AEG 222Dの取扱説明書

20ページ 0.65 mb
ダウンロード

ページに移動 of 20

Summary
  • AEG 222D - page 1

    222 D Fume Extractor Hood Installation and Operating Instructions ...

  • AEG 222D - page 2

    2 Printed on recycled paper. AEG  putting words into action. ...

  • AEG 222D - page 3

    3 Contents Introduction 4 Extraction mode 4 Recirculation mode 5 Electrical connections 6 Technical details 7 Installation 8 Safety warnings for kitchen unit installer 8 Wall unit mounting 10 Wall mounting 1 1 Hood operation 12 Safety warnings for user 13 Maintenance and care 14 Opening the grid 14 Grease filter 14 Carbon filter 15 Changing the lig ...

  • AEG 222D - page 4

    4 2 Introduction Extraction mode ● The hood is supplied as an extractor unit and can also be used with a filtering function by fitting activated carbon filters (available as an accessory). ● The unit features two outlet holes, one of which A is located on the top of the unit while the other B is located on the rear. ● To connect up the hose, ...

  • AEG 222D - page 5

    5 ● Move the lever L to position A  Fig. 3 . ● When connecting up the hood using a telescopic wall pipe, you should use an uninflammable outlet hose ABS 120 (120 mm Ø) available as an accessory. Recirculation mode ● The air is filtered and recirculated through the front grid. ● Move the lever L to position F  Fig. 3 . You will need a ...

  • AEG 222D - page 6

    6 Electrical connection 220-240 V - using fixed power supply line with plug. (The unit should only be connected up by an authorized electrician). Your appliance must be connected to fixed wiring via the use of a double pole swiched fused spur outlet with or without pilot lamp. We strongly recommend the appliance is connected by a qualified electric ...

  • AEG 222D - page 7

    7 Technical details Dimensions Height x Width x Depth (in cm) 13 x 59,9 x 51 Weight N e t : 6,9 kg Gross: 7, 8 k g Maximum absorbed power: 205 W Motor absorption 1 x 125 W Lighting: 2 x 4 0 W Length of the cable: 110 cm Fan powers (speed), speed in compliance with DIN 44971 Extraction mode Speed 1 115 m 3 /h Speed 2 145 m 3 /h Speed 3 180 m 3 /h In ...

  • AEG 222D - page 8

    8 Installation Safety warnings for kitchen unit installer ● When used as an extractor unit, the hood must be fitted with a 120mm diameter hose. ● If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr.- 610 899 004 (Ø 120 mm) which is one of our optional pa ...

  • AEG 222D - page 9

    9 ● The national decree on fuel-burning systems specifies a maximum depression of 0.04 bar in such rooms. ● Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approxi- mately 500-600 cm 2 large to avoid the possib ...

  • AEG 222D - page 10

    10 Wall unit mounting ● Make the holes on the bottom of the cupboard, using the drilling template . ● From inside the cupboard, insert the 4 supplied screws and tighten them in the appropriate holes on the appliance.  Fig. 4. 4 ...

  • AEG 222D - page 11

    11 Wall mounting ● Fix the drilling template to the wall. ● Make 3 Ø 8mm holes in the wall 2 at points I , 1 as desired at points L . ● Insert the three Ø 8mm expansion plugs into the wall. ● Insert 2 5x45 screws at points I but do not tighten them completely. ● Adjust the unit so that it is positioned at a right angle to the wall by tu ...

  • AEG 222D - page 12

    12 Hood Operation ● The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. The control switches are located on the units fro ...

  • AEG 222D - page 13

    13 ● Never leave a cooking hob or ring on without a pot or pan on top of it, to avoid the possibility of excess heat damaging the unit. Gas, oil in particular should never be left uncovered. ● Special care should be taken when using deep fat fryers since the oil in them can overheat and burst into flames. ● The risk of a fat fire increases wh ...

  • AEG 222D - page 14

    14 6 Maintenance and care ● The hood must always be disconnected from the mains power supply before beginning any maintenance work. Opening the grid ● Open the latch L and swing the grille downwards.  Fig. 6. ● To remove the grid, pull it forwards from the right and release it. Grease filter ● The purpose of the grease filters is to aspi ...

  • AEG 222D - page 15

    15 8 Removing the filter Open the grid and remove the stops M to take out the filter. See Fig. 7. Carbon filter ● The activated carbon filter should only be used if you want to use the hood in its filtering function. ● To do this you will need an original AEG activated carbon filter (see special accessories). ● This filter cannot be cleaned o ...

  • AEG 222D - page 16

    16 Warning ● Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. Changing the light bulb ● Disconnect the unit from the mains power supply. ● Remove the grid. ● Replace the old light bulb with a new light bulb (40 W m ...

  • AEG 222D - page 17

    17 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working Chec k that: effectively.. The fan speed is set high eno ...

  • AEG 222D - page 18

    18 Service and spare parts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Y our call will be automatically routed to the Service Centre covering your post code area. For the address of your local Service Force Centre and further infor ...

  • AEG 222D - page 19

    19 ...

  • AEG 222D - page 20

    LI02GB Ed. 05/02 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http:/ /www .aeg.hausgeraete.de © Copyright by AEG ...

メーカー AEG カテゴリー Ventilation Hood

AEG 222Dのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 222Dの取扱説明書
- AEGの製品カード
- パンフレット
- またはAEG 222Dの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、AEG 222Dの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、AEG 222Dの取り付け説明書、サービスマニュアル、簡易説明書、またはAEG 222Dのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、AEG 222Dの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

AEG 222Dデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAEG 222Dを使用するのを助ける技術的文書のことです。説明書は通常、全てのAEG 222Dユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

AEGの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. AEG 222Dの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAEG 222Dの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。AEG 222Dに関してこのドキュメントで見つけることができる全てのヒントの目次
3. AEG 222Dデバイスの基本機能を使うにあたってのヒント。 AEG 222Dのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。AEG 222Dに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAEG 222Dのメーカー/サービスへの連絡先に関する情報。

AEG 222Dについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAEG 222Dの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAEG 222Dで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)