Audiovox PRO9801Nの取扱説明書

24ページ 0.51 mb
ダウンロード

ページに移動 of 24

Summary
  • Audiovox PRO9801N - page 1

    128-8483 1 of 24 Page 1 Model PRO9801N Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure ...

  • Audiovox PRO9801N - page 2

    128-8483 2 of 24 Page 2  Protected Push Button LED V alet/Override Switch  7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / V alet / Arming  Intrusion Alert With Memory  Instant Siren Activation When Used  S tarter Disable Output  Additional Engine Immobilizer Output, (Optional Relay Required)  T rue Last Door Arming (H ...

  • Audiovox PRO9801N - page 3

    128-8483 3 of 24 Page 3 known as a code grabber , which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Y our Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the alarm system will n ...

  • Audiovox PRO9801N - page 4

    128-8483 4 of 24 Page 4 ; The dash mounted LED begins to flash slowly . ; Parking Lights flash one time. ; Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing t ...

  • Audiovox PRO9801N - page 5

    128-8483 5 of 24 Page 5 ; Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones. ; Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was installed, the interior light will flash as well fo ...

  • Audiovox PRO9801N - page 6

    128-8483 6 of 24 Page 6 ; Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered. ; Siren will not sound. If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning the key ...

  • Audiovox PRO9801N - page 7

    128-8483 7 of 24 Page 7 3 . T o return to normal operation, press and release the PBLED switch any time the ignition is on. NOTE: Always remember to return the vehicle to the valet off position. This will ensure that the vehicle remains protected at all times. MANUALL Y OVERRIDING YOUR SYSTEM: USING THE PBLED OVERRIDE SWITCH Y our Security System c ...

  • Audiovox PRO9801N - page 8

    128-8483 8 of 24 Page 8 2 . Turn the ignition switch to the on position. 3 . Within 10 seconds, press and release the PBLED switch, 3 times. 4 . Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 5 . Within 10 seconds, begin to press and release the PBLED switch to ...

  • Audiovox PRO9801N - page 9

    128-8483 9 of 24 Page 9 REMOTE P ANIC OPERA TION The Lock or Unlock button on your keychain transmitter also functions as a panic switch for use in emergency situations. T o use remote panic, 1. Press and hold the Lock or Unlock button on the keychain transmitter for 3 or more seconds. The alarm will immediately sound. 2. T o stop the alarm, press ...

  • Audiovox PRO9801N - page 10

    128-8483 10 of 24 Page 10 2. Within 2 seconds of step 1, press and release the ARM button 2 times, to defeat the pre and full detect stages of the shock sensor . (The lights will flash and the siren will chirp twice.) 3. Within 2 seconds of step 1, press and release the ARM button 3 times to enter the "City Mode" of operation. (The lights ...

  • Audiovox PRO9801N - page 11

    128-8483 11 of 24 Page 11 CAUTION! Do not turn the key to the start position. This will cause the starter motor to engage with the already running engine which could result in damage. S tep on the brake pedal to disengage the remote start unit. The vehicle will continue to run but now on it's own power . NOTE: The engine will stop running befo ...

  • Audiovox PRO9801N - page 12

    128-8483 12 of 24 Page 12 OPTIONAL DEVICE OUTPUT ( CHANNEL 3 ) Controlled By: Trunk/Key Button Other Transmitter button configurations are also available. Consult your installa- tion center for other configurations not listed above that may have been pro- grammed to operate a specific feature of your system. This security system is equipped with an ...

  • Audiovox PRO9801N - page 13

    128-8483 13 of 24 Page 13 Other Transmitter button configurations are also available. Consult your installa- tion center for other configurations not listed above that may have been programmed to operate a specific feature of your system. This security system has an additional feature that can be connected to a number of different optional accessor ...

  • Audiovox PRO9801N - page 14

    128-8483 14 of 24 Page 14 time according to the selection during installation. If you do not want the vehicle to continue to run for one cycle, simply step on the vehicle's brake, or release the parking brake, or activate the transmitter's start button two times in succession. Any of these will cause the engine to turn off. TELEMA TIC UPG ...

