-
Haier XPB88-LS - page 1
User's manual XPB88-LS T win-tub W ashing Machine with Pump Names of the parts.............the 2 nd cover Safety precautions ...............................1 Installation and adjustment ..................3 Introduction of the major functions .......5 Preparation before washing ................6 The musts in washing .........................7 U ...
-
Haier XPB88-LS - page 2
Before Using Before Using Names of the par ts Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine or injure the personal saf ...
-
Haier XPB88-LS - page 3
Before Using Before Using Safety precautions If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean. Do not put the machine at damp place like the bathroom . Never wash it with water. In case the washing machine is install ...
-
Haier XPB88-LS - page 4
Before Using Before Using Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. T ake special care of the children. Handicapped or children without care shall not use the machine. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not decompose, repair or alter t ...
-
Haier XPB88-LS - page 5
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose Before Using Before Using Installa tion and adjustment Install the lint filter After opening the package,pllease take out the lint filter from the document bag,install it ...
-
Haier XPB88-LS - page 6
Extend the drain hose from the rear side How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. T ake off the drain hose from the cabinet. Take the hose out of the fixing groove. (Se ...
-
Haier XPB88-LS - page 7
Quick water-filling entrance If you do not need spraying spin, you can fill water into the wash tub directly through this entrance. It can reduce the humidity inside the control panel significantly and prolong the operating life of the components. Quick water-filling entrance Using process Using process Intr oduction of the major functions The mach ...
-
Haier XPB88-LS - page 8
Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3. Put the drain hose up to suitable position. 4.Slanting or uneven ground may result in unstable working or abnorma ...
-
Haier XPB88-LS - page 9
Reference weight of the laundries Working suit up,down Jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The thickness ,size , type of ...
-
Haier XPB88-LS - page 10
Selection of the quantity of the washing powder list 1 Selection of the current , water level and washing time list 2 How to use the washing powder How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to ...
-
Haier XPB88-LS - page 11
Washing sequence Figure 1 Figure 2 Figure 3 Figure 5 SPIN WASH Using process Using process Wash DRAIN DRAIN STRONG WASH SELECTOR WASH SELECTOR 1.Water-filling selector (1) Set the water-filling selector at the "WASH" side. (Figure 1) (2) Set the water level adjusting lever to needed line. 2. Fill the water and add the dissolved washing po ...
-
Haier XPB88-LS - page 12
Midway spinning 1. 2. 3. Put the laundries into the spin tub evenly and smoothly. Spin Run the foam-removing spinning. Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland Using process Using process (1) Put the gland in properly. Please put in the gland properly even if the laund ...
-
Haier XPB88-LS - page 13
Rinse with stored water Rinse with water-filing 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use "Standard" current. If you use "Strong&quo ...
-
Haier XPB88-LS - page 14
Selection of the spin time list 3 Laundries Spin time (minutes) About 4~5 Bed sheet or blanket About 2~4 Underwear (knitwear) Swear (chemical fiber) About 1~2 Within 1 minute Blending thin laundries Using process Using process 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and out ...
-
Haier XPB88-LS - page 15
After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. 1 Take of f the overflow filter. As indicated in the figure, nip the elastic fixing claw and pull it to the direction of ...
-
Haier XPB88-LS - page 16
Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty Do not wash it directly by water Using process Using process Cleaning the overflow filter 2. T ake off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow fi ...
-
Haier XPB88-LS - page 17
Trou ble-shooting Ans wers to question When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "WASH SELECTOR" at "STRONG" or "ST ANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to melt. ...
-
Haier XPB88-LS - page 18
Troub le-shooting Ans wers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do ...
-
Haier XPB88-LS - page 19
User's manual One One One One One Water inlet hose Water-filling jointer Gland Lint filter Packing list Twin-tub washing machine One ...
-
Haier XPB88-LS - page 20
Type Model Power source Water level Water quantity about Rated input power W Dimension(mm) Wash pattern Weight kg Injection pressure Rated washing capacity kg Twin-tub washing machine with pump XPB88-LS V~, 50Hz Maximum/43L Medium/36L Minimum/30L 8.0 L740 W428 H936 New current 27 0.02MPa~0.2MPa Rated voltage 220 Rated frequency Wash 380 Spin 180 Sp ...
-
Haier XPB88-LS - page 21
...
-
Haier XPB88-LS - page 22
...
-
Haier XPB88-LS - page 23
...
-
Haier XPB88-LS - page 24
...
-
Haier XPB88-LS - page 25
...
-
Haier XPB88-LS - page 26
...
-
Haier XPB88-LS - page 27
...
-
Haier XPB88-LS - page 28
...
-
Haier XPB88-LS - page 29
...
-
Haier XPB88-LS - page 30
...
-
Haier XPB88-LS - page 31
...
-
Haier XPB88-LS - page 32
...
-
Haier XPB88-LS - page 33
...
-
Haier XPB88-LS - page 34
...
-
Haier XPB88-LS - page 35
...
-
Haier XPB88-LS - page 36
...
-
Haier XPB88-LS - page 37
...
-
Haier XPB88-LS - page 38
...
-
Haier XPB88-LS - page 39
...
-
Haier XPB88-LS - page 40
XPB88-LS ...
Haier XPB88-LSについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもHaier XPB88-LSの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHaier XPB88-LSで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。