-
Craftsman 358.794772 - page 1
Operator's Manual CRAFTSMR 25cc/1.5 cu.in. 2-Cycle 215 MPH/470 CFM GASOLINE POWERED BLOWER/VAC Model No. 358.794772 • Safety • Assembly • Operation • Maintenance • Parts List • Espa_ol, p, 20 i WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about ...
-
Craftsman 358.794772 - page 2
Warranty Statement 2 Storage 13 Identification of Safety Symbols 2 Troubleshooting Table 14 Safety Rules 3 Emissions Statement 15 Assembly 5 Parts List 17 Operation 8 Spanish 20 Maintenance 11 Parts and Ordering Sack Cover TWO YEAR FULL WARRANTY ON CRAFTSMAN@ GAS BLOWER When used and maintained according to the operator's manual, if this produ ...
-
Craftsman 358.794772 - page 3
_O _ Secure hair above shoulder length, Do not wear jewelry, loose clothing, or clothing with loosing hanging straps, ties, tassels, etc. They can be caught in moving parts. _ WARNING: Stop the engine before opening the vacuum inlet door. The engine must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating ...
-
Craftsman 358.794772 - page 4
Use your unit as a blower for: • Sweeping debris or grass clippings from driveways, sidewalks, patios, etc. • Blowing grass clippings, straw, or leaves into piles, around joints, or be- tween bricks. Use your unit as a vacuum for: • Picking up dry material such as leaves, grass, small twigs, and bits of paper. • For best results during vacu ...
-
Craftsman 358.794772 - page 5
blower tubes. When using the op- tional vacuum kit, always install vac- uum tubes and vacuum bag assem- bly. Make sure vacuum bag assem- bly is completely zipped. • Check air intake opening, blower tubes, and vacuum tubes frequently. always with engine stopped and spark plug disconnected. Keep vents and discharge tubes free of debris which can ac ...
-
Craftsman 358.794772 - page 6
WARNING: If you receive your unit assembled, repeat all steps to en- sure your unit is properly assembled and all fasteners are secure. A standard screwdriver is required for assembly. BLOWER ASSEMBLY BLOWER TUBE ASSEMBLY If you have already assembled your unit for use as a vacuum, remove the vacuum tubes and collection bag. 1. Align the rib on the ...
-
Craftsman 358.794772 - page 7
6. Turn knob clockwise tosecure el- bow tube. VACUUM TUBE ASSEMBLY _WARNING: Stop engine and be sure the impeller blades have stopped turning before opening the vacuum inlet door or attempting to insert or remove the vacuum or blower tubes. The rotat- ing blades can cause serious injury. 1. Insert the tip of a screwdriver into the latch area of the ...
-
Craftsman 358.794772 - page 8
SHOULDER STRAP ATTACHMENT (optional acce88ory #71-85783) 1. Pass the shoulder strap over your head and onto your left shoulder. 2. Snap the hook onto the retainer (see following illustration). BLOWER USE VACUUM USE Retainer KNOW YOUR BLOWER READ THiS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT Compare the illustrations with y ...
-
Craftsman 358.794772 - page 9
THROTTLE POSITION LEVER The THROTTLE POSITION LEVER is de- signed to allow setting engine speed during blower use only. To avoid caus- ing damage to the unit, DO NOT at- tempt to use the throttle position lever during vacuum use. PRIMER BULB The PRIMER BULB removes air from the carburetor and fuel lines and flits them with fuel This allows you to s ...
-
Craftsman 358.794772 - page 10
leaded gasoline. Included with this blow- er is a 3.2 ounce container of oil. Pour the entire contents of this container into 1 gallon of gasoline to achieve the prop- er fuel mixture. DO NOT USE automotive oil or boat oil. These oils will cause en- gine damage. When mixing fuel, follow instructions printed on container. Once oil is added to gasoli ...
