-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 1
PROFESSIONAL INSTALL ATION IS HIGHLY RECO MMENDED Manufactured by Breckwell Hearth Products Eugene, Oregon Grand Prairie, Texas www.breckwell.com OWNER’S M ANUAL LUXURY SERIES P2700 BRECKWELL HEARTH PRODUCTS C - L - 1001 1 /05 • W ARNING : If your appliance is not properly installed a house fire may result. For your safety, follow the insta ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 2
Thank you for purchasing the Breckwell Pellet Burning Stove. You are now prepared to burn wood in the most efficient, convenient way possible. To achieve the safest, most efficient and most enjoyable performance from your stove, you must do three things: 1) Install it properly; 2) Operate it correctly; and 3) Maintain it regularly. The purpose of t ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 3
Do not operate your stove if you smell smoke coming from it. Turn it off, monitor it, and call your dealer. Never try to repair or replace any part of the stove unless instructions are given in this manual. All othe r work should be done by a trained technician. Never use gasoline, gasoline - type lantern fuel, kerosene, charcoal lighter fluid, or ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 4
INTRODUCTION ----------------------------------------------------------------------------------- --- ------- 2 SAFETY PRECAUTIONS ------------------------------------------------------------------------ ---------- 3 SPECIFICATIONS --------------------------------------------------------------------------------- ---------- 5 INSTALLATION ----------- ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 5
SPECIFICATIONS Width: 23 1/8” Height: 30 ½” Depth: 22 ¼” W eight: 233 lbs. Flue size: 3” or 4” Hopper Capacit y: Up to 50 lbs. (This can vary widely depending on pellet size, length, and diameter) EPA status: exempt Burn time: 1 lb. to 5 .5 lbs. per hour BTU range: 8,200 to 50 ,000 Approved installations: mobile home, alcove, convention ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 6
COMBUSTION AIR SUPPLY For a mobile home installation the stov e must be connected to an outside source of combustion air. A 2” inside diameter metallic pipe, either flexible or rigid, may be attached to the inlet at the stove’s rear (refer to figure 4). A rodent guard (minimum ¼” wire mesh)/wind hood must be used at the terminus (refer to fi ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 7
Equivalent Vent Length (EVL) The longer the run of pipe in your installation, the more restriction there is in the system. Therefore, larger diameter pipe should be used. • Use 4” pipe if you have more than 15 feet of equivalent vent length. • Horizontal runs shall not exceed 10’ of EVL. • Recommended vertical runs to be a minimum of 8’ ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 8
B. VERTICALLY WITH NEW CHIMNEY SYSTEM (Refer to Figure 7) NOTE: Follow L - Vent chimney manufacturer’s instructions. OPTION: To achieve a center vertical installation a 45º elbow and a clean - out tee can be used to offset the pipe from the exhaust outlet to the rear center of the stove. OPTION: Install L - Vent elbow in place of clean - out tee ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 9
E. INSTALLATION THROUGH SIDE OF MASONRY CHIMNEY NOTE: Follow L - Vent chimney manufacturer’s instructions. 1. Position the stove, adhering to the clearances in Figures 1 & 2. Mark the center of t he hole where the pipe is to pierce the masonry chimney. 2. It will be necessary to break out the masonry around the location of the pipe center mar ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 10
PANEL CONTROLS (See Figure 11) The blowers and automatic fuel supply are controlled from a panel on the left - hand side of the P2700. The control panel functions are as follows. a. ON/ OFF SWITCH • When pushed the stove will automatically ignite. No other firestarter is necessary. The igniter will stay on for at least 10 and up to 15 minutes, de ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 11
PROPER FUEL THIS STOVE IS APPROVED FOR BURNING PELLETIZED WOOD FUEL ONLY! Factory - approved pellets are those ¼” or 5/16” in diameter and not over 1” long. Longer or thicker pellets sometimes bridge the auger flights, which prevents proper pellet feed. Burning wood in forms othe r than pellets is not permitted. It will violate the building ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 12
RE - STARTING A WARM STOVE If the stove has been shut off, and you want to re - star t it while it is still warm, the “on/off” button must be held down for 2 seconds. IF STOVE RUNS OUT OF PELLETS The fire goes out and the auger motor and blowers will run until the stove cools. This will take 30 to 45 minutes. After the stove components s top ru ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 13
OPTIONAL THERMOSTAT A thermostat may help you maintain a constant house temperature automatically. A millivolt thermostat is required. A fixed wall mount or Breckwell’s hand held model can be used. The control panel can be set up two ways to operate your stove in thermostat mode. THERMOSTAT INSTALLATION • A MI LLIVOLT THERMOSTAT IS REQUIRED. ? ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 14
