-
Mitsubishi Electronics PKA-RP-KAL - page 1
...
-
Mitsubishi Electronics PKA-RP-KAL - page 2
2 Contents 1. Safety Precautions 2. Parts Names PKA-RP·KAL Filter Air inlet Air outlet Louver Va n e Before installing the unit, make sure you read all the “Safety Precautions”. The “Safety Precautions” provide very important points regarding safety . Make sure you follow them. Please report to or take consent by the supply ...
-
Mitsubishi Electronics PKA-RP-KAL - page 3
3 Wired Remote-Controller °F°C °F°C ERROR CODE AFTER TIMER TIME SUN MON TUE WED THU FRI SA T ON OFF Hr AFTER FIL TER FUNCTION ONL Y1Hr . WEEKL Y SIMPLE A UTO OFF P AR-21MAA ON/OFF FIL TER CHECK OPERA TION CLEAR TEST TEMP . MENU BACK D A Y MONITOR/SET CLOCK ON/OFF Down Up Back Ahead Opening the door . T o preceding operation number . T o nex ...
-
Mitsubishi Electronics PKA-RP-KAL - page 4
4 Wireless Remote-Controller Outdoor unit Power Earth Service Panel Indoor-Outdoor Connection wire Ref. Pipes 2. Parts Names T ransmission indicator T imer indicator When using the wireless remote controller , point it towards the receiver on the indoor unit. If the remote controller is operated within approximately two minutes afte ...
-
Mitsubishi Electronics PKA-RP-KAL - page 5
5 Note: The day and time will not appear if clock use has been disabled at Function Selection of remote controller . Day of the Week & T ime display °C °C TIME SUN P AR-21MAA ON/OFF FIL TER CHECK OPERA TION CLEAR TEST TEMP . MENU BACK DA Y MONITOR/SET CLOCK ON/OFF 2 4 9 1 a T ime Setting TIME SUN 2 3 4 Day of the Week Setting 4. Setting the D ...
-
Mitsubishi Electronics PKA-RP-KAL - page 6
6 5. Operation <T o Stop Operation> Press the ON/OFF button 1 again. • The ON lamp 1 and the display area go dark. Note: Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about three minutes. This is to prevent the internal components from being damaged. ...
-
Mitsubishi Electronics PKA-RP-KAL - page 7
7 5.5. Airflow up/down direction setting <T o change the airflow up/down direction> With the unit running, press the Airflow up/down button 6 as necessary . • Each press changes the direction. The current direction is shown at 6 . • The change sequence, and the available settings, are as follows. Airflow Wireless remote controller Swi ...
-
Mitsubishi Electronics PKA-RP-KAL - page 8
8 6.1. For Wired Remote-controller Y ou can use Function Selection of remote controller to select which of three types of timer to use: 1 Weekly timer , 2 Simple timer , or 3 Auto Off timer . 6.1.1. Weekly Timer The weekly timer can be used to set up to eight operations for each day of the week. • Each operation may consist of any of the foll ...
-
Mitsubishi Electronics PKA-RP-KAL - page 9
9 6.1.2. Simple Timer Y ou can set the simple timer in any of three ways. • Start time only: The air conditioner starts when the set time has elapsed. • Stop time only: The air conditioner stops when the set time has elapsed. • Start & stop times: The air conditioner starts and stops at the respective elapsed times. The simple tim ...
-
Mitsubishi Electronics PKA-RP-KAL - page 10
10 TIMER ON OFF Hr AFTER SIMPLE 1 6 5 T imer Setting °C °C SIMPLE 7 °C °C ON Hr AFTER SIMPLE 7 6. Timer ON Hr AFTER SIMPLE °C °C OFF Hr AFTER SIMPLE SIMPLE At 3 hours after timer start Display changes to show the timer’s OFF setting (hours remaining to OFF). The time displayed is OFF setting (7 hours) – ON setting (3 hours) = 4 hours. At ...
