-
Hawking Technology H-DS20L - page 1
H-DS20L USB 2.0 Docking Station ...
-
Hawking Technology H-DS20L - page 2
FCC W arning This equipment has been tested and found to com ply with the regulati ons for a Class B digita l device, pursuant to Part 15 of the FCC Rul es. These li mits are desi gned to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can rad ...
-
Hawking Technology H-DS20L - page 3
Basic Overview……………………………………………………………………...…….4 Safety Instructions………………………………………………………………...4 Introduction……………………………………………………………………….4 Features………………………………………? ...
-
Hawking Technology H-DS20L - page 4
SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. Always read the safety instructions carefully . Keep this User ’ s Manual for future reference. Keep this equipment away from hum id environments. Lay this equipment on a reliable, flat surface before setting it up. If any of the following situations arise, have the equipment checked by a service personnel: ...
-
Hawking Technology H-DS20L - page 5
SYSTEM REQUIREMENTS PC or Mac MS W i ndows 98SE, ME, 2000, XP & Mac OS9.x & 10.1 A vailable USB Port 64 MB RAM or above Pentium 233 MHz or higher P ACKAGE CONTENTS Docking Station – 1pc DC5V Power supply - 1pc User ’ s Manual - 1pc Software driver CD-ROM - 1pc T ype-A to T ype-B USB Cable - 1pc SU ...
-
Hawking Technology H-DS20L - page 6
Type Docking Station With LAN Computer Port 1 upstream port Type B receptacle 2 USB 2.0 downstream ports, Type A receptacle 1 PS/2 Keyboard port Mini Din 6-pin 1 PS/2 Mouse port Mini Din 6-pin 1 File Transfer port Type B receptacle 1 serial port DB 9-pin male 1 parallel port DB 25-pin female I/O Ports 1 10/100M LAN port 8P8C RJ-45 shielding Emissio ...
-
Hawking Technology H-DS20L - page 7
LED S tatus Indicators Once the USB Port Replicator is connected, the Hub Link LED is lit green and the LAN LED is lit after the Ethernet cable is connected. Ty p e # of LEDs Color Descriptions 1 Red The AC to DC power adapter is plugged into the power port 2 Green When any of the hub ports, which are connected to USB devices, are activated. Dockin ...
-
Hawking Technology H-DS20L - page 8
Figure 2. Upstream Port and Power Connector Connect to power adaptor Connect to PC ( I ) Connect the power adapter and plug it into the back of the docking station. Find an unused electrical outlet and plug it in the power adapter. Plug the flat end (A plug) of the USB cable into a free USB port on your PC. Plug the square end (B pl ...
-
Hawking Technology H-DS20L - page 9
1. Two-Port Hub Before you connect a USB device to one of the Hub ports, please follow the software installation instructions provided in the subsequent pages of this User ’ s Manual. 2. PS/2 ports (Keyboard and Mouse port) If you connect a PS/2 keyboard or mouse to the docking station and you are using a PC, you will not need the software driver ...
-
Hawking Technology H-DS20L - page 10
Installation for Windows 98SE & ME 1. The H-DS20L Install wizard searches for new drivers. Click Next to continue. 2. Select "Search for the best driver for your device [Recommended]," and click Next to continue. 10 ...
-
Hawking Technology H-DS20L - page 11
3. Select "CD-ROM drive", and click Next to continue. 4. W indows will now search for the driver file for the device. Click Next to continue. 11 ...
-
Hawking Technology H-DS20L - page 12
5. W indows has finished installing the software. Click Finish to end the W izard. * NOTE: Repeat the previous steps as needed. 6. If your operating system is Windows ME, click No to continue. Otherwise, click Yes to reboot your computer. 12 ...
-
Hawking Technology H-DS20L - page 13
7. The "W elcome to the Install Shield W izard for PC-Linq" dialog window appears. Click Next to continue. 8. 9. Setup will add the program icon to the Program Folder listed below. Click Next to continue. Windows has finished installing the software. Click Finish to end the W izard. 13 ...
-
Hawking Technology H-DS20L - page 14
10. The PC-Linq icon will appear on the desktop. Installation verification Because the docking station is USB 2.0, the hub driver is based on the host device. The device name may vary on your host device driver . W i ndows 98SE 14 ...
-
Hawking Technology H-DS20L - page 15
15 ...
-
Hawking Technology H-DS20L - page 16
W i ndows ME 16 ...
-
Hawking Technology H-DS20L - page 17
17 ...
-
Hawking Technology H-DS20L - page 18
Installation for Windows 2000 1. The H-DS20L Install wizard helps you install a device driver. Click Next to continue. 2. Select "Search for a suitable driver for my device [recommended]." Click Next to continue. 18 ...
-
Hawking Technology H-DS20L - page 19
3. Select "Floppy disk drives" and click Next to continue. The wizard found a driver. Click Next to continue. 4. 19 ...
-
Hawking Technology H-DS20L - page 20
5. Select "C:WINNTsystem32drivers" for built-in hub driver (usbhub20.sys). Click Open to continue. 6. Click OK to continue. 20 ...
-
Hawking Technology H-DS20L - page 21
7. W indows has finished installing the software. Click Finish to continue. 8. This wizard helps you install a device driver . Click Next to continue. 21 ...
-
Hawking Technology H-DS20L - page 22
9. Select "Search for a suitable driver for my device [recommended]." Click Next to continue. 10. Select CD-ROM drives and click Next to continue. 22 ...
-
Hawking Technology H-DS20L - page 23
11. The wizard found a driver . Click Next to continue. 12. W indows has finished installing the software. Click Finish to continue. * NOTE: Repeat the previous steps as needed. 23 ...
-
Hawking Technology H-DS20L - page 24
13. The "Welcome to the Install Shield W izard for PC-linq" dialog window appears. Click Next to continue. 14. name, or se Setup will add the program icon to the Program Folder. You m ay type a new folder lect the default folder name. Click Next to continue. The PC-Linq icon will appear on the desktop. Note: If you connect the docking sta ...
-
Hawking Technology H-DS20L - page 25
Installation verification Because our docking station is USB 2.0, the hub driver is based on the host device. The device name may vary on your host device driver . W i ndows 2000 25 ...
-
Hawking Technology H-DS20L - page 26
1. Installation for Windows XP The H-DS20L Install wizard helps you install a device driver. Select "Install the software automatically [Recomm ended]." Click Next to continue. 2. Click Continue Anyway . 26 ...
-
Hawking Technology H-DS20L - page 27
3. The wizard has finished installing the software. Click Finish to continue. * NOTE: Repeat the previous steps as needed. 4. The "Welcome to the Install Shield Wizard for PC-linq" dialog window appears. Click Next to continue. 27 ...
-
Hawking Technology H-DS20L - page 28
5. Setup will add the program icon to the Program Folder. You may type a new folder name, or select the default folder name. Click Next to continue. The PC-Linq icon will appear on the desktop. Note: If you connect the docking station to a PC via a USB 2.0 port, PCI card, or hub, it will ask for the operating system for the USB 2.0 driver. 28 ...
-
Hawking Technology H-DS20L - page 29
Installation verification Because the docking station is USB 2.0, the hub driver is based on the host device. The device name may vary on your host device driver . W i ndows XP 29 ...
-
Hawking Technology H-DS20L - page 30
30 ...
Hai una domanda su Hawking Technology H-DS20L?
Utilizza il modulo sottostante
Se non hai risolto il problema con Hawking Technology H-DS20L con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Hawking Technology H-DS20L è probabile che voglia condividere il modo di risolverlo.