-
Cisco Systems OL-6109-01 - page 1
CH A P T E R 4-1 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 4 Zone Configuration This chapter describes zone confi guration. It includes the foll owi ng major sections: • Basic Zone Conf iguration • Zone Remote Guard List • Zone Traf f ic Learning • Zone Detection Basic Zone Configuration This section describes the ini tial Zone ...
-
Cisco Systems OL-6109-01 - page 2
Chapter 4 Z one Configuration Basic Zone Configur ation 4-2 Cisco Traffic Anomaly De tector User Guide OL-6109-01 • Removing a Zone IP Address • Removing all Zo ne IP Addresses Defining a New Zone The Detector enables the us er to define a ne w zone based on a vari ety of templates. T o defi ne a ne w zone perform the followi ng: 1. From the Co ...
-
Cisco Systems OL-6109-01 - page 3
4-3 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Basic Zone Configuration Note If no zone template is specif ied, the zone will be defined u sing the Detector DEF A UL T zone template. – base-zone-name —(Optional) Th e name of a desired zone used as a template for the ne w zone. – interactive —(Optional ...
-
Cisco Systems OL-6109-01 - page 4
Chapter 4 Z one Configuration Basic Zone Configur ation 4-4 Cisco Traffic Anomaly De tector User Guide OL-6109-01 2. Choose ENTER . The following prompt appears: admin@DETECTOR–conf-zone-<new-zone-name># T o duplicate a zone from the zone command group lev el perform the follo wing: 1. From the Zone command gr oup le vel of the desired zone ...
-
Cisco Systems OL-6109-01 - page 5
4-5 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Basic Zone Configuration Removing All Zones The user may remov e all the D etector’ s zones. Caution Removing all zones eliminates their DDoS detection. T o remov e all zones perform the follo wing: 1. From the Conf iguration command group le vel type the fol l ...
-
Cisco Systems OL-6109-01 - page 6
Chapter 4 Z one Configuration Basic Zone Configur ation 4-6 Cisco Traffic Anomaly De tector User Guide OL-6109-01 Where: – template-name —A zone template. Options i nclude: Default —The Guard default zone template LINK_128K —A template designed fo r bandwidth-limited Links LINK_1M —A template designed for bandwidth-limited Links LINK_4M ? ...
-
Cisco Systems OL-6109-01 - page 7
4-7 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Basic Zone Configuration Where zone-name specifies the desired zone name. 2. Choose ENTER . Below is an e xample of the zone command implementation: admin@DETECTOR-conf# zone scannet admin@DETECTOR-conf-zone-scannet# Describing a Zone The user may add a descripti ...
-
Cisco Systems OL-6109-01 - page 8
Chapter 4 Z one Configuration Basic Zone Configur ation 4-8 Cisco Traffic Anomaly De tector User Guide OL-6109-01 – ip-mask —(Optional) The zone IP subnet mask. Note If no mask is s pecified, the Detect or assumes th e default subnet mask 255.255.255.255. 2. Choose ENTER . Below is an e xample of the ip address command implemen tation: admin@DE ...
-
Cisco Systems OL-6109-01 - page 9
4-9 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Remote Guard List Note If no mask is s pecified, the Detect or assumes th e default subnet mask 255.255.255.255. 2. Choose ENTER . Below is an example of the no ip address co mmand implemen tation: admin@DETECTOR-conf-zone-scannet# no ip address 192.168.100. ...
-
Cisco Systems OL-6109-01 - page 10
Chapter 4 Z one Configuration Zone Remote Guar d List 4-10 Cisco Traffic Anomaly De tector User Guide OL-6109-01 This section contains the following procedures: • Adding a Guard to the Zone Remo te Guard List • Removing a Guard from the Zone Remote Guard List • Interacti ve Recommendations Mode Adding a Guard to the Zone Remote Guard List The ...
-
Cisco Systems OL-6109-01 - page 11
4-11 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Remote Guard List Where remote-guard-address specifies the remote Guard IP address. Use ‘*’ to remov e all remote Guards from the remote Guard li st. Caution The user should verify that the Detector has at least one remote Guard on it s default remot e ...