  • Audiovox PRO9801N - page 15

    128-8483 15 of 24 Page 15 disarmed and the Panic Mode is activated, the lights will flash unlock icon will be displayed and the siren will beep on the LCD screen. When ever the vehicle is operated from the two way transmitter , the unit will beep responsive to the function executed at the vehicle. 1 beep when armed, 2 beeps when disarmed, etc... at ...

  • Audiovox PRO9801N - page 16

    128-8483 16 of 24 Page 16 When the vehicle is armed, and the hood or trunk, is opened or ajar , the trans- mitter will chirp 3 times, the lights will flash, and the display will indicate a hood or trunk trigger as shown on the previous page. When the hood or trunk is closed, or the zone clears, the transmitter will chirp 1 time, and the display wil ...

  • Audiovox PRO9801N - page 17

    128-8483 17 of 24 Page 17 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start. Selection of these and other features are shown below: NOT ...

  • Audiovox PRO9801N - page 18

    128-8483 18 of 24 Page 18 Note this feature must be activated at the vehicle at the prescribed time. Once activated at the vehicle, you can toggle the feature on simultaneously pressing the Lock + Option buttons of the transmitter . The 24 hour icon will appear and the transmitter will emit a tone confirming the feature is active. Note: the unit wi ...

  • Audiovox PRO9801N - page 19

    128-8483 19 of 24 Page 19 Battery Indicator: Y our transmitter has a battery indicator that is shown in the upper right corner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deteriorates, the bars will disap- pear . 1 bar indicates the battery should be replaced. Replace battery with a fresh 1.5V AA ...

  • Audiovox PRO9801N - page 20

    128-8483 20 of 24 Page 20 T emperature S t art Mode. This icon will appear when the temp start mode is activated. The vehicle will start one time automatically when the temperature reaches 0*. Caution, Be certain vehicle is outside before activating this mode. T o toggle this feature on of off, from the Locked/Armed mode, press the Option and Lock ...

  • Audiovox PRO9801N - page 21

    128-8483 21 of 24 Page 21 ...

  • Audiovox PRO9801N - page 22

    128-8483 22 of 24 Page 22 THIS P AGE LEFT BLANK INTENTIONALL Y ...

  • Audiovox PRO9801N - page 23

    128-8483 23 of 24 Page 23 PRO9801N SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INT RUSI ON ZON E 3 2 FLASH...P AUSE = INT RUSI ON ZON E 2 1 FLASH...P AUSE = INT RUSI ON ZON E 1 SIREN CHIRP INDICA TORS 1 CHIRP * = A ...

  • Audiovox PRO9801N - page 24

    128-8483 24 of 24 Page 24 © 2009 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8483 ...

メーカー Audiovox カテゴリー Remote Starter

Audiovox PRO9801Nのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- PRO9801Nの取扱説明書
- Audiovoxの製品カード
- パンフレット
- またはAudiovox PRO9801Nの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Audiovox PRO9801Nの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Audiovox PRO9801Nの取り付け説明書、サービスマニュアル、簡易説明書、またはAudiovox PRO9801Nのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Audiovox PRO9801Nの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Audiovox PRO9801Nデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAudiovox PRO9801Nを使用するのを助ける技術的文書のことです。説明書は通常、全てのAudiovox PRO9801Nユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Audiovoxの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Audiovox PRO9801Nの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAudiovox PRO9801Nの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Audiovox PRO9801Nに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Audiovox PRO9801Nデバイスの基本機能を使うにあたってのヒント。 Audiovox PRO9801Nのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Audiovox PRO9801Nに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAudiovox PRO9801Nのメーカー/サービスへの連絡先に関する情報。

Audiovox PRO9801Nについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAudiovox PRO9801Nの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAudiovox PRO9801Nで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)