Manuale per l’uso Windsor A

16 pagine 0.82 mb
Scarica

Vai alla pagina of 16

Summary
  • Windsor A - page 1

    Handling, Installing and Operating Instructions Important Do not operate machine in unstable, low-flow range (surge). Read and become familiar with this manual prior to installing your Spencer Industravac equipment. Following the instructions detailed here will help you realize its full potential of efficient service and extended lifespan. Damage ...

  • Windsor A - page 2

    2 Contents Page I. W arranty 1 II. General Introduction 1 III. Getting Started 1 IV . Operation and Adjustments 7 V . Maintenance 7 Vl. T roubleshooting Guide — Separator 10 Vll. T roubleshooting Guide — V acuum Producer 1 1 I. W arranty We warrant that this product will be free from defects in materials and workmanship for a period of 18 month ...

  • Windsor A - page 3

    3 Location Industravac vacuum producers are designed for operation at or near sea level atmospheric pressure and a nominal ambient temperature of 70°F (21°C).When necessary , they can be factory- designed for higher altitude or higher temperature operation. Consideration should be given to the noise generated by Industravac equipment and its cont ...

  • Windsor A - page 4

    4 Stationary Model. No special foundation is required. A level concrete floor or pad is recommended, although any other substantial floor is satisfactory . The Industravac base should be placed on rubber isomode pads furnished with the unit. In selecting an installation site for a stationary Industravac model, be sure the unit is readily accessib ...

  • Windsor A - page 5

    Stationary Model Portable Model Stationary Model Portable Model 5 Series A Series B 2 1 / 4 cu. ft. DIRT CAN 2 1 / 4 cu. ft. DIRT CAN INLET EXHAUST DIFFUSER MANUAL BAG SHAKER 4" O.D. INLET INLET VA LV E MANUAL BAG SHAKER INLET V AL VE INLET V AL VE INLET V AL VE ST ARTER HANDLE 6" O.D. EXHAUST OUTLET INLET V AL VE MANUAL BAG SHAKER INLET ...

  • Windsor A - page 6

    6 Series C Series D Series V Stationary Model Portable Model INLET VA LV E MANUAL BAG SHAKER INLET INLET V AL VE INLET V AL VE INLET VA LV E 2-1/2 ” O.D. INLET MANUAL BAG SHAKER 2 1 / 4 cu. ft. DIRT CAN 2 1 / 4 cu. ft. DIRT CAN Stationary Model Stationary Model EXHAUST DIFFUSER ST ARTER HANDLE 4 1 / 3 cu. ft. DIRT CAN 7 1 / 2 cu. ft. DIRT CAN INL ...

  • Windsor A - page 7

    7 V . Maintenance CAUTION: Disconnect electrical power before performing any maintenance procedure. 1. Lubrication 1. Motor . Follow motor manufacturer's recommendations. For following items 2 through 4, apply light lubricating oil yearly or more often as needed. 2. Bag shaker rod. Grease yearly or more often as needed. 3. Lift cams, left- and ...

  • Windsor A - page 8

    Reassembly (For Series V see Form ZZ) 1. Bolt the motor down tightly in its original position with the shaft in the exact center of the vacuum producer casing. Be sure that shims (if removed) are replaced in their exact positions on the same attach-points as before. See that packing #3 is in place and tight around the shaft. 2. Place the last-remov ...

  • Windsor A - page 9

    9 Balancing (For Series V see Form ZZ) T urn the machine on with inlet blocked to check balance. If there is excess vibration due to an unbalanced condition after reassemble, use the following balancing procedure: 1. Mark the position of the end impeller hub on the shaft. 2. Loosen the bolts or screws holding the impeller on the shaft. 3. Rotate th ...

  • Windsor A - page 10

    10 Possible Cause • Worn or poorly fitting seals. • Holes worn in separator by abrasive materials. • Leaks. • Separator outlet blocked. • Dirt can liner sucked up against filter bag inlet. • Machine rotating backward. • Filter bags clogged. • Loose bag(s). • Holes in bags. • Leaks. • Incorrect filter bag material. VI. T rou ...

  • Windsor A - page 11

    11 Possible Cause VI. T roubleshooting Guide - V acuum Producer PROBLEM INSUFFICIENT AIR THROUGH SYSTEM MACHINE NOISY Corrective Action Change motor leads to correct rotation. Following instructions on pages 7-8, disassemble machine and reassemble correctly . Increase tubing size or install machine providing higher vacuum. Restrict number of simult ...

  • Windsor A - page 12

    12 Possible Cause VI. T roubleshooting Guide - V acuum Producer (cont.) PROBLEM MACHINE VIBRA TING MOTOR HOT Corrective Action Clean impellers, check filter bags for holes. Straighten shaft. Replace bearing(s). Replace with correct motor . Disassemble machine, balance motor . Disassemble machine, reassemble following instructions on pages 7-8. Ali ...

  • Windsor A - page 13

    13 Filter Bag Part No. Filter Bag Maintenance Record Date Filter Bag Material Date Changed ...

  • Windsor A - page 14

    14 V acuum Accessories Record (Hoses, T ools, V alves) Part No. Description ...

  • Windsor A - page 15

    15 V acuum Cleaning Attachments and Accessories Catalog, Bulletin 241, contains Spencer ’s product line of professional cleaning components for use with portable and station- ary Industravac systems. There are broad selections of hoses, cleaning wands, hand and floor tools, inlet valves, connectors, adapters and accessories to make work easier in ...

  • Windsor A - page 16

    Industrially rated products offering effective solutions for air and gas moving problems: • Modular central vacuum systems • Mobile or stationary integrated vacuum units • Dust collectors and separators • Multi-stage centrifugal blowers • Single stage centrifugal blowers • Regenerative blowers • Gas boosters • Custom-engineered prod ...

Fabbricante Windsor Categoria Vacuum Cleaner

I documenti che otteniamo dal fabbricante del dispositivoWindsor A possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Windsor
- manuali per l’uso A
- schede prodotto Windsor
- opuscoli
- o etichette energetiche Windsor A
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Windsor A.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Windsor A, manuali di manutenzione, brevi manuali o manuali utente Windsor A. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Windsor A.

Manuali per l’uso simili

Manuale completo del dispositivo Windsor A, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Windsor A dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Windsor A.

Il manuale per l’uso completo Windsor, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Windsor A - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Windsor A, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Windsor A che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Windsor A - che ci dovrebbe aiutare nei primi passi durante l'uso Windsor A
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Windsor A
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Windsor A in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Windsor A?

Utilizza il modulo sottostante

Se non hai risolto il problema con Windsor A con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Windsor A è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)