-
Locke TRM-3083, TRM-5138, TRM-7192 - page 1
Reel Mower TRM-3083, TRM-5138 TRM-7192 Operators Manual Locke T urf 307 Highway 52E, Opp, Alabam a, 36467, (334) 493-1300 ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 2
CONGRA TULA TIONS Y ou have invested in the best implemen t of its type on the market today . The care you give your Locke T urf implement will greatly determine your satisfaction with it s performance and it s service life. W e urge a careful study of this manual to provide you with a thorough understanding of you new implement before operating, a ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 3
REEL MOWER Operator ’ s Manual T able of Content s SECTION Introduction …………………...…………2,3 Lift Chain Adjustment.…………………...8 Federal Laws and Regulations ………….4 Mowing Unit Belt Adjustment.....………..8 Dealer Preparation Check List…………..5 Mowing…….………………..……………..9 Fe ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 4
INTRODUCTION More than merely devices created fo r mowing grass, the excellence of design, construction and operation of Locke power mowers is unp aral- leled. Introduced in 1928, tested an d proven, Locke power mowers may be considered, in terms of today’ s te chnology , the ultimate response to the need for the highest degree of qua lity lawn c ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 5
Definitions: NOTE: A special point of information related to its preceding topic. The author ’s intention is that you read and note this information before co ntin uing. IMPORTANT: Information, related to its preceding topic, that the author fe els would be of use. Owner Assistance If customer service or repair parts are required con- tact your l ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 6
DEALER PREP ARA TION CHECK LIST REEL MOWER BEFORE DELIVERING MACHINE- The foll owing check list should be completed. Use the Operator ’ s Man- ual as a guide. 1. Assembly completed. 2. Gearbox f illed with oil. 3. All fittings lubricated. 4. All shields in place and in good condition. 5. All fasteners torqued to specifications ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 7
IMPORT ANT FEDERAL LA WS AN D REGULA TIONS* CONCERNING EMPLOYERS, EMPLOYEES AND OPERA TIONS. *(This section is intended to explai n in broad terms the concept and effect of the follo wing federal laws and regula- tions. It is not intended as a legal interpretation of the la ws and should not be consider ed as such.) U.S. Public Law 91-596 (The Will ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 8
and tighten if necessary. 8. Travel slowly over rough terrain and be a lert to holes and gullies 9. When traveling on public roads, use acce ssory lights and devices for adequate warnin g to operators of other vehicles. Comply with all Federa l, State and Local laws. 10. Never operate the Reel Mower while in the raised transport position. 11. Be al ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 9
During Operation 1. Tractor should be equippe d with ROPS and seat belt during operation. 2. Do not allow anyone to operat e this machine who has not been properly trained in its safe operation. 3. Do not allow children to oper ate the implement. 4. Never dismount from a moving tractor. 5. Put tractor in park, tu rn off engine, remove key and allow ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 10
Hook Up 1. Engage Clevis swivel hitch or ball hitch to tractor drawbar using draw bar pin or ball su pplied. IMPORTANT For correct leveling, adjust Reel Mower unit tongue height so that the front and rear jack- shafts are equal distances above ground level. Leveling the Frame – Tongue Adjust- ments The bolt on section of the tongue can be rot ate ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 11
The large (constant velocity U-joint) e nd of th e shaft goes on the tractor’s PTO shaft. NOTE: Refer to page 16 for locations of compo- nents. Belt Idlers – Main Drive Check regularly for correct belt tension, particularly every 5 to 10 hours following installation of new belts. To adjust belt idlers: 1. Remove belt guards. 2. Loosen idler cla ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 12
Mowing 1. Lower the mowing units to the ground. 2. Engage the tractor PTO at low speed to avo id shock to the mower power train. 3. Select appropriate tractor gear range (maxim um 5- 1/2 mph or 8.8 km/h at rated PTO speed). Refer to Clip Ratio on page 11. 4. Accelerate to maximum PTO speed: 500-54 0 rpm. DO NOT ENGAGE THE PTO WITH MOWERS IN THE RAI ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 13
