-
La Crosse Technology WS-9057U - page 1
1 Weather Station Model WS-9057U Instruct ion Man ua l INSTANT TRANSMISSION is the state-o f - the-art new wireless transmissi on technology, exclusively designed and developed by L A CROSSE TECHNOLOGY. INSTANT TRANSMISSION offers you an immediate update (every 4 seconds!) of all your outdoor data measured from the transmitte rs : follow your clima ...
-
La Crosse Technology WS-9057U - page 2
5 SETUP WHEN ONE TRANSMITTER IS USED 1. First, insert the ba tteries in the trans mitter (see “ How to install and replace batteries in the Thermo-hygro outdoor transmitter ” on page 11). 2. Within 2 minutes of powering up the transmitte r, insert the batteries in the W eather St ation (s ee “ How to install a nd replace batterie s in the Wea ...
-
La Crosse Technology WS-9057U - page 3
9 When the weather station is receiving the WWVB time signal, the outdoor transmitter data signal will temporarily not be receiv ed by the weather station. During this short period of time, the outdoor readings shown on the weather station will not be renew ed until the WWVB time signal is successf ully recei ved. TO INSTALL A ND REPLACE BATTER ...
-
La Crosse Technology WS-9057U - page 4
13 will sound for every seco nd. It is possible that your wireless w eather station may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accu rate; under 0.10 second s per day. FUNCTION KEYS: The Weather Station has 5 easy to use functi on key ...
-
La Crosse Technology WS-9057U - page 5
17 * When the signal is successfully received by t he Weather Station, the outdoor transmission icon will be switched on. I f not successful, the icon will no t be shown on LC D. The user can the n easily see whe ther the last reception was successful (icon on) or not (icon off). A short b linking of the icon indicates that signal reception is curr ...
-
La Crosse Technology WS-9057U - page 6
21 12/24-HOUR FORMA T SETTING: The hour display can be selecte d to show hours in 12-hour or 24-hour settings. (Default 12-Hour) 1. Use the OU T/+ key to toggl e between “12H” or “2 4H”. 2. Confirm with the SET key and enter the Manual time setting . MA NUA L TIME SETT ING: If Weather Station cannot detect the WWVB-signal due to disturbance ...
-
La Crosse Technology WS-9057U - page 7
25 2. Confirm with the SET key and enter the Relative air pre ssur e value s etting . Note : Units of weather icon sensitivity and air pressure history are not affected. They are always expressed in hPa. RELATIVE A IR PRESSURE VALUE SET TING The default relative pressure value is 29.92 inHg (1013 hPa). This can be manually set to another value with ...
-
La Crosse Technology WS-9057U - page 8
29 INDO OR RELA TIV E HUM IDI TY A ND INDO OR TEMP ER ATU RE: The indoor temperature and hum idity data and the indoor comfort indicator are automatically update d and displayed on the second section of the LCD. Indoor relat ive humidity in RH% Indoo r temperature in °C or ºF MAX icon New Moon Small Waxing Crescent Large Waxing Crescent First Qua ...
-
La Crosse Technology WS-9057U - page 9
33 If the Weather stati on is moved to another location significantly higher or lower than its initi al standing point (fo r example from the ground floor to the upper floors of a h ouse), discard the w eather foreca st for the nex t 48- 60 hours. By doing this, the Weather Station will not mistake the new location as being a possible ch ange in ai ...
-
La Crosse Technology WS-9057U - page 10
37 2. Use OUT/+ key to view the MIN/MAX temperature and humidity data for the sele cted transmitter. 3. To reset the minimum and maximum temperatur e and humidity data, and the times at which they were recorded , press the SET key continuously for abou t 3 seconds. This will reset t he MIN/MAX data recorde d to the current time, date, temperat ure ...
-
La Crosse Technology WS-9057U - page 11
41 2. Clip the remote temperature transmitt er onto the bracket. Note : The mounti ng surface can affect th e transm ission range. If, for instance, the unit is attached t o a piece of metal, it ma y then either reduce or increase the transmittin g range. For this reason, we recommend not to place the unit on any metal sur f aces or in any position ...
-
La Crosse Technology WS-9057U - page 12
45 parts or products if found to be defectiv e during the limited warranty period specifie d above. All replaced parts and produc ts become the property of La Crosse Technology , Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty , or ninety (90) days, whichever is longer. La ...
La Crosse Technology WS-9057Uについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもLa Crosse Technology WS-9057Uの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがLa Crosse Technology WS-9057Uで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。