Panasonic AJ-FRC27Eの取扱説明書

22ページ 0.31 mb
ダウンロード

ページに移動 of 22

Summary
  • Panasonic AJ-FRC27E - page 1

    VQT9737 Model No. AJ- E Operating Instructions Frame Rate Con ver ter Before operating this product, please read the instructions carefully and save this manual for future use. ENGLISH DEUTSCH FRANÇAIS IT ALIANO ESP AÑOL ...

  • Panasonic AJ-FRC27E - page 2

    2 (E) indicates safety information FOR U.K. ONLY This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the AST ...

  • Panasonic AJ-FRC27E - page 3

    Contents 3 (E) ENGLISH Operating precautions . . . . . . . . . . . . . . . . .3 F eatures . . . . . . . . . . . . . . . . . . . . . . . . . . .4 System configuration . . . . . . . . . . . . . . . . . .4 P ar ts and their functions . . . . . . . . . . . . . . .5 Basic operations . . . . . . . . . . . . . . . . . . . . .7 Menu selection . . . . . . . ...

  • Panasonic AJ-FRC27E - page 4

    Features 4 (E) System configuration Frame rate conversion function Using the HD-SDI input signals from a variable frame rate camera (AJ-HDC27F) or DVCPRO HD VTR, this unit con- verts frame rates by taking out only the effective frames of variable frame rate recorded clips, recording them, and play- ing them back. It can reproduce the slow or quick ...

  • Panasonic AJ-FRC27E - page 5

    P arts and their functions 5 (E) ENGLISH 1 POWER switch After the unit ’ s operation has been shut down properly, set this switch to the OFF position. If the power is turned off while the unit is operating, the data may be destroyed or the hard disk drive may malfunction. 2 WARNING lamp This flashes when an error or warning has occurred. For deta ...

  • Panasonic AJ-FRC27E - page 6

    P arts and their functions 6 (E) 1 HD SDI IN connector (BNC) The HD SDI signals are supplied to this connector. 2 HD SDI through connector (BNC) The HD SDI input signals are passed straight through the unit and output here. 3 HD SDI OUT connector (BNC) The HD SDI signals are output from this connector. 4 REMOTE IN (RS-422) connector The remote cont ...

  • Panasonic AJ-FRC27E - page 7

    Basic operations 7 (E) ENGLISH Startup 1. Set the power switch to the ON position. P anasonic AJ-FRC27 Now Booting/ 222 ... 05141501 00:00:00:00 720/60P ST OP > 2. The following message appears on the display panel. 3. When startup is completed normally, the following dis- play appears on the display panel. Recording 1. Check that the HD SDI sig ...

  • Panasonic AJ-FRC27E - page 8

    Basic operations 8 (E) Recording (contin ued) 1. Check that the HD SDI signals are being input from the variable frame rate camera. 2. To start recording data, press the REC and PLAY keys. (Both the REC and PLAY lamps light.) 3. To stop the data recording, press the STOP key. (Only the STOP lamp lights.) $ When AUTO REC is set to OFF Auto Rec=ON Op ...

  • Panasonic AJ-FRC27E - page 9

    Basic operations 9 (E) ENGLISH Shutdown 1. In the MENU mode, press the [ 1 ] (right) key to move the cursor to END (shutdown). 2. Press the SET key. 4. Press the SET key. 3. The following message now appears. Select YES. <Note> Keep pressing both the SHIFT key and the [ 2 ] (down) key for more than 2 seconds and a shutdown confirma- tion mess ...

  • Panasonic AJ-FRC27E - page 10

    Menu selection 10 (E) Basic screens 1 and 2 05141501 00:00:00:00 12 35 6 7 1 4 720/60P 2 PLA Y A UT O 1 CLIP ID display The name of the clip currently being output appears here. 2 Time code display The current time code value appears here. During recording, the value of original time code which has been input is displayed; during playback, the valu ...

  • Panasonic AJ-FRC27E - page 11

    Menu selection 11 (E) ENGLISH SETUP screen [CLOCK] <02/04/11 00:00:00> VER screen [VERSION] APP V er .1.02 APP Ver.x.xx Application FRNT Ver.x.xx Front panel (FPGA) PCII Ver.x.xx PCI I/F (FPGA) UPCN Ver.x.xx Format converter (FPGA) DVCC Ver.x.xx DVC control (FPGA) DWNC Ver.x.xx Down-conversion CLOCK: The unit ’ s internal PC clock is set. U ...

  • Panasonic AJ-FRC27E - page 12

    Menu selection 12 (E) HDD screen HDD V er ify ST ART OK? YES NO 1 On this screen, some data is saved into a part of the hard disk drive ’ s memory that is free and then loaded to check that the drive is working properly. <Note> When no clips have been recorded, it takes about 80 min- utes to check that the hard disk drive is working properl ...

