-
Numark Industries SA3000 - page 1
Owner’s Manual SA3000/SA5500/SA9500 Amplifiers ...
-
Numark Industries SA3000 - page 2
©1997 Numark Industries http://www.numark.com 2 ...
-
Numark Industries SA3000 - page 3
©1997 Numark Industries http://www.numark.com 3 SAFETY FIRST! WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WATER AND ELECTRICITY DO NOT MIX. Keep this unit away from water. If water or other liquids are spilled on or into this unit, unplug the power cord immediately from the wall socket ...
-
Numark Industries SA3000 - page 4
©1997 Numark Industries http://www.numark.com 4 ...
-
Numark Industries SA3000 - page 5
©1997 Numark Industries http://www.numark.com 5 Contents Warning and Safety Instructions 3 Introduction 6 Front-Panel Description 7 Back-Panel Description 8 Audio Terms 10 Hook-up #1: Home Studio Reference Amp 12 Hook-up #2: Mobile DJ Stereo PA 12 Hook-up #3: Monitor Amplifier 13 Hook-up #4: Stereo PA System 13 Specifications 14 Block Diagram 15 W ...
-
Numark Industries SA3000 - page 6
©1997 Numark Industries http://www.numark.com 6 Introduction Thank you for choosing a Performance Series power amplifier from Numark. These units are designed to provide a good combination of power, audio clarity, and reliable operation. The basic circuit has been kept as simple as possible to reduce the amount of components, thereby shortening th ...
-
Numark Industries SA3000 - page 7
©1997 Numark Industries http://www.numark.com 7 Front Panel Description 1. Gain Controls These two knobs are the level controls for each channel of the amplifier. The gain increases as the knob is turned clockwise. The SA5500 features detented gain controls with dB calibrations to simplify set up. 2. Limit LED If an audio signal is amplified beyon ...
-
Numark Industries SA3000 - page 8
©1997 Numark Industries http://www.numark.com 8 Back Panel Description 6. Neutrick Connector Inputs a. Balanced XLR Inputs These combined inputs are commonly used for both mobile and installation set ups. The XLR provide a good combination of ease of connection and resistance to corrosion. They are wired as per the following convention: b. Balance ...
-
Numark Industries SA3000 - page 9
©1997 Numark Industries http://www.numark.com 9 3. ensure that there is only one input signal connected to channel 1 of the amplifier - channel 2 input must be vacant 4. switch the amplifier to bridged mono (back panel switch) 5. turn the gain down and turn on the amp 6. verify operation at low gain, and then increase power to desired level, ensur ...
-
Numark Industries SA3000 - page 10
©1997 Numark Industries http://www.numark.com 10 Audio Terms Gain This is the factor by which an input signal is amplified (increased) or attenuated (reduced) when passing through an amplifier. Gain is generally measured in decibels (dB) which is a logarithmic ratio of input to output. Unity or zero gain means that the signal comes out at the same ...
-
Numark Industries SA3000 - page 11
©1997 Numark Industries http://www.numark.com 11 The variable resistor is to ensure an impedance balance between the positive and negative inputs, and should be adjusted until any hum is at a minimum. Balanced lines are also the most effective means of reducing or eliminating RF or ‘radio frequency interference’. Long unbalanced cable runs are ...
-
Numark Industries SA3000 - page 12
©1997 Numark Industries http://www.numark.com 12 Hook up #1 Home Studio Reference Amplifier outputs AMPLIFIER OUTPUTS + - AMPLIFIER INPUTS + - - + GND CH-2 CH-1 CH-2 CH-1 reference monitors Numark amplifier mixer power CH-2 CH-1 Hook up #2 Mobile DJ Stereo PA main outputs AMPLIFIER OUTPUTS + - AMPLIFIER INPUTS + - - + GND CH-2 CH-1 CH-2 CH-1 speak ...
-
Numark Industries SA3000 - page 13
©1997 Numark Industries http://www.numark.com 13 Hook up #3 Monitor Amplifier (in bridged mono) Zone/Booth send AMPLIFIER OUTPUTS + - AMPLIFIER INPUTS + - - + GND CH-2 CH-1 CH-2 CH-1 monitor speaker Numark amplifier mixer power CH-2 CH-1 Hook up #4 Stereo PA System AMPLIFIER OUTPUTS + - AMPLIFIER INPUTS + - - + GND CH-2 CH-1 CH-2 CH-1 inputs outpu ...
-
Numark Industries SA3000 - page 14
©1997 Numark Industries http://www.numark.com 14 Specifications SA9500 SA5500 SA3000 Frequency response (8 ohms , 20Hz - 20kHz @ 1 W) +0, -1dB +0, -1dB +0, -1dB Total harmonic distortion 0.1% 0.1% 0.1% Signal to noise ratio 102dB 102dB 102dB Slew rate 20V/uS 20V/uS 20V/uS Damping factor >200 >200 >200 Crosstalk 80dB 80dB 80dB Rated power ...
-
Numark Industries SA3000 - page 15
©1997 Numark Industries http://www.numark.com 15 Block Diagrams ch2 outputs ch1 outputs detector short circuit protection detector clip/limit short circuit protection + - + - + - + - + - + - + - + - gnd DC fault thermal power on/off protection stereo bridged mono GS GC amp voltage amp voltage amp current amp current level level protect protect ch1 ...
-
Numark Industries SA3000 - page 16
©1997 Numark Industries http://www.numark.com 16 Professional Disc Jockey Products LIMITED WARRANTY Numark Industries, LLC and Numark International, Inc. (hereafter “Numark”) warrants each new amplifier manufactured and/or supplied by it to be free from defects in material or workmanship under conditions of normal use and service for 3 years, ...
Numark Industries SA3000についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもNumark Industries SA3000の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがNumark Industries SA3000で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。