-
Black Box 39005 - page 1
CUSTOMER SUPPORT INFORMATION Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mail order: Black Box Corporation , 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com MARCH 200 ...
-
Black Box 39005 - page 2
1 FCC INFORMATION FEDERAL COMMUNICA TIONS COMMISSION AND INDUSTR Y CANADA RADIO FREQUENCY INTERFERENCE ST A TEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has ...
-
Black Box 39005 - page 3
2 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR NORMAS OFICIALES MEXICANAS (NOM) ELECTRICAL SAFETY ST A TEMENT INSTRUCCIONES DE SEGURIDAD 1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado. 2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura. 3. ...
-
Black Box 39005 - page 4
3 NOM STATEMENT 12. Precaución debe ser tomada de tal manera que la tierra fisica y la polarización del equipo no sea eliminada. 13. Los cables de la fuente de poder deben ser guiados de tal manera que no sean pisados ni pellizcados por objetos colocados sobre o contra ellos, poniendo particular atención a los contactos y receptáculos donde sal ...
-
Black Box 39005 - page 5
4 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR General Safety Precautions T ransport, Installation, and Operation • Avoid excessive vibration and shocks. • Avoid contact with water and dust. • Avoid excessive direct sunlight. • Ensure sufficient cooling. • Prevent loose items from falling into the device. Fiber Optics • Looking into the fiber ...
-
Black Box 39005 - page 6
5 TRADEMARKS TRADEMARKS USED IN THIS MANUAL ST ® is a registered trademark of American Telephone and Telegraph Company. Any trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. ...
-
Black Box 39005 - page 7
6 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR Contents 1. Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 2. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 2.1 Description . . . . . . . . . . . . . . . . . . . . . . . . . . ...
-
Black Box 39005 - page 8
7 CHAPTER 1: Specifications 1. Specifications Maximum Distance— 39004: 3 mi. (4.8 km) @ 16 dB; 39005: 24 mi. (38.6 km) @ 16 dB Speed —1.544 Mbps Interface —DTE: T1, G.703/DS1; Fiber: Dual ST ® multimode or single-mode Connectors —DB15 for DTE, dual ST for fiber Indicators and Buttons —(6) LEDs: TX, RX, FO/S, C, LL, DL; (1) Loop mode butt ...
-
Black Box 39005 - page 9
8 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR 2. Introduction 2.1 Description The T1 Fiber Optic Line Extender/Simulator lets you combine fiber optic technology with standard interfaces at 1.544 Mbps. The advantages are increased transmission distances and immunity to electrical interference. Connections between buildings become possible since no lightn ...
-
Black Box 39005 - page 10
9 CHAPTER 3: Connectors, Indicators, and Controls 3. Connectors, Indicators, and Controls Figure 3-1. Front and Rear Panels. T able 3-1. Connectors, Indicators, and Controls No. Connector , Indicator , or Control 1 TX LED: Transmitting binary 0 via fiber optic 2 G.703 connector 3 FO/S LED: Power/FO Link/sync 4 LL LED: Unit in line loop mode* 5 DL L ...
-
Black Box 39005 - page 11
10 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR 4. Setup Figure 4-1. Location of Jumpers on the Printed Circuit Boar d. Main board Front panel Back panel ...
-
Black Box 39005 - page 12
11 CHAPTER 4: Setup T able 4-1. Key , Jumper , and Switch Settings Number Setting Description 1 Loop Mode Key: Press the key switches through the following operating modes: Normal operation, Digital loop, Remote loop. The unit enters loop mode when the distant modem gets switched to remote loop. 2 Clock Source Internal Remote External 3 Interface S ...
-
Black Box 39005 - page 13
12 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR T able 4-1 (continued). Key , Jumper , and Switch Settings Number Setting Description 8 Sample mode for incoming intermediate frequency (I/F) data Data sampled on positive clock edge (std.) Data sampled on negative clock edge 9 Interface Mode NT (Network Termination) TE (Terminal Equipment) 10 Interface Pin ...
-
Black Box 39005 - page 14
13 CHAPTER 4: Setup Clock Mode Comments: • Internal: The clock is generated by the internal clock generator. • External: The clock is provided by the local equipment. • Remote: The local modem receives the clock via the link from the distant modem. The distant modem must be set to Internal or External. Figure 4-2. Possible Synchronous Clock C ...
-
Black Box 39005 - page 15
14 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR 5. Data Signals Figure 5-1. Data Signals at Nor mal Mode. Figure 5-2. Data Signals at Digital Loop Mode. Distant fiber optic modem Local fiber optic modem in normal mode Local fiber optic modem in digital loop mode Distant fiber optic modem ...
-
Black Box 39005 - page 16
15 CHAPTER 5: Data Signals Figure 5-3. Data Signals at Remote Loop/Line Loop Mode. T able 5-1. G.703 Pinout (Female) Pin Signal T erminal End Network T ermination 2 R A Input Output 4 T A Output Input 9 R B Input Output 11 T B Output Input Figure 5-4. G.703 Connector . Local fiber optic modem switched to remote loop mode Fiber optic modem forced to ...
-
Black Box 39005 - page 17
16 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR Appendix: Fiber Optic Planning Guidelines A.1 Introduction Designing a fiber optic link means considering two main physical limitations: System attenuation and fiber optic dispersion. Attenuation results when properties of the fiber optic link reduce the intensity of the fiber optic signals. Dispersion occu ...
-
Black Box 39005 - page 18
17 A.2 Fiber Optic Calculation S TEP 1: A TTENUATION C ONSIDERATIONS Figure A-1 shows the various elements of the fiber optic link that decrease light intensity. Depending on the real installation, you must subtract a series of attenuation (att.) values from the raw optic output level of the fiber optic transmitter. The remainder of the originally ...
-
Black Box 39005 - page 19
18 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR (max, cable [2] att.)=(fiber optic power budge) - (right part att.) = 17 dB - 12 dB = 5 dB. (max. cable [2] length) = (max.cable [2] att.)/(cable [2] att. factor) = 5 dB/3 dB/km = 5.6 km Example 2: Maximum length of cable [2] when connected directly (without splices, etc.): (max. cable [2] length) = (fiber ...
-
Black Box 39005 - page 20
19 APPENDIX: Fiber Optic Planning Guidelines S TEP 2: O VERALL O PERATION C ONSIDERATIONS The operation diagram ( Figure A-2 ) shows one example diagram and one blank diagram to be completed based on real values: 1. Draw horizontal lines at the min. and max. value of the fiber optic pulse width* of the affected units. 2. Calculate the maximum total ...
-
Black Box 39005 - page 21
20 T1 FIBER OPTIC LINE EXTENDER/SIMULATOR Figure A-2. Operation Diagram ...
-
Black Box 39005 - page 22
21 Use the example on the previous page as a reference when filling in information for your application below. Figure A-3. Y our Application. APPENDIX: Fiber Optic Planning Guidelines ...
-
Black Box 39005 - page 23
1000 Park Drive • Lawrence, PA 15055-1018 • 724-746-5500 • Fax 724-746-0746 © Copyright 2000. Black Box Corporation. All rights reserved. ...
Hai una domanda su Black Box 39005?
Utilizza il modulo sottostante
Se non hai risolto il problema con Black Box 39005 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Black Box 39005 è probabile che voglia condividere il modo di risolverlo.