-
Solid State Logic MX4 - page 1
User Guide V1.1 ...
-
Solid State Logic MX4 - page 2
T able of Contents 1. ! Introduction ............................................................................................................................................................................................. ! Page 3 ! 2. ! System Requirements ....................................................................................... ...
-
Solid State Logic MX4 - page 3
! S S L C onsole Bundle for M X4 User Guide V1.1 ! English Edition V1.1 ! Plug-Ins included: SSL Console EQ and Filters V1.5 / SSL Console Dynamics V1.01 / SSL Console Bus Compressor V1.0 Congratulations on your purchase of the SSL Console Bundle, the real SSL processing solution for your SSL Mixer V6 or SSL Soundscape V6 Software. As you ʼ re sat ...
-
Solid State Logic MX4 - page 4
T o run the SSL Console Bundle Plug-Ins you need a host PC equipped with an SSL MX4 PCIe Card o r SSL Mixpander/5 (or Soundscape Mixpander/9) and the latest V ersion of the SSL Mixer V6.x or SSL Soundscape V6.x Software. In order to get the most out of the SSL Console Bundle plug-ins, your system needs the following minimum specification: • Work ...
-
Solid State Logic MX4 - page 5
NOTE: The SSL Console Bundle Plug-ins are automatically installed with the SSL Mixer & Soundscape V6 (or later) software. The installation procedure below is only required for previous Software V ersions. Installation Procedure: • Please close all SSL Mixer or SSL Soundscape V6 software • Double-click on the SetupSSLbundleV1.0.exe • Pleas ...
-
Solid State Logic MX4 - page 6
Included Plug-ins: SSL Console EQ and Filters V1.5 T wo different Plug-In versions are included; mono to mono and stereo to stereo. Once inserted into the Mixer Software, the SSL Console EQ and Filters plug-in will appear as a small graph preview window inside the mixer column. Each different EQ plug-in on the SSL Mixer will exhibit a different col ...
-
Solid State Logic MX4 - page 7
SSL Console Bus Compressor V1.0 T wo different Plug-In V ersions are included: Stereo to Stereo and Stereo to Stereo with Sidechain (SC). The SSL Bus Compressor is always Stereo. In the SC V ersion Input 3+4 are used to derive the SC Key signal from. TIP: In order to use a SC V ersion, you need a 4CH to Stereo Column to insert the Plug-In. Once ins ...
-
Solid State Logic MX4 - page 8
Peak Meters The peak meters in the input and output sections contain a clip indication light. This can be reset using CTRL+double click anywhere on the peak meter area (this does not have to be exactly over the LEDs). This will also reset the clip indication in the small plug-in window in the mixer once the EQ curve or LED Background of the Dynamic ...
-
Solid State Logic MX4 - page 9
Current Preset Name Displays the name of the currently loaded Preset, or (Untitled), if the Setting hasn ʻ t been stored yet. NOTE: The def.SEF , def.SCD and def.SBC presets restore the factory defaults, so we advise you to not overwrite them. TIP: In order to copy the EQ settings from one channel to another , we recommen d creating a new folder f ...
-
Solid State Logic MX4 - page 10
SSL Console EQ and Filters EQ-Section Based on the EQ algorithm of the SSL C200 Console family , the equaliser is a four band parametric EQ. The distinctive Sound that was truthfull y modelled on XL 9000K EQ circuit and includes two distinct EQ curves, one based on the SSL G series EQ and another based on the latest version of SSL ʼ s classic E se ...
-
Solid State Logic MX4 - page 11
The High Mid Frequency section o perates over a frequency range of 600Hz - 7 kHz and is capable of ±20dB of gain with a continuously variable Q from 0.5 to 2.5. Normally , at any Q setting, the bandwidth of the HMF and LMF sections varies with gain, whereby an increase in boost or cut increases the selectivity of the EQ. This type of EQ can sound ...
-
Solid State Logic MX4 - page 12
Special EQ Controls Filter Knobs The filter pots have an OUT position, which removes the filters independently from the signal chain. T h e L P fi l t e r p o t e n t i a l l y h a s a m a x i m u m frequency of 35kHz. According to the Nyquist theorem, the possible bandwidth of a digital system is 0.5 x sample rate. This means that with sample r ...
-
Solid State Logic MX4 - page 13
SSL Console Channel Dynamics The SSL Ch annel Dyna mics Plug-In co mpris es s eparat e secti ons for compressor/limiter and an expander/gate. Both sections work independently , but can be operational at the same time, providing sophisticated control of signal levels. The Mono and Stereo V ersion are both also available as a V ersion with side chain ...
-
Solid State Logic MX4 - page 14
THRESHOLD Whenever a signal exceeds the level set by this control, the compressor will start to act at the ratio set by the RA TIO control. This control also provides automatic make-up gain, so as you lower the threshol d and introduce more compression, the output level is increased, maintaining a steady output level regardless of the amount of com ...
-
Solid State Logic MX4 - page 15
F AST A TT Provides a fast attack time (100 μ s per 40db). When off, a controlled linear attack time of 1.5ms per 40dB is selected. The attack time is the time taken for the Expander/Gate to ʻ recover ʼ once the signal level is above the threshold. When gating signals with a steep rising edge, such as drums, a slow attack may ef fectively mask t ...
-
Solid State Logic MX4 - page 16
SSL Console Bus Compressor The SSL Console Bus Compressor plug-in is a stereo version of the legendary centre section bus compressor found on the XL 9000K Series console. It provides high quality stereo compression, giving you critical control over the dynamic range of audio signals. Used on a stereo mix or instrument group has the effect of ' ...
-
Solid State Logic MX4 - page 17
RELEASE Five switchable ranges 0.1, 0.3, 0.6, 1.2 seconds and ʻ Auto ʼ . (With Auto selected, the release time is dependant upon the duration of signal peaks). Determines the time it takes for the compressor module to ʻ recover ʼ , once the incoming signal level is becoming lower . MAKE-UP Level compensation to compensate for compressor action, ...
-
Solid State Logic MX4 - page 18
Support, F AQs and Online Help Center T o access the latest support infor mation on MX4 or the SSL Console Bundle, please visit our online support site. The information there is kept up to date by our support staff to make sure all information is accurate. All information is available to you 24/7/365. If you can ʼ t find your answer or a solution ...
-
Solid State Logic MX4 - page 19
Solid St ate L ogic SOUND || VISION Visit SSL at: www .solid-state-logic.com © 2009-2010 Solid State Logic All Rights reserved under International and Pan-American Copyright Conventions. No part of this publication may be reproduced in any form or by any means, whether mechanical or electronic, without the written permission of Solid State Logic, ...
Hai una domanda su Solid State Logic MX4?
Utilizza il modulo sottostante
Se non hai risolto il problema con Solid State Logic MX4 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Solid State Logic MX4 è probabile che voglia condividere il modo di risolverlo.