-
Dual DA304 - page 1
INSTALLATION / OWNER'S MANUAL Mobile Power Amplifiers PERFORMANCE SERIES DA304 DA602 DA604 DA904 DA4001 DA6001 DA8001 ...
-
Dual DA304 - page 2
2 INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your Dual amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnectnegative batteryterminal. (consult aqualified technician? ...
-
Dual DA304 - page 3
NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used as a general guideline only. Power Wire (+12V) • Disconnectnegative batteryterminal before proceeding.Consult aqualified technician for instructions ...
-
Dual DA304 - page 4
DA602 DA304 DA604 DA904 High Level Inputs RCA Line Inputs Pass Through Gain 1 2 3 Hi-Pass Filter Crossover Mode Low-Pass Filter Bass Boost 4 5 6 7 8 INSTALLATION Audio Inputs and Controls 4 8 2 4 1 3 5 6 7 2 4 1 5 6 7 8 ...
-
Dual DA304 - page 5
DA602 DA304 DA904 DA604 Speaker Connections Fuse(s) +12VDC Battery Connection 1 2 3 Remote Turn On Ground Connection 4 5 INSTALLATION Power and Speaker Connections 5 5 4 1 2 3 5 4 1 2 3 5 4 1 2 3 ...
-
Dual DA304 - page 6
DA4001 DA6001 DA8001 RCA Line Inputs Pass Through Gain Phase Control Subsonic Filter 1 2 3 Bass Boost Low Pass Filter Slave/Master Controls Data Link Remote 4 5 6 7 8 9 10 INSTALLATION Audio Inputs and Controls 6 2 4 1 3 5 6 7 8 9 10 ...
-
Dual DA304 - page 7
DA4001 DA8001 DA6001 Speaker Connections Fuse(s) +12VDC Battery Connection 1 2 3 Remote Turn On Ground Connection 4 5 INSTALLATION Power and Speaker Connections 7 5 4 1 3 2 5 4 1 3 2 5 4 1 3 2 ...
-
Dual DA304 - page 8
REM (Remote Turn On) SPEAKERS RCA CABLES GROUND FUSE 12V BATTERY MAXIMUM 12V DC (Power) 2-8 ohms Fuse Rating Whenreplacing fuses,makesure newfuse isthe correcttypeand amperage.Using an incorrect fuse could damage the amplifier. DA602 20A x1 DA304 30A x1 DA604 20A x2 DA904 30A x2 D ...
-
Dual DA304 - page 9
High-Level Input (speaker cables) Low-Level Input (RCA) Speaker Connections Connect speaker wires observing polarity. The minimum impedance load for the DA304, DA602, DA604 and DA904 is 2 ohms stereo and 4 ohms bridged. Use of loads lower than these is not recommended and may cause amplifier damage. The DA304, DA602, DA604 and DA904 can be wired fo ...
-
Dual DA304 - page 10
INSTALLATION Master/Slave Mode TheDualmonoampliersfeatureaMaster/Slavemode,wheretwoamplierscanbe connectedtogether.Whentwomonoampliersareconnectedtogether,thepower frombothampliersiscombined. 10 ...
-
Dual DA304 - page 11
11 INSTALLATION *MASTER For master amplifier, set the switch to master. This will route the signal through Line-out to the slave amplifier. Set the phase to 0, all adjustments for gain and sound are done on this amplifier. The remote subwoofer control should be connected to master amplifier as well. *SLAVE For slave amplifier, set the switch t ...
-
Dual DA304 - page 12
The input level control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input. Begin by turning the input level control fully counterclockwise. Next, turn up the head unit volume control around 3/4 of the way up. Adjust the input level control clockwise until audible distortion is heard, then sl ...
-
Dual DA304 - page 13
Problem Cause Action Unit will not turn on (no power LED indicator) +12Vwire notconnected orincorrect voltage.REM wirenot connectedor incorrectvoltage Checkconnectionsfor propervoltage (11~16VDC) GNDwire notconnected Check connectionto ground Fuse(s)blown Replace fuse(s) ...
-
Dual DA304 - page 14
DA602 Power Out put (1 4.4VDC, 20Hz ~ 20kHz): •60 Watts RMS x 2 channels @ 4ohms • 1 00 Watts RMS x 2 channels @ 2ohms • 21 5 Watts RMS x 1 channel @ 4ohms (bridged) Peak Music Power Outpu t: 380 Watts Signal t o noise ratio: 90dB (THD< 0.05% @ 4Ω, 1 4.4V) Frequency response: 1 0Hz– 35kHz (-3dB) Amplifier dimensions: 2” x 9.3” x 7 . ...
-
Dual DA304 - page 15
INSTALLATION Specifications DA4001 Power Out put (1 4.4VDC, 20Hz ~ 250Hz): •850 Watts RMS x 1 channel @ 2ohms • 1 200 Watts RMS x 1 channel @ 1ohm Peak Music Power Outpu t: 3200 Watts Signal t o noise ratio: > 80dB (THD < 0.5% @ 4Ω, 1 4.4V) Frequency response: 20Hz -1 50Hz (-3dB) Amplifier dimensions: 2” x 9.3” x1 1 .8” (5 1 x 236 ...
-
Dual DA304 - page 16
DualElectronics Corp. TollFree: 1-866-382-5476 9AM-5PM,EST www.dualav.com ©2014Dual ElectronicsCorp. NSA1113-V01 Thiswarranty givesyou specific legalrights. Youmay alsohave other rightswhich vary from state to state. DualElectronics Corp.warrants this product ...
Dual DA304についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもDual DA304の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDual DA304で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。