-
Omega Vehicle Security 850i - page 1
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the "Company"), are warranted to be free from defects in materials and workmanship under normal use. If a product sold by the Company proves to be defective, the Company will repair or replace it free of charge within the first year and thereafter all parts to be re ...
-
Omega Vehicle Security 850i - page 2
INSIDE FRONT COVER PRINTER’S NOTE: blank page. INSIDE BACK COVER PRINTER’S NOTE: blank page. ...
-
Omega Vehicle Security 850i - page 3
Page 48 Page 1 TABLE OF CONTENTS About Your New Crime Guard System .................................. 3-5 Status Light, Valet Switch, Transmitter & Transceiver Using Your Crime Guard System ........................................... 6 Remote Arming By Transmitter or Transceiver ..................... 6-7 Arming Bypass Last Door Arming By Exitin ...
-
Omega Vehicle Security 850i - page 4
Page 2 # FEATURE DEFAULT #1 SecureCode Programming 1 Press (n/a) #2 30 / 60 Second Activated Alarm Cycle 30 Seconds (U) #3 3 / 45 Second Arming Delay 3 Seconds (L) #4 Last Door Arming OFF (U) #5 Automatic Rearming OFF (U) #6 Auxiliary Channel #2 Also Disarms System ON (L) #7 Parking Light Illumination Upon Disarm ON (L) #8 Doors Lock At Ignition ? ...
-
Omega Vehicle Security 850i - page 5
Page 46 Echo is configured for “MUTE” operation (vibrates instead chirping), then in programming it will not play the musical melodies. Instead, it vibrates when the remote starting Start Melody and Stop Melody are accessed for program- ming. Other Omega Echo Notes : • The system will only transmit a signal to the Echo transceiver if the Echo ...
-
Omega Vehicle Security 850i - page 6
Page 4 • The locked or unlocked pad- lock (windshield) reflects the true locked or unlocked status of the doors (certain pro- grammable features can auto- matically arm the system, but not lock the doors). Arming with the transmitter/trans- ceiver always locks the doors; “Disarm/Unlock” Button “Arm/Lock” Button “Auxiliary #2” Button ? ...
-
Omega Vehicle Security 850i - page 7
disarming with the transmitter/transceiver will unlock the doors unless the system is activated and sounding. • “VALET” indicates Alarm Valet Mode, replacing the “ARM” or “DISARM” icons. A musical tone occurs when placing the system into Alarm Valet Mode. • When “BAT LOW” appears the transceiver’s 1.5 volt AAA battery should b ...
-
Omega Vehicle Security 850i - page 8
Arming the Crime Guard system turns on the antitheft protection, disables the vehicle’s starter and locks the doors (provided an interface is installed). Once the system is Armed , any intrusion attempt will Activate it, sounding the siren and flashing the lights to attract attention. Disarming the system turns off the protection, allowing normal ...
-
Omega Vehicle Security 850i - page 9
Arming Bypass: When arming the system using the transmitter or transceiver, if any pro- tected zone or sensor circuit is in a violated condition, the affected zone or circuit will be automatically bypassed. This is “Arming Bypass”, which allows the system to still arm and protect the other normal, non-violated zones. In the case of a bypassed z ...
-
Omega Vehicle Security 850i - page 10
The Last Door Arming process: 1- When the vehicle’s ignition has been turned off, the system waits until a door is opened. When the door is closed, or when the last door is closed when more than one door is opened, the siren will chirp twice, the parking lights will flash twice, and the Status Light will begin flashing Red rapidly. The Last Door ...
-
Omega Vehicle Security 850i - page 11
While the system is in the Armed state: • The Status Light will be flashing slowly Red to confirm that the system is armed, and also serve as a visual deterrent. • The starter interrupt circuit is engaged. • All protected zones are being monitored for intrusion attempts. Should an Activation into the Alarm Condition occur: • The changing-to ...
-
Omega Vehicle Security 850i - page 12
Page 39 Feature #24 Door Lock/Unlock Pulse Duration (Factory Default Setting .8 Second) This feature, for the installer’s use, offers the selection of a .8 second or a 3 second pulse duration of the system’s doorlock outputs. Certain vehicles have power doorlocking systems which are vacuum operated, and thus require a longer output pulse from t ...
-
Omega Vehicle Security 850i - page 13
Page 11 Safety Disarm Feature: Pressing and releasing the “Disarm/Unlock button while the system is activated in the alarm condition will disarm the system, but the doors will re- main locked. This is the “Safety Disarm” feature, which allows the vehicle to remain secure, even though an activated system has been disarmed. Safety Dis- arm will ...
