日本語 dropdown-ico

Lennox Hearth HCI-42の取扱説明書

20ページ 0.43 mb
ダウンロード

ページに移動 of 20

Summary
  • Lennox Hearth HCI-42 - page 1

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 1 42" Wood Burning Fireplaces P/N 850,047M REV. B 12/2008 RDI-42 HCI-42 RDI-42-H HCI-42-H MODELS OMNI Report No. 116-F-52-2 This installation manual will enable you to obtain a safe, efficient and dependable installation of your fireplace system. Please read and under- stand these instructions b ...

  • Lennox Hearth HCI-42 - page 2

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 2 TABLE OF CONTENTS Safety Rules .................................... page 2 Tools and Building Supplies ............ page 2 Precautions ..................................... page 3 Introduction ..................................... page 3 Clearances/Height Requirements ..... page 3 Chimney System .. ...

  • Lennox Hearth HCI-42 - page 3

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3 Figure 1 TYPICAL INSTALLATION *Construction Materials: • framing materials • paneling • particle board • flooring • dry wall • etc. • plywood PRECAUTIONS Note: These fireplace systems are not difficult to install. However, in the interest of safety, it is recommended that the installe ...

  • Lennox Hearth HCI-42 - page 4

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 4 Figure 2 Chimney Height The total height of your completed fireplace system from the surface the fireplace rests on to the chimney top must not exceed 60' and must also meet minimum height requirements. Refer to the minimum system height chart. LOCATION OF FIREPLACE Carefully select the proper ...

  • Lennox Hearth HCI-42 - page 5

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 5 Note: Install the hearth extension only as illus- trated. The safety strips should extend from front of the fireplace at least 1-1/2" and should extend to be at least flush with the sides. In the event a wooden support is used to elevate the fireplace above the floor, a “Z” type safety str ...

  • Lennox Hearth HCI-42 - page 6

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 6 FIREPLACE SPECIFICATIONS Figure 10 Figure 8 Figure 9 Step 3. Refer to fireplace drawings and specifi- cations on pages 6 and 7 for framing dimensions and details. Frame appliance enclosure as illus- trated in Figures 11 through 14 on page 8. IMPORTANT: UNDER NO CIRCUMSTANCES CAN THE FIREPLACE TOP S ...

  • Lennox Hearth HCI-42 - page 7

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 7 FRAMING SPECIFICATIONS Figure 11 Figure 12 Figure 13 Figure 15 Figure 16 Figure 14 A B Ceiling Framing C D Roof Framing Header Fireplace Framing B A A Outside Chase G H Back Wall of Chase/Enclosure Including Finising Materials if any Rough Framing Face (Unfinished Shown) FOAK Combustion Air Kit - O ...

  • Lennox Hearth HCI-42 - page 8

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 8 Step 4. Fireplace should be secured to side framing members using the nailing tabs at the top and bottom of the fireplace front face. Use 8d nails or equivalent ( Figure 17 ). Figure 17 Note: The nailing tabs and the area directly behind the nailing tabs are exempt from the clearances described on ...

  • Lennox Hearth HCI-42 - page 9

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 9 Figure 25 Outer pipe section installs in just the opposite way; the lanced end goes down and each new section goes OVER the outside of the previous section installed ( Figure 26 ). Figure 26 Security's chimney sections do not need to be screwed together. Additional reinforcement is not necessa ...

  • Lennox Hearth HCI-42 - page 10

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 10 Next, slide roof flashing over extended chimney section that previously has been installed above the roof opening in Step 4. FTF8 flashings require flashing spacers. Slide flashing all the way down until the flashing base rests flat on the roof ( Figure 29 ). Again, check the vertical position of ...

  • Lennox Hearth HCI-42 - page 11

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 11 Figure 34 Note: It is recommended that all exterior ex- posed metal fireplace components; such as terminations, flashings, storm collars and/or flue be painted with a premium quality, high temperature, rust preventative paint designed for metal. This is especially important when installations are ...

  • Lennox Hearth HCI-42 - page 12

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 12 FTF8 VERTICAL ELEVATION CHART Height Of Number Of FTF8 Chimney Only Chimney Lengths Inches Feet/Inches 12" 18" 36" 48" Height Of Number Of FTF8 Chimney Only Chimney Lengths Inches Feet/Inches 12" 18" 36" 48" 386 ¹⁄₂ 32 2 ¹⁄₂ 01 0 8 390 ³⁄₄ 32 ...

