-
Kenwood KAC-7251 - page 1
KA C-7251 KA C-7201 © PRINTED IN CHINA B64-2569-00/00 (KV/EV) POWER AMPLIFIER 7 page 2-13 INSTR UCTION MANU AL AMPLIFICATEUR DE PUISSANCE 7 page 14-25 MODE D’EMPLOI AMPLIFICADOR DE POTENCIA 7 página 26-37 MANU AL DE INSTR UCCIONES Take the time to read through this instruction manual. Familiarity with installation and operation procedures will ...
-
Kenwood KAC-7251 - page 2
2 English Safety precautions To prevent injury or fire, take the following precautions: •W hen extending the ignition, battery, or ground wires, make sure to use automotive- grade wires or other wires with a 5 mm 2 (AWG 10) or more to prevent wire deterioration and damage to the wire coating. • To prevent a short circuit, never put or leave any ...
-
Kenwood KAC-7251 - page 3
English 3 Installation • Do not install in the below locations; (Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air) • Do not install the unit under the carpet. Otherwise heat build ...
-
Kenwood KAC-7251 - page 4
4 English Controls / Indicator 12 3 45 (W) 20 40 10 1 LPF FREQUENCY control Sets the cutoff frequency when the FILTER switch is set to LPF. 2 FILTER switch This switch allows to apply high-pass or low-pass filtering to the speaker outputs. • HPF (High-Pass Filter) position: Only frequencies of 150 Hz or higher are output. (Frequencies below 150 H ...
-
Kenwood KAC-7251 - page 5
English 5 7 Power indicator When the power is turned on, the Power indicator lights. If the Power indicator does not light when the power is turned on, the protection function may be activated. Check whether there is any indication of trouble. ■ The protection function is activated in the following situations: This unit is equipped with a protect ...
-
Kenwood KAC-7251 - page 6
6 English Connection 30 30 89 0 ! @ ^ & $% # 8 Fuse (30 A × 2) 9 Battery terminal 0 Ground terminal ! Power control terminal Controls the unit ON/OFF. Controls the unit power. Be sure to connect it with all the systems. @ Speaker output terminals • Stereo Connections: When you wish to use the unit as a stereo amplifier, stereo connections ar ...
-
Kenwood KAC-7251 - page 7
English 7 ■ Installation procedure Since there are large variety of settings and connections possible according to applications, read the instruction manual well to select the proper setting and connection. 1. Remove the ignition key and disconnect the negative - terminal of the battery to prevent short circuits. 2. Set the unit according to the ...
-
Kenwood KAC-7251 - page 8
$ & # GND # ^ CENTER UNIT (CD receiver, etc.) Left input Right input RCA cable ground terminal 8 English RCA cable* Connection Power control wire (Blue/ White) ■ RCA cable or Speaker level input connection Genuine-accessory car stereo (No line output center unit etc.) ACC Battery Car fuse box White White/Black Gray Gray/Black Left Right Cable ...
-
Kenwood KAC-7251 - page 9
30 30 30 30 @ @ @ English 9 ■ Speaker wire connection Lead terminal* (Stereo Connections) Left speaker Right speaker (Bridged Connections) Speaker (Bridged) 30 30 90 ! Battery Ground wire* Battery wire* Protective Fuse* Lead terminal* ■ Power wire connection * Commercially available parts Extension wire* Terminal cover KAC-7251/7201(KE) 1Englis ...
-
Kenwood KAC-7251 - page 10
10 English System examples L R L R L R L R L R L R L R L R L R L R L R LINE OUT ¡ ¡ ™ ™ ¡ ™ ¡ ™ 23 4 23 4 23 4 23 4 CENTER UNIT ■ 2-channel system ■ High-power 2-channel system Right speaker Left speaker Right speaker (Bridged) Left speaker (Bridged) ■ 2-channel + Subwoofer system Subwoofer (L + R) (Bridged) CENTER UNIT CENTER UNI ...
-
Kenwood KAC-7251 - page 11
English 11 L R L R L C C 23 4 ■ Tri-mode CENTER UNIT (High pass) Subwoofer (L + R) (Bridged) ● Principle of Tri-mode Method of frequency band division using a coil and capacitor…in case of 6dB/oct. slope L C 0 dB -3 dB Coil (L): Passes low frequencies and blocks high frequencies. (Low pass) Capacitor (C): Passes high frequencies and blocks lo ...
-
Kenwood KAC-7251 - page 12
12 English Tr oubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM POSSIBLE CAUSE SOLUTION No sound. (No sound from one side.) (Blown fuse.) The output level is too small (or too large) ...
-
Kenwood KAC-7251 - page 13
English 13 Specifications Specifications subject to change without notice. Audio Section Max Power Output ............................................................................................................80 0 W × 1 Rated Power Output Normal (4 Ω ) (20 Hz – 20 kHz, 0.08 % THD) .......................................................... ...
Kenwood KAC-7251についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもKenwood KAC-7251の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがKenwood KAC-7251で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。