M&S Systems dmc1の取扱説明書

16ページ 1.52 mb
ダウンロード

ページに移動 of 16

Summary
  • M&S Systems dmc1 - page 1

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 1 dmc1 Finish-Out Instructions ...

  • M&S Systems dmc1 - page 2

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 2 Introduction Designed for installation in new home, the dmc1 is a whole-house music communications system. It is designed to provide years of enjoyment and service to the homeowner. M&S audio products are backed with more than 50 years of experience in the design and manufacture ...

  • M&S Systems dmc1 - page 3

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 3 Impor tant Safety Instr uctions READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR USIN G THE DMC1 SYSTEM FOR CONTINUED PROTECTION AGAINST RISK OF FIRE REPLACE THE FUSE IN THE POWER SWITCH MODULE ONLY WITH SAME TYPE 6 AMP, 120 VOLT FUSE. THE dmc1 MUST BE INSTALLED BY A M&S SYST ...

  • M&S Systems dmc1 - page 4

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 4 The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of shock to persons. The exclamation ...

  • M&S Systems dmc1 - page 5

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 5 • Do not over-tighten the screws for the remote stations or the master as the plastic face panels may crack or strip out. • Use only M&S Systems certified re placement parts and have them installed by an M&S Systems deal er or installer. Unauthorized substitutions can res ...

  • M&S Systems dmc1 - page 6

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 6 Connect each colored conductor to its respective screw terminal. The screw terminals are marked with th e appropriate wire colors. Note: Some screw terminals have more th an one wire connected to them. Mount each room station to its mounting ring using the two screws provided with ea ...

  • M&S Systems dmc1 - page 7

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 7 Satellite Volume Control MVC1 Series At each MVC1 location strip approx imately 4 inches of jacket from wires and separate colored conductors from each other. Connect drain wires together from both cables using a wire nut. Wire nut each colored conductor to its respective wire as sho ...

  • M&S Systems dmc1 - page 8

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 8 Door Stations At each door station loca tion, strip approximately 4 inches of jacket from wi re and separate colored conductors from one another. Strip ½ inch of insulation from conductors as shown in figure 1. Cut each shield drain wire at ja cket to prevent them from touching each ...

  • M&S Systems dmc1 - page 9

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 9 Important: Verify all cable run loca tions prior to connecting if they were not labeled at rough-in. Inco rrectly connecting cables to the master, room stations or door stat ions may result in system damage. Install the optional chime module MC3 or MC8 in the wall housing by pressing ...

  • M&S Systems dmc1 - page 10

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 10 Connect each yellow wire to a note selection terminal. (Do not connect more than one yellow wire per note terminal.) Plug in the modular chime plug to the 4 pin connector labeled as CHIME on the dmc1 master unit as shown in figure 10. Antenna Connection Connect the FM dipole twin le ...

  • M&S Systems dmc1 - page 11

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 11 may result in poor range of the wi reless remote control system. Connect the wire harness from the MCRC to the connector labeled REMOTE on the master as shown in figure 10. Door Release Connection To use of the DRW door release, connect the VM127X cables from the remote power transf ...

  • M&S Systems dmc1 - page 12

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 12 Satellite Speakers At each speaker location, strip approx imately 4 Inches of jacket from the MS2SXSC cables and separate the colo red wires from each other. Strip 1/2 Inch of insulation fr om each wire. Connect the MS2SXSC cable to the speake r as show n in figure 8. NOTE: The bare ...

  • M&S Systems dmc1 - page 13

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 13 dmc1 fro m dm c 1 marked locations with the screws pr ovided as shown in figure 17. F AILURE TO PROPERLY MOUNT THE AMPLIFIER MAY LEAD TO AM PLIFIER DAMAGE AND / OR VOLUME CONTROL / PREAMP W IRING DAMAG E . dmc1 Connection Locate the MS7X5SC cable from the dmc1 master. Connect each o ...

  • M&S Systems dmc1 - page 14

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 14 Stereo/Mono Configuration Each MC960PA remote amplifier is equipped with a stereo/mono select jumper. All MC960PA amp lifiers are shipped from the factory with this jumper in the STEREO position. If an amplifier is required to drive more than 10 monaural speakers, this jumper must b ...

  • M&S Systems dmc1 - page 15

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 15 Powering Up The dmc1 After all connections have been made , insert the power plug into the transformer and secure the master to the wall housing using the 2 screws provided. If using the dmc1F frame with a dmc1CD player, install the master unit over the frame. Do not ov er tighten t ...

  • M&S Systems dmc1 - page 16

    dmc1 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 16 M&S Systems 2-Year Warranty M&S Systems wa rrants its products to be free of defects for 2 year s. Except for the AirVac Gold power units. Th e warranty period begins on either (a) the date of purchase or installation date of this product or (b) the date of closing on a new ...

メーカー M&S Systems カテゴリー Speaker System

M&S Systems dmc1のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- dmc1の取扱説明書
- M&S Systemsの製品カード
- パンフレット
- またはM&S Systems dmc1の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、M&S Systems dmc1の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、M&S Systems dmc1の取り付け説明書、サービスマニュアル、簡易説明書、またはM&S Systems dmc1のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、M&S Systems dmc1の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

M&S Systems dmc1デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがM&S Systems dmc1を使用するのを助ける技術的文書のことです。説明書は通常、全てのM&S Systems dmc1ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

M&S Systemsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. M&S Systems dmc1の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははM&S Systems dmc1の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。M&S Systems dmc1に関してこのドキュメントで見つけることができる全てのヒントの目次
3. M&S Systems dmc1デバイスの基本機能を使うにあたってのヒント。 M&S Systems dmc1のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。M&S Systems dmc1に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるM&S Systems dmc1のメーカー/サービスへの連絡先に関する情報。

M&S Systems dmc1についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもM&S Systems dmc1の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがM&S Systems dmc1で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)