-
Mitsubishi Electronics PKA-RP-KAL - page 11
11 <Checking the Current Auto Off Timer Setting> 1. Be sure that the “Auto Off” is visible on the screen (at 1 ). 2. Hold down the T imer Menu button b for 3 seconds , so that “Monitor” is indicated on the screen (at 4 ). • The timer remaining to shutdown appears at 5 . 3. T o close the monitor and return to the standard control scr ...
-
Mitsubishi Electronics PKA-RP-KAL - page 12
12 7.2. Error Codes indication ON/OFF ERROR CODE If the ON lamp and error code are both flashing: This means that the air conditioner is out of order and operation has been stopped (and cannot resume). T ake note of the indicated unit number and error code, then switch off the power to the air conditioner and call your dealer or servicer . Indo ...
-
Mitsubishi Electronics PKA-RP-KAL - page 13
13 [Function selection flowchart] Setting language (English) OFF on1 on2 OFF ON OFF ON OFF OFF CALL- ON OFF ON OFF C F PAR-21MAA ON/OFF FILTER CHECK OPERA TION CLEAR TEST TEMP . MENU BACK DA Y MONITOR/SET CLOCK ON/OFF F E G C D H B A I G G G G G G E E G G G G G E G E G G G G D D D D D D D D D D D D D D D D D D D D D D D D D D D D D D English German ...
-
Mitsubishi Electronics PKA-RP-KAL - page 14
14 [Detailed setting] [4]–1. CHANGE LANGUAGE setting The language that appears on the dot display can be selected. • Press the [ MENU] button G to change the language. 1 English (GB), 2 German (D), 3 Spanish (E), 4 Russian (RU), 5 Italian (I), 6 Chinese (CH), 7 French (F), 8 Japanese (JP) Refer to the dot display table. [4]–2. Function limit ...
-
Mitsubishi Electronics PKA-RP-KAL - page 15
15 [Dot display table] Selecting language English Germany Spanish Russian Italy Chinese French Japanese W aiting for start-up Operation mode Cool Dry Heat Auto Auto(Cool) Auto(Heat) Fan V entilation Stand by (Hot adjust) Defrost Set temperature Fan speed Not use button Check (Error) T est run Self check Unit function selection Setting of ventilatio ...
-
Mitsubishi Electronics PKA-RP-KAL - page 16
16 X Filter removal Caution: • In removing the filter , precautions must be taken to protect your eyes from dust. Also, if you have to climb up on a stool to do the job, be careful not to fall. • When the filter is removed, do not touch the metallic parts inside the indoor unit, otherwise injury may result. PKA-RP·KAL 1 Using both hands, p ...
-
Mitsubishi Electronics PKA-RP-KAL - page 17
17 1 1. T roubleshooting Having trouble? Here is the solution. (Unit is operating normally .) Air conditioner does not heat or cool well. Clean the filter . (Airflow is reduced when the filter is dirty or clogged.) Check the temperature adjustment and adjust the set temperature. Make sure that there is plenty of space around the outdoor ...
-
Mitsubishi Electronics PKA-RP-KAL - page 18
18 Having trouble? Here is the solution. (Unit is operating normally .) Noise is louder than specifications. The indoor operation sound level is af fected by the acoustics of the particular room as shown in the following table and will be higher than the noise specification, which was measured in an echo-free room. High sound- absorbing rooms N ...
-
Mitsubishi Electronics PKA-RP-KAL - page 19
...
-
Mitsubishi Electronics PKA-RP-KAL - page 20
Please be sure to put the contact address/telephone number on this manual before handing it to the customer . HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN Printed in Thailand RG79D344H01 ...
Hai una domanda su Mitsubishi Electronics PKA-RP-KAL?
Utilizza il modulo sottostante
Se non hai risolto il problema con Mitsubishi Electronics PKA-RP-KAL con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Mitsubishi Electronics PKA-RP-KAL è probabile che voglia condividere il modo di risolverlo.