-
Vulcan-Hart 7800 - page 1
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791 SER VICE AND P AR TS MANUAL FOR H SERIES HEA VY DUTY GAS RANGES FORMERL Y 7800 AND SG7800 SERIES FORM 30555 (2-91) ...
-
Vulcan-Hart 7800 - page 2
– 2 – SERVICE & PARTS H SERIES IMPOR T ANT OPERATING, INSTALLING AND SERVICE PERSONNEL Operating information for this equipment has been prepared for use by qualified and/authorized operating personnel. All installation and service on this equipment is to be performed by qualified, certified, licensed and/ authorized installation or service ...
-
Vulcan-Hart 7800 - page 3
– 3 – H SERIES SERVICE & PARTS DESCRIPTION P A GE DEFINITIONS OF PERSONNEL (OPERATING, INSTALLATION & SERVICE) Inside Front Cover INDEX 3 TROUBLESHOOTING (PROBLEMS AND CAUSES) 4 LIGHTING AND SHUTTING DOWN PILOT BURNERS 5, 6 PILOT BURNER ADJUSTMENTS 7 STANDARD OVEN TEMPERATURE CONTROL RECALIBRATION 8 CONVECTION OVEN TEMPERATURE CONTROL R ...
-
Vulcan-Hart 7800 - page 4
– 4 – SERVICE & PARTS H SERIES TROUBLESHOOTING PROBLEM PROBABLE CAUSES OVEN TOO MUCH BOTTOM HEAT INSUFFICIENT HEAT INPUT. OVERACTIVE FLUE. UNEVEN BAKE TOO LOW TEMPERATURE. IMPROPER OPERATION. SIDE BURNING IMPROPER BYPASS SETTING. FLUCTUATING GAS PRESSURE. TOO MUCH TOP HEAT TOO HIGH TEMPERATURE. FAULTY VENTILATION. EXCESSIVE HEAT INPUT. THER ...
-
Vulcan-Hart 7800 - page 5
– 5 – H SERIES SERVICE & PARTS LIGHTING AND SHUTTING DOWN PILOT BURNERS NOTE: All adjustment procedures associated with pilot lighting must be performed by an authorized Vulcan-Hart installation or service person. The bypass (minimum burner) flame adjustment must be made at the time the appliance is installed. OPEN TOP BURNERS 1. Turn main ...
-
Vulcan-Hart 7800 - page 6
– 6 – SERVICE & PARTS H SERIES LIGHTING AND SHUTTING DOWN PILOT BURNERS (Cont.) STANDARD OVEN PILOT NOTE: Before lighting oven, be sure that range top sections have been lit. 1. Open oven door and lift up the pilot lighting hole cover. 2. Light oven pilot by depressing red reset button (Fig. 1) located on the side control panel above the th ...
-
Vulcan-Hart 7800 - page 7
– 7 – H SERIES SERVICE & PARTS PILOT BURNER ADJUSTMENTS NOTE: All pilot adjustments are to be performed only by certified Vulcan service representatives. OPEN TOP BURNER PILOT ADJUSTMENTS TOOLS: Standard screwdriver. After pilot is lit, turn the open top burner(s) ON. Adjust the flame if necessary. To adjust, rotate the pilot valve adjustme ...
-
Vulcan-Hart 7800 - page 8
– 8 – SERVICE & PARTS H SERIES TEMPERA TURE CONTROL RECALIBRA TION STANDARD OVEN TEMPERATURE CONTROL RECALIBRATION Field recalibration is seldom necessary and should not be resorted to unless experience with cooking results definitely proves that the control is not maintaining the set temperature. To check oven temperatures when recalibrati ...
-
Vulcan-Hart 7800 - page 9
– 9 – H SERIES SERVICE & PARTS A UT OMA TIC SHUT OFF PILO T INSTR UCTIONS CLEANING To clean limiting orifice (Fig. 7), turn gas supply to unit OFF. Disconnect pilot tubing at the pilot burner body. The orifice is then accessible at the body end of the pilot burner and can be removed for cleaning. Clean spud, taking care not to enlarge the o ...
-
Vulcan-Hart 7800 - page 10
– 10 – SERVICE & PARTS H SERIES REPLA CEMENT P AR TS LIST WARNING ALL SERVICE PERSONNEL WHEN SERVICING THIS EQUIPMENT, USE ONLY CERTIFIED CONTROLS DUPLICATING THOSE ORIGINALLY SUPPLIED ON THIS EQUIPMENT BY VULCAN-HART COMPANY. DO NOT SUBSTITUTE COMPONENTS WITH DIFFERENT MODEL NUMBERS. DO NOT SUBSTITUTE COMPONENTS WITH DIFFERENT MANUFACTURIN ...
-
Vulcan-Hart 7800 - page 11
– 11 – H SERIES SERVICE & PARTS REPLA CEMENT P AR TS LIST H SERIES RANGE REPLACEMENT PARTS LIST ALL UNITS WITH OVENS ITEM NUMBERS REFER TO REPLACEMENT PARTS DRAWING AND PHOTOS OF INSERT B & A Item Std. Oven Conv. Oven Description Remarks Part Numbers Part Numbers (Formerly SG 7800) (Formerly 7800) 1 407798-4 407798-4 Safety Valve 2 4075 ...