  • Lennox Hearth HCI-42 - page 13

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 13 A B FTF8-ES30 Number of FTF8 Chimney Sections Offset Height Offset/Return FTF8-S4 (Inches) (Inches) Elbow Stabilizer 12" 18" 36" 48" 41 5 ³⁄₄ 10 0 0 0 0 92 4 ¹⁄₂ 10 1 0 0 0 12 29 ³⁄₄ 10 0 1 0 0 14 ¹⁄₄ 33 ¹⁄₂ 10 2 0 0 0 17 ¹⁄₄ 38 ¹⁄₂ 10 1 1 0 0 ...

  • Lennox Hearth HCI-42 - page 14

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 14 Step 5. Secure support straps to framing members by nailing under tension in sheer ( Figure 41 ). INSTALLING OFFSETS First, review the Offset Elevation Chart and Figure 38 for reference. Step 1. Determine the offset distance where chimney is to pass through the first ceiling- dimension “A.” To ...

  • Lennox Hearth HCI-42 - page 15

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 15 Figure 42 Figure 43 THIS FIREPLACE IS NOT INTENDED TO BE USED AS A SUBSTITUTE FOR A FURNACE TO HEAT AN ENTIRE HOME. USE FOR SUPPLE- MENTARY HEATING ONLY. HOUSE WIRING COVER PLA TE Replace Cover Plate After Electrical Hook-Up POWER TO THE FIREPLACE The Optional Blower Kit Operates on 115 volt 60 Hz ...

  • Lennox Hearth HCI-42 - page 16

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 16 It is especially important to insulate between the studs of an outside chase cavity and under the floor if the floor is above ground level. Do not place insulation directly against the fire- place or chimney system. FIREPLACE FINISHES Mantels and Trim It is sometimes best to frame your fireplace a ...

  • Lennox Hearth HCI-42 - page 17

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 17 Figure 47 A B D C C Hearth Extension Dimensions A 16" B 38" C 8" D 54" Note: To convert inches to millimeters divide by 0.03937 Answer - The minimum required thickness of the Micore 160 is .875”, therefore round up to 7/8” and use the nearest standard thickness available wh ...

  • Lennox Hearth HCI-42 - page 18

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 18 Secure the hearth extension to the floor to prevent possible shifting. FINISH TO YOUR TASTE There are a wide variety of “finished looks” for these fireplaces, from formal wall decor with elaborate mantels to rustic wood paneling or warm brick facings. Only noncombustible materials like stone, ...

  • Lennox Hearth HCI-42 - page 19

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 19 Stabilizer 63L25 FTF8-S4 Firestop Spacer (30 ° ) 63L32 F8FS30-2 Offset/ Return Package (30 ° ) 63L22 FTF8-ES30 INSTALLATION COMPONENTS The following items are available for use in the installation of this appliance. Storm Collar 63L59 FSC 63L38 F8F6 Flashing 63L39 F8F12 Round Termination 63L42 F ...

  • Lennox Hearth HCI-42 - page 20

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 20 Printed in U.S.A. © 2007 by LENNOX HEARTH PRODUCTS P/N 850,047M REV. A 12/2008 The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fire ...

メーカー Lennox Hearth カテゴリー Indoor Fireplace

Lennox Hearth HCI-42のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- HCI-42の取扱説明書
- Lennox Hearthの製品カード
- パンフレット
- またはLennox Hearth HCI-42の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Lennox Hearth HCI-42の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Lennox Hearth HCI-42の取り付け説明書、サービスマニュアル、簡易説明書、またはLennox Hearth HCI-42のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Lennox Hearth HCI-42の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Lennox Hearth HCI-42デバイスの取扱説明書はどのようなものですか？
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがLennox Hearth HCI-42を使用するのを助ける技術的文書のことです。説明書は通常、全てのLennox Hearth HCI-42ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Lennox Hearthの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Lennox Hearth HCI-42の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははLennox Hearth HCI-42の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Lennox Hearth HCI-42に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Lennox Hearth HCI-42デバイスの基本機能を使うにあたってのヒント。 Lennox Hearth HCI-42のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Lennox Hearth HCI-42に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるLennox Hearth HCI-42のメーカー/サービスへの連絡先に関する情報。

Lennox Hearth HCI-42についてご質問がありますか？

次のフォームを使用してください

見つけた説明書を読んでもLennox Hearth HCI-42の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがLennox Hearth HCI-42で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

Captcha
新しい画像

コメント (0)