-
Casio PRW-1500-1VER - page 1
Operation Guide 3134 3205 1 MO1002-EA Getting Acquainted Congratulations upon your selection of this CASIO w atch. T o get the most out of your purchase, be sure to read this man ual carefully . • This watch does not have a time zone that corresponds to the UTC offset of –3.5 hours. Because of this, the radio-controlled timekeeping and W orld T ...
-
Casio PRW-1500-1VER - page 2
Operation Guide 3134 3205 2 Radio-controlled Atomic Timekeeping This watch receives a time calibr ation signal and updates its time setting accordingly . • This watch is designed to pic k up the time calibration signals transmitted in Germany (Mainflingen), England (Anthorn), the United States (For t Collins) and Japan. • See the inf or mation ...
-
Casio PRW-1500-1VER - page 3
Operation Guide 3134 3205 3 Note • When a calibration time is reached, the watch will receiv e the calibration signal only if it is in either the Timekeeping Mode or World Time Mode. Reception is not performed if a calibration time is reached while y ou are configuring settings. • A uto receive of the calibration signal is designed to be perfor ...
-
Casio PRW-1500-1VER - page 4
Operation Guide 3134 3205 4 Digital Compass A built-in bearing sensor detects magnetic nor th and indicates one of 16 directions on the display . Direction readings are performed in the Digital Compass Mode. • Y ou can calibrate the bearing sensor if you suspect the direction reading is incorrect. • See “ Using the Digital Compass While Mount ...
-
Casio PRW-1500-1VER - page 5
Operation Guide 3134 3205 5 • Y ou can turn off ( OFF ) magnetic declination correction (which effectiv ely makes the magnetic declination angle: 0 ° ) by pressing A and C at the same time. • The illustration, for e xample, shows the v alue you should input and the direction setting you should select when the map sho ws a magnetic declination ...
-
Casio PRW-1500-1VER - page 6
Operation Guide 3134 3205 6 Barometer/Thermometer This watch uses a pressure sensor to measure air pressure (barometric pressure) and a temperature sensor to measure temperature. • Y ou can calibrate the pressure sensor and the temperature sensor if you suspect that readings are incorrect. To take barometric pressure and temperature readings Pres ...
-
Casio PRW-1500-1VER - page 7
Operation Guide 3134 3205 7 To display your current altitude 1. Press A in the Timekeeping Mode or in any of the other sensor modes to enter the Altimeter Mode. • The watch will star t altitude measurement automatically , and display the result. • It can take up to four or five seconds f or the altitude reading to appear after you enter the Alt ...
-
Casio PRW-1500-1VER - page 8
Operation Guide 3134 3205 8 • If the Moon phase indicator shows a phase that is a mirror image of the actual moon phase in your area, y ou can use the procedure under “ Rev ersing the Displayed Moon Phase ” to change it. To view Moon Data for a particular date, or Tide Data for a particular date and time 1 . In the Tide/Moon Data Mode, use A ...
-
Casio PRW-1500-1VER - page 9
Operation Guide 3134 3205 9 Countdown Timer Examples Countdown start time: 10 minutes; Reset time: 5 minutes Progress beeper: On 10'00" Start Time Reset Time 0'00" 1'00" 0'10" 2'00" 3'00" 4'00" 5'00" Reset P eriod Reset Period Beeper Countdown End Beeper Reset Time Beep ...
-
Casio PRW-1500-1VER - page 10
Operation Guide 3134 3205 10 To set an alarm time 1. In the Alarm Mode, use A and C to scroll through the alarm screens until the one whose time you want to set is displa yed. 2. Hold down E until the hour setting of the alarm time star t to flash, which indicates the setting screen. • This automatically tur ns on the alar m. 3. Press D to mov e ...
-
Casio PRW-1500-1VER - page 11
Operation Guide 3134 3205 11 0 ft 2000 ft 4000 ft 6000 ft 8000 ft 10000 ft 12000 ft 14000 ft 25.84 inHg 22.23 inHg 19.03 inHg 44.7 ° F 30.5 ° F 16.2 ° F 59.0 ° F 29.92 inHg About 3.6 ° F per 1000 ft About 0.15 inHg per 200 ft About 0.17 inHg per 200 ft About 0.192 inHg per 200 ft About 0.21 inHg per 200 ft Source: International Civil Aviation ...
-
Casio PRW-1500-1VER - page 12
Operation Guide 3134 3205 12 Recovery Times The table below sho ws the amount exposure that is required to tak e the battery from one level to the ne xt. • The abov e exposure time v alues are all for ref erence only . Actual required e xposure times depend on lighting conditions. Appro ximate Exposure Time Le vel 5 Le vel 4 Le vel 3 Le vel 2 Lev ...
-
Casio PRW-1500-1VER - page 13
Operation Guide 3134 3205 13 Moon Phase Indicator The Moon phase indicator of this watch indicates the current phase of the Moon as shown below . It is based on the view of the left side of the moon at meridian transit from the nor thern hemisphere of the Earth. If the appearance of the Moon phase indicator is rev ersed from the actual Moon as view ...
-
Casio PRW-1500-1VER - page 14
Operation Guide 3134 3205 14 To recover from the sleep state P erform any one of the f ollowing operations. • Mov e the watch to a well-lit area. It can take up to two seconds for the display to turn on. • Press any b utton. • Angle the watch tow ards your face f or reading. To turn Power Saving on and off 1. In the Timekeeping Mode, hold do ...
-
Casio PRW-1500-1VER - page 15
Operation Guide 3134 3205 15 3. Use A (+) and C ( – ) to set the calibration v alue in the units shown below . T emperature 0.1 ° C (0.2 ° F) Barometric Pressure 1 hPa (0.05 inHg) • “ OFF ” is displa yed while the reference temper ature value and barometric pressure value are zero (0). • Pressing A and C at the same time retur ns to the ...
Casio PRW-1500-1VERについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもCasio PRW-1500-1VERの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCasio PRW-1500-1VERで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。