  • Panasonic AJ-FRC27E - page 13

    Setup menu 13 (E) ENGLISH Menu item Parameter Description HD PB FMT HD PB RATE 1080/23psf 1080/24psf (Default) 1080/25psf 1080/50i 1080/59i 1080/60i 720/59p 720/60p 24 (Default) 25 30 60 For selecting the output format. <Notes> O 23psf = 23.98psf, 59i = 59.94i O Bear in mind that if the systems for the reference frequency at the camera side a ...

  • Panasonic AJ-FRC27E - page 14

    Setup menu 14 (E) REGEN MODE NORMAL (Default) 24PSync For selecting the time code conversion method. NORMAL: Conversion with no synchronization point (head = 00:00:00:00). 24PSync: With the 25 p output, conversion with the designated syn- chronization point serving as the basic point. Conditions under which 24PSync TC conversion operates normally: ...

  • Panasonic AJ-FRC27E - page 15

    Time code (TC) and user’ s bit (UB) 15 (E) ENGLISH O Recorded clips shot at the 24P frame rate setting must be used. If any other clips are used, the value of the time code which is output will be adversely affected. O Output formats: 1080/25P, 720/25P over 59.94P/60P O Clips: Recording frame rate of 24P O Clips cannot be used in the E-E mode. O ...

  • Panasonic AJ-FRC27E - page 16

    Time code (TC) and user’ s bit (UB) 16 (E) When CONV is selected as the TC REGEN setting, the values of the time code which are output to the display panel, remote controller, SD OUT connector and HD SDI OUT connector may not be the same values in all locations. (See table below) Time code values whic h are output for 1 second f or each output f ...

  • Panasonic AJ-FRC27E - page 17

    Input/output f ormats 17 (E) ENGLISH E-E mode (when the same signals as the input signals are output) O Only format conversion is possible with E-E mode outputs. O The output in the E-E mode is synchronized with the input. This means that, when the input is 60p, the output will always be set to the output format with a frequency whose decimal place ...

  • Panasonic AJ-FRC27E - page 18

    T r oubleshooting 18 (E) Indication Action to be taken Data is not recorded properly. When the unit is set to the recording mode with the power on, a problem occurs with the E-E output during recording. O Check that the internal cooling fans are running properly. O Stop the recording, and shut down the unit. Continue cooling for 10 minutes with the ...

  • Panasonic AJ-FRC27E - page 19

    Err or displa ys 19 (E) ENGLISH Type of error Cause and remedial action RECORD ERROR This appears when data could not be recorded properly when a recording request was processed. Restart the unit. PLAY ERROR This appears when data could not be played back properly when a playback request was processed. Check that clips have been recorded. SHUTTLE E ...

  • Panasonic AJ-FRC27E - page 20

    Specifications 20 (E) Operating temperature: 5 to 35 ˚ C Storage temperature: j 10 to 50 ˚ C Operating humidity: 10% to 80% Storage humidity: 5% to 90% Weight: 15 kg Dimensions: (W k H k D) 210 k 222 k 492 mm Recording time: Min. 40 min. (100 min. with 24P conversion) Compression system: DVCPRO HD (720/60P) Input signal (recording signal) connect ...

  • Panasonic AJ-FRC27E - page 21

    ENGLISH 21 (E) ...

  • Panasonic AJ-FRC27E - page 22

    Panasonic Broadcast Europe Panasonic Broadcast Europe Ltd West Forest Gate, Wellington Road, Wokingham, Berkshire RG40 2AQ U.K. Tel: 0118 902 9200 Panasonic Broadcast Europe GmbH Hagenauer Str. 43, 65203 Wiesbaden-Biebrich Deutschland Tel: 49-611-1816-0 F0702Y1072 @ Printed in Japan E ...

メーカー Panasonic カテゴリー TV Converter Box

Panasonic AJ-FRC27Eのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- AJ-FRC27Eの取扱説明書
- Panasonicの製品カード
- パンフレット
- またはPanasonic AJ-FRC27Eの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Panasonic AJ-FRC27Eの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Panasonic AJ-FRC27Eの取り付け説明書、サービスマニュアル、簡易説明書、またはPanasonic AJ-FRC27Eのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Panasonic AJ-FRC27Eの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Panasonic AJ-FRC27Eデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがPanasonic AJ-FRC27Eを使用するのを助ける技術的文書のことです。説明書は通常、全てのPanasonic AJ-FRC27Eユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Panasonicの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Panasonic AJ-FRC27Eの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははPanasonic AJ-FRC27Eの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Panasonic AJ-FRC27Eに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Panasonic AJ-FRC27Eデバイスの基本機能を使うにあたってのヒント。 Panasonic AJ-FRC27Eのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Panasonic AJ-FRC27Eに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるPanasonic AJ-FRC27Eのメーカー/サービスへの連絡先に関する情報。

Panasonic AJ-FRC27Eについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもPanasonic AJ-FRC27Eの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPanasonic AJ-FRC27Eで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)