Ultra Start 440の取扱説明書

12ページ 1.85 mb
ダウンロード

ページに移動 of 12

Summary
  • Ultra Start 440 - page 1

    FCC/ID Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the ...

  • Ultra Start 440 - page 2

    COMPONENTS - Three Button Remote transmitter’s (430 Series) -Control Module - Four Button Remote transmitter ’s (440 Series) - Plug-in Led - Plug-in V alet Switch (Program Switch) - Multi-T one Siren - 10 Pin Main Harness - Installation Guide - 2 pin Keyless Entry harness - Owners Manual T able Of Contents Page 2 Components Wiring Diagram (With ...

  • Ultra Start 440 - page 3

    Blue Connect to hood and / or trunk pin Hood Input Green Connect to door pin. (-) when opened Door Input Purple Connect to door pin. (+) when opened Door Input Black Connect to chassis ground Ground Input Brown Connect to Siren wire. 2amp Maximum Siren Output Red Connect to constant power . 20amp input 12 V olt Input Y ellow Connect to vehicles ign ...

  • Ultra Start 440 - page 4

    INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 4 Blue Connect to hood and / or trunk pin Hood Input Green Connect to door pin. (-) when opened Door Input Purple Connect to door pin. (+) when opened Door Input Blk/White Dome Light Supervision Output (-) Dome Light Black Connect to chassis ground Ground Input Brown Connect to Siren wire. 2amp Maximum Si ...

  • Ultra Start 440 - page 5

    REMOTE V EHICLE SECURITY INSTALL MANUAL P AGE 5 Recommended Installa tion Pr ocedures White (+) Park lights Park light output. Orange* (-) When Armed Negative output when system is armed. Grey* (-) T runk Release Negative output for trunk release. Y ellow (+) Ignition Input Input from vehicles ignition wire. Red (+) 12V olt Input Constant 12 V olt ...

  • Ultra Start 440 - page 6

    INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 6 Step 3- T est And Adjust The Shock Sensor (see page 3) R ecommended Installation Procedures Basic Install Installing the LED- Choose a location that will be highly visible when the LED is installed. Most vehicles are equipped with knock out panels in the dashboard, these panels are easily removable and ...

  • Ultra Start 440 - page 7

    REMOTE V EHICLE SECURITY INSTALL MANUAL P AGE 7 Changing A Prog rammable Setting Quick View Prog ramming T o Enter Program Mode 1) Make sure ignition is in the off position. 2) Within three seconds turn the key ON the OFF . 3) Press and release the Program Button two times. 4) The siren will chirp and the lights will flash once to confirm. NOTE : I ...

  • Ultra Start 440 - page 8

    INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 8 Enter Program Mode Entering program mode is done by the following steps: 1) Make sure ignition is in the off position. 2) T urn the ignition key ON - OFF , leaving key in the OFF position. 3) Press and release the V alet button two times. 4) The siren will chirp one time to confirm entering program mode ...

  • Ultra Start 440 - page 9

    REMOTE V EHICLE SECURITY INSTALL MANUAL P AGE 9 V oltage / Door Pin Sensing 1 - Enter Program Mode - (Ignition ON-OFF , followed by V alet 2 times) 2 - Press & release transmitter buttons in the following sequence #1 - #1 then #3 3 - The siren will respond with the following: 1 Chirp V oltage Sensing- No Door Pin Connection Needed 2 Chirps Door ...

  • Ultra Start 440 - page 10

    INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 10 T r ansmitter Progr amming Follow the steps below to program the transmitters to the system s memory Step 1 - T urn the Ignition key ON then OFF - Leaving Key Off. Step 2 - Press and release the Program Button twice then press and hold. Step 3 - T he siren will respond with five chirps to confirm T ran ...

  • Ultra Start 440 - page 11

    REMOTE V EHICLE SECURITY INSTALL MANUAL P AGE 11 Arm 1. Press and release the button. 2. The park light s will flash and the siren will chirp one time. 3. The doors will lock (optional). NOTE : The LED will start flashing within five seconds. If installed, the starter disable will activate. Disarm 1.Press and release the button on the remote transm ...

  • Ultra Start 440 - page 12

    87 86 85 87a 30 87 86 85 87a 30 87 86 85 87a 30 87 86 85 87a 30 87 86 85 87a 30 Negative Type Door Loc ks Positiv e Type Door Locks 5 Wire / Re verse Polarity Type Door Loc ks Negative Park Lights- In some cases the park lights may flash erratically after installing the negative park light relay . T o correct this issue add a diode between the coil ...

メーカー Ultra Start カテゴリー Automobile Alarm

Ultra Start 440のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 440の取扱説明書
- Ultra Startの製品カード
- パンフレット
- またはUltra Start 440の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Ultra Start 440の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Ultra Start 440の取り付け説明書、サービスマニュアル、簡易説明書、またはUltra Start 440のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Ultra Start 440の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Ultra Start 440デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがUltra Start 440を使用するのを助ける技術的文書のことです。説明書は通常、全てのUltra Start 440ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Ultra Startの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Ultra Start 440の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははUltra Start 440の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Ultra Start 440に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Ultra Start 440デバイスの基本機能を使うにあたってのヒント。 Ultra Start 440のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Ultra Start 440に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるUltra Start 440のメーカー/サービスへの連絡先に関する情報。

Ultra Start 440についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもUltra Start 440の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがUltra Start 440で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (1)

Vasiliev Anatoly

Периодически загорается красный световой диод под надписью ALARM и звучит звуковой сигнал на передней панели Electroiux ER 3114B. После кратковременного отключения от электросети это прекращается через некоторое время возобновляется вновь. Какая может быть этому причина?