-
Cisco Systems OL-6109-01 - page 12
Chapter 4 Z one Configuration Zone Traffic Learning 4-12 Cisco Traffic Anomaly De tector User Guide OL-6109-01 T o create a ne w zone with interacti ve recommendations mod e perform the follo wing: 1. From the Conf iguration command group le vel type the fol low ing: admin@DETECTOR-conf# zone < new-zone-name > interactive 2. Choose ENTER . Th ...
-
Cisco Systems OL-6109-01 - page 13
4-13 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Traffic Learning The Detector’ s tools for constructing detection policies are the Polic y T emplates. These define the policies according to the Minimum Threshold and Maximum Services parameters the user pro vides (t his chapter will not cov e r those ad ...
-
Cisco Systems OL-6109-01 - page 14
Chapter 4 Z one Configuration Zone Traffic Learning 4-14 Cisco Traffic Anomaly De tector User Guide OL-6109-01 Where zone-name specifies a zone name. Note that the Guard enables the use of an asteri sk (*) as a wildcard denoting either of the follo wing options: – All of the Guard’ s zones. Issuing learning policy-const ruction* means setting t ...
-
Cisco Systems OL-6109-01 - page 15
4-15 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Traffic Learning Accepting Learning Phase 1 – Policy Construction The user may accept the Detector’ s suggested policies. T o accept the results of the initial Po licy Construction phase perform the follo wing: 1. From the Global command gro up level ty ...
-
Cisco Systems OL-6109-01 - page 16
Chapter 4 Z one Configuration Zone Traffic Learning 4-16 Cisco Traffic Anomaly De tector User Guide OL-6109-01 Note that the Detector enables the us e of an asterisk (*) as a wildcard denoting either of th e following opt ions: – All of the Detector’ s zones. Issuing no lear ning* reject means abort ing the learning phase for all o f the Detect ...
-
Cisco Systems OL-6109-01 - page 17
4-17 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Traffic Learning Terminating Learning Phase 2 – Threshold Tuning After a suf ficient period of time (see th e above note) the user ends the Threshol d T uning phase. The user may accept the Detect or’ s suggested policies or decide to abort the second p ...
-
Cisco Systems OL-6109-01 - page 18
Chapter 4 Z one Configuration Zone Traffic Learning 4-18 Cisco Traffic Anomaly De tector User Guide OL-6109-01 Aborting Learning Phas e 2 – Tuning Threshold The user may wish to abort the second phase of learning procedure. In this case the Detector stops the process and erases the data learned on the second phase . The data gathered on the first ...
-
Cisco Systems OL-6109-01 - page 19
4-19 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Detection 2. Choose ENTER . The follo wing (partial sample) screen appears: admin@DETECTOR-conf-zone-scannet# show policies statistics Key Rate Policy 192.168.100.34 73.17 http/80/analysis/syns/dst_ip N/A 0.17 http/80/analysis/syns/global Key Ratio Policy 1 ...
-
Cisco Systems OL-6109-01 - page 20
Chapter 4 Z one Configuration Zone Detection 4-20 Cisco Traffic Anomaly De tector User Guide OL-6109-01 Note that the Detector enables the us e of an asterisk (*) as a wildcard denoting either of th e following opt ions: – All of the Detector’ s zones. Issuing detect * means be ginning detection for all of the Detector’ s zones. – A wildcar ...
-
Cisco Systems OL-6109-01 - page 21
4-21 Cisco Traffic Anomaly Dete ctor User Guide OL-6109-01 Chapter 4 Zone Configuration Zone Detection Where: – all-zone —The Detector activ ates the Guard to assume protection over the overall zone whene ver a traff ic abnormality is detected (see this section’ s explanation for further details). – only-dest-ip —The Detector acti vates t ...
-
Cisco Systems OL-6109-01 - page 22
Chapter 4 Z one Configuration Zone Detection 4-22 Cisco Traffic Anomaly De tector User Guide OL-6109-01 The sample screen indicates that zone tr aff ic is mirrored (or split), the Detector receiv es the zone’ s traff ic and the traff i c shows normal flo w fluctuations. Zone detection is functio ning properly . Ending the Zone Detection The user ...
Cisco Systems OL-6109-01についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもCisco Systems OL-6109-01の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCisco Systems OL-6109-01で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。