-
Audiovox PRO 9644a - page 1
128-6619 1 of 10 Model PRO 9644a Owner ’s Manual 3 Button Remote Security System with Starter Disable IMPORT ANT ! In order to provide the highest possible level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to manually override your security system if the transm ...
-
Audiovox PRO 9644a - page 2
128-6619 2 of 10 YOUR " CODE HOPPING " TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s sophisticated auto thieves use a device known as a code grabber , which will receive and st ...
-
Audiovox PRO 9644a - page 3
128-6619 3 of 10 þ Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the sys ...
-
Audiovox PRO 9644a - page 4
128-6619 4 of 10 o Whenever the system is triggered, the vehicle’s horn will beep for the full 30 second alarm cycle, attracting added attention to the vehicle. o Optional - Whenever the system is triggered, the interior courtesy lights will flash for the full 30 second alarm cycle. þ Whenever the system is armed, the vehicle’s starting circui ...
-
Audiovox PRO 9644a - page 5
128-6619 5 of 10 SILENT DISARMING 1. As you approach the vehicle, press and hold the Unlock button on the keychain transmitter for 2 seconds. þ Red dash mounted LED turns off. If passive arming was selected during the installation, then the LED will start flashing rapidly , indicating that the system is re-arming automatically . Open any door to s ...
-
Audiovox PRO 9644a - page 6
128-6619 6 of 10 If the LED is flashing one time...pause...one time...pause...etc., then an intrusion attempt was made to the OPTIONAL shock sensor, or an accessory triggering device that may have been added to the system. If the LED is flashing two times...pause...two times...pause...etc., then an intrusion attempt was made to a hood or tr ...
-
Audiovox PRO 9644a - page 7
128-6619 7 of 10 Page 7 1. Disarm the system by use of the transmitter , or by use of the emergency override sequence. Turn the ignition switch to the on position. 2. Within 10 seconds, press and release the valet/override switch, 3 times. 3. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the ...
-
Audiovox PRO 9644a - page 8
128-6619 8 of 10 Page 8 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. MANUALL Y OVERRIDING YOUR SYSTEM: USING THE CUSTOM CODE OVERRIDE Assuming the override code programmed has not been changed, and the default override code of 1 1 is in the system's memory . 1. Enter the vehicle and t ...
-
Audiovox PRO 9644a - page 9
128-6619 9 of 10 Page 9 allotted 30 seconds, however , the security system will be disarmed allowing the vehicle to start. OPTIONAL DEVICE OUTPUT (CHANNEL 3) Controlled By: o Option Button, o Both Lock & Unlock Button, o Both Option & Lock Button, or Both Option and Unlock Button. This security system is equipped with an output which will a ...
-
Audiovox PRO 9644a - page 10
128-6619 10 of 10 PRO 9644 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING SLOW FLASHING = ARMED OF F = DISARMED ON S OL ID = V ALET MODE 3 FLASH...P AUSE = INTRUSION ZONE 3 2 FLASH...P AUSE = INTRUSION ZONE 2 1 FLASH...P AUSE = INTRUSION ZONE 1 SIREN AND / OR HORN CHIRP INDICA TORS 1 CHIRP * = A R M 2 CHIRPS * = ...
Audiovox PRO 9644aについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもAudiovox PRO 9644aの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAudiovox PRO 9644aで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。