Dynex 5232IMの取扱説明書

19ページ 0.42 mb
ダウンロード

ページに移動 of 19

Summary
  • Dynex 5232IM - page 1

    CD-WRITER 5232IM CD-ReWritable Drive User’s Manual ...

  • Dynex 5232IM - page 2

    DANGER INVISIBLE LASER RADIATION WHEN O PEN AVOID DIRECT EXPOSURE TO BEAM VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN ATTENTION RADIATIO N DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYO NS. Copyright Statement It is a criminal offence, under applicabl e copyright law s, ...

  • Dynex 5232IM - page 3

    FCC Compliance Statement This device complies with Part 15 of the FCC Ru les. Operation is subject to the following two condit ions: 1. this device ma y not cause harmful i nterference, and 2. this device must accept any interferen ce received, including interference that may cause undesired operat ion. FCC Warning Statement This equipm ent has bee ...

  • Dynex 5232IM - page 4

    Table of Contents INTRODUCTION 1 S YSTEM R EQUIREMENTS 2 P ACKAGE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWARE I NSTALLATION 4 D RIVER I NSTALLATION 6 Windows Environment 6 S OFTWARE I NSTALLATION 6 Windows Environment 6 CONNECTION & OPERATION 7 F RONT P ANEL 7 R EAR V IEW 8 TECHNICAL DATA 9 TROUBLESHOOTING 12 ...

  • Dynex 5232IM - page 5

    CD-WRITER 5232IM 1 INTRODUCTION CD-WRITER 5232IM is a half-height CD-ReWritable drive of standard IDE interface. It supports maximu m 52X speed writing ability on CD-R discs, 32X speed on CD-RW discs and 52X speed reading performance. The drive backs up all writing modes and different CD formats and it automatically recognizes the media pl aced in ...

  • Dynex 5232IM - page 6

    CD-WRITER 5232IM 2 System Requirements For IBM compatible PCs, the system requirements recommended are as follows: ♦ PC sufficient to run Windows 98/ME/2000/XP ♦ Pentium II 350MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦ IDE host interface suppor ...

  • Dynex 5232IM - page 7

    CD-WRITER 5232IM 3 INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four dev ices, but it is recommended that you separate IDE ports for your hard drive and your CD-ReWritable drive. This will ensure that y our ...

  • Dynex 5232IM - page 8

    CD-WRITER 5232IM 4 You may consider one of the two ways recommended below to connect your drive. ♦ To get the most stable performance for the CD-RW drive to write: Primary IDE Master: Hard Disk Primary IDE Slave: CD-ROM Drive Secondary IDE Master: CD-RW drive ♦ For best hard disk performance: Primary IDE Master: Hard Disk Secondary IDE Master: ...

  • Dynex 5232IM - page 9

    CD-WRITER 5232IM 5  The red-edge of the IDE Cable must be connected to Pin 1 on the CD- ReWritable drive. 5. If you have a sound card that can be connected to this CD- ReWritable drive, you can connect the drive (as Audio-out) and the sound card (as Audio-in) with a 4- pin audio cable. (See figure above.) If your mainboad is integrated with buil ...

  • Dynex 5232IM - page 10

    CD-WRITER 5232IM 6 Driver Installation Windows Environment CD-WRITER 5232IM is a PnP device, and Windows 98/ME/2000/XP can automatically detect the drive and load the appropriate driver. If Windows cannot detect the driv e, you can operate manually: 1. Click the Control Panel Icon in My Computer and then click Add New Hardw are . The Add New Hardwa ...

  • Dynex 5232IM - page 11

    CD-WRITER 5232IM 7 CONNECTION & OPERATION Front Panel 12 4 3 1. LED Indicator Flashes “green” while verifying or reading a disc/ writing a CD- R/CD-RW disc. 2. Disc Tray This is the tray for the disc. Pl ace the disc in the tray, then press the Close/Eject button or lightly push the tray to close it. 3. Emergency Eject Hole When the Close/E ...

  • Dynex 5232IM - page 12

    CD-WRITER 5232IM 8 NOTE: The front panel is subject to change wi thout notice. Rear View 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connec t the driv ...

  • Dynex 5232IM - page 13

    CD-WRITER 5232IM 9 TECHNICAL DATA Performance Transfer rate Read : CD-ROM/CD-R: 7800kb/s (up to 52X) CD-RW: 6000kb/s (up to 40X) Write: CD-R 7800kb/s (up to 52X) CD-RW 4800kb/s (up to 32X) Access time 100ms at ⅓ stroke(52X CD-ROM) 180ms at full stroke(52X CD-ROM) 120ms at ⅓ stroke (52X CD-RW) 200ms at full stroke (32X CD-RW) Data buffer 2MB CD ...

  • Dynex 5232IM - page 14

    CD-WRITER 5232IM 10 Form factor 5.25" Half Height Disc loading Tray (motorised) Audio output level Line out = 0.6 ± 10%Vrms Headphone out = 0.6± 10%Vrms Power 5 VDC & 12VDC Dimensions Height 41.8 ± 0.2 mm Width 148.6 ± 0.3 mm Depth 177.0 ± 0.3mm Weight 1 kg Disc Specification Capacity 120mm disc: 74min 650MBytes Mode-1 80min 700MBytes ...

  • Dynex 5232IM - page 15

    CD-WRITER 5232IM 11 Environment Temperature Operating 5°C to 45°C Non-operating -20°C to 60°C Humidity Operating 8% ~ 80%RH Non-operating 5% ~ 95%RH ...

  • Dynex 5232IM - page 16

    CD-WRITER 5232IM 12 TROUBLESHOOTING To help you get more familiar with CD-WRITER 5232IM, the following FAQ lists some common problems you might encounter. Please read it for reference before you request RM A support from your dealer. Q1. CD-WRITER 5232IM cannot be recognized. (1) The drive might not be connected properly. Please check whether the I ...

  • Dynex 5232IM - page 17

    CD-WRITER 5232IM 13 (1) Please check if the audio cable is connected to the audio connector properly. (2) Check both rear side of the CD-RW drive and sound card on M/B (If Audio chipset is on board). If they are well connected, check if the sound card is working. Q7. The tray cannot be ejected. There are two possible reasons: (1) Need to be ejected ...

  • Dynex 5232IM - page 18

    CD-WRITER 5232IM 14 (4) Increase main memory capacity. (5) Select other burning software. (6) De-fragment the hard disk. (7) Keep the source & destination discs clean. (no scratches, fingerprints or contamination.) (8) Copy data as image file to hard drive to avoid buffer underrun. (9) Keep the system clean. Do not install redundant driver or a ...

  • Dynex 5232IM - page 19

    3100552360 Version 1.0 March 2004 ...

メーカー Dynex カテゴリー Computer Drive

Dynex 5232IMのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 5232IMの取扱説明書
- Dynexの製品カード
- パンフレット
- またはDynex 5232IMの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Dynex 5232IMの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Dynex 5232IMの取り付け説明書、サービスマニュアル、簡易説明書、またはDynex 5232IMのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Dynex 5232IMの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Dynex 5232IMデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがDynex 5232IMを使用するのを助ける技術的文書のことです。説明書は通常、全てのDynex 5232IMユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Dynexの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Dynex 5232IMの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははDynex 5232IMの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Dynex 5232IMに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Dynex 5232IMデバイスの基本機能を使うにあたってのヒント。 Dynex 5232IMのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Dynex 5232IMに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるDynex 5232IMのメーカー/サービスへの連絡先に関する情報。

Dynex 5232IMについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもDynex 5232IMの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDynex 5232IMで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)