-
Craftsman 358.794772 - page 11
Starter Handle Start/_ Lever Primer / Bulb 4. This unit has the Sim-pul' starting system. You do not have to pull the starter rope handle sharply or briskly. Pult starter rope handle 5 times with a controlled and steady motion (no more than 3 times above 90F). If engine starts and runs prior to 5 pulls, allow engine to run for 5 seconds; the ...
-
Craftsman 358.794772 - page 12
CHECK FOR LOOSE FASTENERS AND PARTS • Muffler • Spark Plug Boot • Air Filter • Housing Screws CHECK FOR DAMAGED OR WORN PARTS Contact Sears Service Center for re- placement of damaged or worn parts. • Fuel Tank - Do not use unit if fuel tank shows signs of damage or leaks. • Vacuum Bag - Do not use vacuum bag if it is torn or damaged. I ...
-
Craftsman 358.794772 - page 13
, Spark Arresting Screen Screws Replace the spark arresting screen ev- ery 50 hours of operation or if any dam- age or breaks in file screen are noted. NOTE: Do not attempt to clean the spark arresting screen. 1. Remove 3 screws from muffler cov- er. Remove muffler cover. 2. Loosen and remove 4 screws from the muffler hood. 3. Remove the muffler ho ...
-
Craftsman 358.794772 - page 14
ENGINE • Remove spark plug and pour 1 tea- spoon of 40:1,2-cycle engine oit (air cooled) through the spark plug open- ing. Slowly pull the starter rope 8 to 10 times to distribute oil. • Replace spark plug with new one of recommended type and heat range. • Clean air filter. • Check entire unit for loose screws, nuts, and bolts. Replace any ...
-
Craftsman 358.794772 - page 15
YOUR WARRANTY RIGHTS AND OB- LIGATIONS: The U.S. Environmental Protection Agency/California Air Re- sources Board and Sears, Roebuck and Co., U.S.A., are pleased to explain tile emissions control system warranty on your year 2007 and later small off-road engine. In California, all small off-road engines must be designed, built, and equipped to meet ...
-
Craftsman 358.794772 - page 16
WHERE TO GET WARRANTY SER- VICE: Warranty services or repairs shall be provided at all Sears Service Cen- ters. Call 1-800-469-4663. MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION RE- LATED PARTS: Any Sears approved replacement part used in the perfor- mance of any warranty maintenance or repair on emission related parts will be provided without c ...
-
Craftsman 358.794772 - page 17
REPAIR PARTS SEARS GAS BLOWER MODEL 358.794772 2_ _&WARNING A_ repair8 adjustments and mahltenanee ilot descdbed in the Operatol's Manual must _e performed by Qualified Selvice Re 5onne_ Ref Part No. 1 530015814 2. 545150502 3 530015880 4 545134001 5 545099101 6 545052401 7 545052501 6. 545050407 9 545054901 10 545152901 11 545050416 12. 5 ...
-
Craftsman 358.794772 - page 18
REPAIR PARTS SEARS GAS BLOWER MODEL 358.794772 ,t_WARNING AI_ lepairs adjustment3 and maintenance not desodbe_l in the Ope_ato's Manua_ must be performer1 by Qualified Se vice Personnel / Ref. Part No. 1 545090001 2 530015241 3 545081845 4 530058982 5 545081832 6 545115301 7 530015953 8 Champion g 545084901 10 545115501 11 545081857 12 5451571 ...
-
Craftsman 358.794772 - page 19
REPAIR PARTS SEARS GAS BLOWER MODEL 358.794772 / _ "C ......... i i 7 Ref. Part No Description 1 545099401 Tube Uppe_ vac 2. 530095589 Tube Lowel vac 3 545139501 Tube J 4 530095564 Assy Vuc bag 5 545138001 Tube Uppe_ Blower 8 545138101 Tube Lowe_ Blower 7 545151201 Nozzle High Speed ...
Craftsman 358.794772についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもCraftsman 358.794772の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCraftsman 358.794772で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。