BEDKNIFE HOLDER QUICK HEIGHT ADJUSTER REAR ROLLER REAR ADJUSTING SCREW BEDKNIFE FRONT ADJUST ING SC REW DESIRED CUTTING HEI GHT "A" A ADJUSTING BAR ASSY. 50019946 FRONT ROLLER LOCKNUTS Mowing Height Adjustment To ensure the same height of cut on each m owing unit and that each unit is also cutting level, Adjus t ment Bar part no. 50019946 ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 14
Bed knife to Reel Adjustment A quick check of the spring spacer (Refer to illustra- tion below) is all that is required. To properly set spring spacer, loosen jam nut (A), then turn adjuster screw nut until the spring spacer is “snug” between washers. One should be able to rotate the spring spacer by firmly gripping it. Backlapping In some cond ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 15
Hydraulic Lift Operation Refer to Hydraulic System Schematics. RAISING MOWING UNITS: (TRM 5000 & 7000 ONLY) Pressure is applied to the “lift side of the circuit. Oil passes through the check (lock) valve and restrictor to the rod end port of the hydraulic c ylinder. Maximum normal lift pressure occurs as the two rear mowing units climb the sn ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 16
To Lower the Mowing Unit 1. Make sure the transport safety chain is unhooked and stowed on the left rear lift arm. NOTE Do not attempt to lower the mowing units with the transport safety chain in place, as this may result in damage to the lift system. 2. Place the tractor’s external hydraulics control valve in the “lower” position. Return the ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 17
HYDRAULIC LIFT TROUBLESHOOTING UNITS WILL NOT LOWER 1. Transport safety chain not hooked and Unhook and stow chain. stowed. 2. Quick-disconnects reversed. Reverse couplings. 3. Faulty tractor hydraulic supply. See tractor manual. 4. Check valve pilot not operating. Replace check valve. UNITS WILL NOT RAISE 1.Quick-disconnects reversed. Reverse coup ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 18
Periodic Maintenance After ev ery 40 hours or operation: Grease the following points sparingly: Reel bearings Roller bearings Telescoping arms PTO drive shaft (primary drive) Tie rod ends (#6 and #7 mo wing units) After ev ery 80 hours of ope ration: Grease the following points sparingly: Jackshaft bearings Hitch Tower jack swivel Service the prima ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 19
1 2 3 6 4 7 5 Tongue V-Belt Guards Gearbox PTO Shaft V-Belts Cutting Unit Stabilizer Arm Rear Roller Tire & Wheel Inner Arm Outer Arm PTO Shaft Main Frame Main Component Locations 17 ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 20
HIGH PRESSUR E FLUID HAZARD To prevent serious injury or death from escaping hydrau lic flu id: Visually chec k all hydraulic lines and hoses BEFORE applying pressure. Relieve pres sure on system before repairing, adjusting or disconnecting. Use paper or cardboard, Not BODY PARTS, to check for suspected leaks. WARNING NOTICE TO OWNER An OPERATOR&ap ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 21
50022075 50022077 50022073 50022066 50022078 50022065 50022070 DANGER THROWN OBJECT HAZARD To prevent serious i nj ury or death fro m thrown o bjects: Operate with all guards installed in good condition. Stop operation if bystanders come within several hundred feet. DANGER ROTATING BLADES-KEEP A WAY To prevent serious inj ury or death from rotating ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 22
NOTICE To prevent damage to reel units and / or uneven cutting: Keep frame level CAUTION To Avoid Injury or Machin e Damage from Improper Tire Inflation or Torquing of Wheel Bolts: Maximum in flation pressure o f tires is 35 psi. Torque wheel bolts to 65 lb-ft. Maximum in flation pressure o f tires is 24 psi. Torque wheel bolts to 65 lb-ft. Inflati ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 23
T ORQUE SPECIFICA TIONS Proper torque for American fastene rs used on Locke Turf equipment. Recommended Torque in Foot Pound s (Newton Meters). * WRENCH SIZE (mm) “A” BOLT DIA. (mm) “B” AST M 4.6 AST M 8.8 AST M 9.8 ASTM 10.9 8 5 1.8 (2.4) 5.1 (6.9) 6.5 (8.8) 10 6 3 (4) 8.7 (12) 11.1 (15) 13 8 7.3 (10) 21.1 (29) 27 (37) 16 10 14.5 (20) 42 ( ...
-
Locke TRM-3083, TRM-5138, TRM-7192 - page 24
Locke T urf 307 Highway 52E, Opp, Alabam a, 36467, (334) 493-1300 ...
Locke TRM-3083, TRM-5138, TRM-7192についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもLocke TRM-3083, TRM-5138, TRM-7192の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがLocke TRM-3083, TRM-5138, TRM-7192で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。