OPERATING SAFETY PRECAUTIONS PLEASE READ THI S! a. Hot while in operation. Keep children, clothing, and furniture away. Contact may cause skin burns. b. If you notice a smoldering fire (burnpot full but no visible flame) AND a heavy smoke buildup in firebox, immediately TURN OFF the stove, but DO NOT unp lug it. Do not open the door, change the dam ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 15
FAILURE TO CLEAN AND MAINTAIN THIS UNIT AS INDICATED CAN RESULT IN POOR PERFORMANCE AND SAFETY HA ZARDS. NEVER CLEAN WHEN HOT. NOTE: Inspect burn pot periodically to see that holes have not become plugged, if so, clean thoroughly. ASH REMOVAL Ashes should be placed in a metal container with a tight - fitting lid. The closed container or ashes shoul ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 16
CLEANING a. Heat Exchange Tubes – Your Breckwell stove is designed wi th a built - in heat exchange tube cleaner. This should be used every two or three days to remove accumulated ash on the tubes, which reduces the efficiency of your unit . Insert the handle end (with hole) of the cleaning tool onto the cleaning rod (refer to figure 14 ). The cl ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 17
CHIMNEY CLEANING a. Creosote Formation – When any wood is burned slowly, it produces tar and other organic vapors, which combine with expelled moisture to form creosote. The creosote vapors condense in the relativel y cool chimney flue or a newly started fire or from a slow - burning fire. As a result, creosote residue accumulates on the flue lin ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 18
When your stove acts out of the ordinary, the first reaction is to call for hel p. This guide may save time and money by enabling you to solve simple problems yourself. Problems can be caused by to only five factors: 1) poor fuel; 2) poor operation or maintenance; 3) poor installation; 4) component failure; 5) factory defect. You can usually solve ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 19
STOVE SHUTS OFF AND THE # 3 LIGHT FLASHES Possible Causes: Possible Remedies: (Unplug stove first when possible) 1. The hopper is out of pellets. Refill the hopper. 2. The air damper is too far open for a low feed setting. If burning on the low setting, you may need to close the damper all the way (push the knob in so it touches the side of the sto ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 20
STOVE FEEDS PELLETS, BUT WILL NOT IGNITE Possible Causes: Possible Remedies: 1. Air damper open too far for ignition. Push the air damper in closer to the side of the stove for startup. In some situations it may be necessary to have the damper comple tely closed for ignition to take place. After there is a flame, the damper can then be adjusted for ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 21
STOVE WILL NOT FEED PELLETS, BUT FUEL FEED LIGHT COMES ON AS DESIGNED Possible Causes : Possible Remedies: 1. F use on control board blew Remove the control board. If the fuse appears to be bad, replace it with a 5 Amp 250 Volt fuse. Plug the stove back in and try to run the unit. 2. High limit s witch has tripped or is defective W ait for the stov ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 22
• GLASS “SOOT’S” UP AT A VERY FAST RATE • FLAME IS LAZY, DARK, AND HAS BLACK TIPS • AFTER STOVE HAS BEEN ON F OR A WHILE, THE BURNPOT OVERFILLS Possible Causes: Possible Remedies: 1. Stove or vent pipe is dirty, which restricts airflow through the burnpot. Follow all cleaning procedure in the maintenance section of the owner’s manual. ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 23
HIGH LIMIT SWITCH KEEPS TRIPPING Possible Causes: Possible Remedies: 1. The convection blower is overheating and tripping the internal temperature shutoff. C lean any dust off of the windings and fan blades. If cleaning the blower does not help, the blower may be bad. 2. The stove is being left on the highest setting for exte nded periods of time. ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 24
FIGURE 20 ELECTRICAL DIAGRAM 24 ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 25
Contact an Authorized Breckwell Pellet Stove Dealer to obtain any of these parts. Never use substitute materials. Use of non - approved parts can result in poor performance and safety hazards. ITEM PART # Air Switch C - E - 201 Air S witch Hose C -M- 340 - T Auger Motor C - E - 017 Breckwell Maintenance Tool A - TOOL - 96 Brick Panel Set, Ceramic ? ...
-
Breckwell Breckwell Hearth Products LUXURY SERIES - page 26
LIFETIME LIMITED WARRANTY Breckwell Hearth Products warrants to the original consumer purchaser that the Breckwell stove in its original installation is free from defects in material and workmanship from the original date of purchase as follows: Steel fabricated components, excluding burnpot inserts, are covered for five years. Glass and burnpot in ...
Hai una domanda su Breckwell Breckwell Hearth Products LUXURY SERIES?
Utilizza il modulo sottostante
Se non hai risolto il problema con Breckwell Breckwell Hearth Products LUXURY SERIES con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Breckwell Breckwell Hearth Products LUXURY SERIES è probabile che voglia condividere il modo di risolverlo.