a plastic bag. Seal the bag ...
-
Wagner SprayTech 9140S - page 13
© 2003 W agner Spray T ech - All rights reserved. 13 Customer Service: 800-880-0993 English D AIL Y M AINTENANCE The only daily maintenance necessary is thorough cleaning. Follow the cleaning procedures in this manual. E XTENDED M AINTENANCE Some pump parts eventually wear out from use and must be replaced. The following list indicates the availab ...
-
Wagner SprayTech 9140S - page 14
Customer Service: 800-880-0993 14 © 2003 W agner Spray T ech - All rights reserved. English D ISASSEMBL Y OF THE F LUID S ECTION 1. Remove the suction set. 2. Remove the front cover and the four screws that secure it using a T20 T orx head driver . 3. Remove the yoke screw and washer that secures the dowel pin. The dowel pin connects the yoke to t ...
-
Wagner SprayTech 9140S - page 15
© 2003 W agner Spray T ech - All rights reserved. 15 Customer Service: 800-880-0993 English T ROUBLESHOOTING P ROBLEM A. The sprayer does not start. B. The sprayer starts but does not draw in paint when the PRIME/SPRA Y knob is set to PRIME. C. The sprayer draws up paint but the pressure drops when the gun is triggered. D. The PRIME/SPRA Y valve i ...
-
Wagner SprayTech 9140S - page 16
English 48 800-880-0993 © 2003 W agner Spray T ech - All rights reserved. Fran ç ais Espa ñ ol GX-06/07 (9140, 9140S, 9150, 9170) Item Part # Description Quantity 1 0512120 Plastic gun assembly ............................1 0512121 Metal gun assembly ..............................1 2 050101 1 Guard Assembly ...................................1 3 ...
-
Wagner SprayTech 9140S - page 17
English Fran ç ais © 2003 W agner Spray T ech - All rights reserved. 800-880-0993 49 Espa ñ ol Article N ° de pi è ce Description Quantity 1 Se reporter à la liste d ’ ACCESSOIRES 2 050101 1 Prot è ge-embout ....................................1 3 0296261 Diffuseur , 2,2 cm ...................................1 4 0296270 Ressort de soupape ...
-
Wagner SprayTech 9140S - page 18
English 50 800-880-0993 © 2003 W agner Spray T ech - All rights reserved. Fran ç ais Espa ñ ol P ARTS LIST • L ISTE DE PI È CES • L IST A DE PIEZAS GX-10 (9210) Item Part # Description Quantity 1 Refer to Accessories, page 13 2 050101 1 Holder assembly ...................................1 3 0296261 Diffuser , 7/8" ..................... ...
-
Wagner SprayTech 9140S - page 19
English Fran ç ais © 2003 W agner Spray T ech - All rights reserved. 800-880-0993 51 Espa ñ ol 8 0512396 Roue (9140, 9150) . . . . . . . . . . . . . .2 0512397 Roue (9170) . . . . . . . . . . . . . . . . . . .2 0278373 Roue (9190, 9210) . . . . . . . . . . . . . .2 9 0275728 Capuchon (9140, 9150, 9170) . . . . . .2 9890104 Capuchon (9190, 9210) ...
-
Wagner SprayTech 9140S - page 20
English 52 800-880-0993 © 2003 W agner Spray T ech - All rights reserved. Fran ç ais Espa ñ ol GARANTIE LIMIT É E MA T É RIEL DE PUL V É RISA TION DE PEINTURE SANS AIR Ce produit, fabriqu é par W agner Spray T ech Corporation (Wagner), est garanti, au b é n é fice de l ’ acheteur au d é tail d ’ origine, contre tout vice de mati è re ...
Hai una domanda su Wagner SprayTech 9140S?
Utilizza il modulo sottostante
Se non hai risolto il problema con Wagner SprayTech 9140S con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Wagner SprayTech 9140S è probabile che voglia condividere il modo di risolverlo.