-
Vulcan-Hart 7800 - page 12
– 12 – SERVICE & PARTS H SERIES REPLA CEMENT P AR TS LIST (Cont.) 29 409433-1 409433-1 Top Aeration Plate H45 30 409432-1 409432-1 Top Grate H45 31 409416-1 409416-1 Burner Venturi (Lower) H45 31.1 409417-1 409417-1 Burner Head (Top) H45 32 402077-2 402077-2 Top Burner Valve H60 33 FP86-44 FP86-44 Elbow H60 34 408379-2 408379-2 Top Burner V ...
-
Vulcan-Hart 7800 - page 13
– 13 – H SERIES SERVICE & PARTS REPLA CEMENT P AR TS LIST (Cont.) 57 414001-1 Air Director N.S. 58 413990-G1 Fan Cover Assembly N.S. 59 415780-7 Fan N.S. 60 413994-1 Motor N.S. 62 413773-1 413773-1 Top Grate H56, H54, H53-72 63 413787-1 413787-1 Nozzle Extension H56, H54 64 411496-B1 On/Off Switch N.S. 65 411496-E4 Warning Light N.S. 66 405 ...
-
Vulcan-Hart 7800 - page 14
– 14 – SERVICE & PARTS H SERIES REPLA CEMENT P AR TS LIST (Cont.) 80 415248-1 415248-1 Pilot Tube, Hot Top H53-72 81 412063-2 412063-2 Top Pilot H54, H53-72 82 414038-1 414038-1 Hot Top Burner H53-72 83 414064-1 414064-1 Rear Burner Support H53-72 84 414282-1 414282-1 Hot Top H53-72 85 414072-1 414072-1 Rear Baffle H53-72 86 414067-G1 41406 ...
-
Vulcan-Hart 7800 - page 15
– 15 – H SERIES SERVICE & PARTS REPLA CEMENT P AR TS LIST (Cont.) PART NO. DESCRIPTION GAS BURNER ORIFICE Drill Size No. H30 VALVES 402601-A44 Valve, Top Burner Adj. Natural Outer 44 (.086) 402601-F56 Valve, Top Burner Fixed Butane Outer 55 (.052) 402601-F55 Valve, Top Burner Fixed Propane Outer 54 (.050) 402601-A48 Valve, Top Burner Adj. N ...
-
Vulcan-Hart 7800 - page 16
– 16 – SERVICE & PARTS H SERIES REPLA CEMENT P AR TS LIST (Cont.) ITEM DESCRIPTION PART NUMBER PART NUMBER STD.OVEN CONV. OVEN (Formally 7800) (Formally SG-7800) A Cover Plate 405817-1 405817-1 B Back Top (H30, H72 Only) (PTD) 409649-1 409649-1 Back Top (H30, H72 Only) (SST) 409649-2 409649-2 B1 Back Top (H45) (PTD) 409650-1 409650-1 Back T ...
-
Vulcan-Hart 7800 - page 17
– 17 – H SERIES SERVICE & PARTS REPLA CEMENT P AR TS LIST (Cont.) INSER T A ...
-
Vulcan-Hart 7800 - page 18
– 18 – SERVICE & PARTS H SERIES REPLA CEMENT P AR TS LIST (Cont.) INSER T B ...
-
Vulcan-Hart 7800 - page 19
– 19 – H SERIES SERVICE & PARTS REPLA CEMENT P AR T PHO T OS H54 ...
-
Vulcan-Hart 7800 - page 20
– 20 – SERVICE & PARTS H SERIES REPLA CEMENT P AR T PHO T OS (Cont.) H54 ...
-
Vulcan-Hart 7800 - page 21
– 21 – H SERIES SERVICE & PARTS REPLA CEMENT P AR T PHO T OS (Cont.) H56 ...
-
Vulcan-Hart 7800 - page 22
– 22 – SERVICE & PARTS H SERIES REPLA CEMENT P AR T PHO T OS (Cont.) H56 ...
-
Vulcan-Hart 7800 - page 23
– 23 – H SERIES SERVICE & PARTS REPLA CEMENT P AR T PHO T OS (Cont.) H53-72 ...
-
Vulcan-Hart 7800 - page 24
– 24 – SERVICE & PARTS H SERIES REPLA CEMENT P AR T PHO T OS (Cont.) H53-72 ...
-
Vulcan-Hart 7800 - page 25
– 25 – H SERIES SERVICE & PARTS REPLA CEMENT P AR T PHO T OS (Cont.) H53-72 ...
-
Vulcan-Hart 7800 - page 26
THIS P AGE INTENTIONALL Y LEFT BLANK ...
-
Vulcan-Hart 7800 - page 27
THIS P AGE INTENTIONALL Y LEFT BLANK ...
-
Vulcan-Hart 7800 - page 28
THIS P AGE INTENTIONALL Y LEFT BLANK ...
Vulcan-Hart 7800についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもVulcan-Hart 7800の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがVulcan-Hart 7800で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。