-
Omega Vehicle Security 850i - page 14
Page 12 Automatic Rearming: Automatic Rearming is a programmable feature which ensures that your system is never inadvertently disarmed. It is possible to accidentally or unknowingly operate the transmitter from a pocket or purse. You may not even be aware of an accidental disarming due to the enhanced operating distance offered by the Extended Ran ...
-
Omega Vehicle Security 850i - page 15
the Vehicle Recovery operation from the transmitter or transceiver in the event that you are forced from your car. “Remote Activated” Vehicle Recovery is one three methods of activating this feature, which is explained on page 27. Programming Transmitter Activated Anti Car-Jacking: Follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will ...
-
Omega Vehicle Security 850i - page 16
Page 35 Feature #14 Ignition Activated Vehicle Recovery (Factory Default Setting Off) The Vehicle Recovery feature activates the system into an alarm condition automatically in the event that you are forced from your car. “Ignition Activated” Vehicle Recovery is one three methods of activating this feature, which is explained on page 27. Progra ...
-
Omega Vehicle Security 850i - page 17
Page 34 Feature #12 Doors Lock With Last Door Arming (Factory Default Setting Off) This feature adds the automatic locking of the doors to feature #4, Last Door Arming. If this feature is turned on, the doors will lock when the system becomes armed 30 seconds after closing the last door. Feature #4 must be turned on for this feature to operate. Pro ...
-
Omega Vehicle Security 850i - page 18
* An optional doorlock interface must be installed. When Auxiliary #2 is operated, all of the doors will unlock, even if the vehicle is configured with Driver’s Door Priority. To Activate Auxiliary Output #2: Press & Hold for 3 Seconds the “Auxiliary #2 Output” Button ( I I ) To Activate Auxiliary Output #3: Press & Hold for 3 Seconds ...
-
Omega Vehicle Security 850i - page 19
Sensors : The Crime Guard 850i 4 e security system is equipped with a Glass Breakage and Dual-Zone Infrasonic Impact Sensor to increase the effectiveness of the system. The impact sensor is just one in a comprehensive line of available sensors. Other available options are: piezo shock sensors, and microwave/radar sensors which can detect objects in ...
-
Omega Vehicle Security 850i - page 20
Feature #4 Last Door Arming (Factory Default Setting Off) This feature configures the system to automatically Arm itself 30 seconds after the vehicle’s last door is closed. Programming Last Door Arming: Follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will be pressed and released four times. The system’s response will be four siren ch ...
-
Omega Vehicle Security 850i - page 21
Page 19 THE PARKING LIGHTS WILL ILLUMINATE* To Activate Remote Starting: THE ENGINE STARTS To remote start the vehicle: 1- Press and release together the transmitter or Echo transceiver’s “Arm/Lock” and “Disarm/Unlock” buttons. The system will respond first by rapidly flashing the Status Light Green, then by turning on the ignition and fl ...
-
Omega Vehicle Security 850i - page 22
To Change a Feature: Step 5 After accessing the desired feature, within 10 seconds Press & Re- lease either the transmitter/transceiver’s “Arm/Lock” button or the “Disarm/Unlock” button. • Pressing the “Arm/Lock” button turns the feature on; the siren will chirp once and the Status Light will turn on. • Pressing the “Disarm/ ...
-
Omega Vehicle Security 850i - page 23
Pit-Stop Feature: This feature allows you to turn off the ignition switch, remove your keys, leave the vehicle and lock your doors while leaving the en- gine running. To use this feature, have the engine running normally from the ignition switch, have the gear selector in “park”, and your foot off of the brake pedal. Press the Valet Switch twic ...
-
Omega Vehicle Security 850i - page 24
VEHICLE RECOVERY Your system is equipped with three separately programmable Vehicle Recovery protection features, which also provide Anti-Carjacking protection. The Vehicle Recovery operation may be selectively activated by the ignition, by an open door, or by the transmitter or Echo transceiver. How It Works: Once the Vehicle Recovery process has ...
-
Omega Vehicle Security 850i - page 25
and pause to indicate which protected zone was violated while the system is still armed, after it’s disarmed, and until the vehicle’s ignition is turned on. The system’s Zone Violation memory can store two consecutive zone violations. If there have been multiple violations, the Status Light will replay the two most recent violations in the or ...
-
Omega Vehicle Security 850i - page 26
Page 25 The Status Light visually confirms the status of the system and provides a high level of visual deterrence. Two colors are shown- Red for security operations, and Green for remote starting operations. Combinations of both colors are seen when the two operations are occurring together. The Status Light, which shares a housing assembly with t ...
Hai una domanda su Omega Vehicle Security 850i?
Utilizza il modulo sottostante
Se non hai risolto il problema con Omega Vehicle Security 850i con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Omega Vehicle Security 850i è probabile che voglia condividere il modo di risolverlo.