-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 1
Hoover ® WindT unnel Bagless Canister Cleaner with Power ed Nozzle Owner’ s Manual English ➜ pp. 1-12 Español ➜ pàg.13-19 Français ➜ p.20-26 Review this manual befor e operating cleaner . TM www .hoover .com ® ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 2
Fill in and r etain The model and serial number are located on the bottom of the cleaner . For your personal recor ds, please enter the COMPLETE model and serial number in the spaces provided and r etain this information. Y our cleaner is model________________________________________________________ and has serial number ___________________________ ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 3
3 Unpack cleaner from carton and iden- tify the parts shown. Remove and dispose of cardboard packing. A. Canister cleaner B. WindT unnel™ powered nozzle C. Extension wand and hose D. Powered hand tool (available at additional cost if not included with your cleaner) Operate cleaner only at voltage speci- fied on data plate on bottom of cleaner . A ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 4
2. How to use 4 C leane r description The assembled cleaner will look like the drawing. Operate cleaner only at voltage speci- fied on data plate on bottom of cleaner . This cleaner is intended for household use only . 1. WindT unnel™ carpet and floor power nozzle: automatically adjusts to differ ent carpet pile heights 2. Headlight 3. Quick disc ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 5
Hard surface floor cleaning The power nozzle can be used for cleaning hard surface floors such as wood, linoleum, vinyl, asphalt and rub- ber tile, sealed cork, concrete and ter- razzo, as well as carpet. T o tur n the brushes off for har d sur face floor cleaning, press the FLOOR/CAR- PET (E) switch again. Note : The headlight will be OFF when in ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 6
C C F J G H I The dirt cup needs emptying before the dirt reaches the “MAX” line (A) on the dirt cup or after ever y use if preferred. CAUTION: V ery fine materials, such as face powder , cornstarch, fireplace ashes or fireplace soot, may seal the filter and cause loss of suction. When using the cleaner to remove this type of dust, empty the cu ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 7
Exhaust filter How to clean T urn cleaner off and disconnect from electrical outlet. The exhaust filter , located behind the grill on the body of the cleaner , is wash- able. T o clean, rotate grill (F) counter - clockwise. Remove the exhaust filter (G). W ash filter by running it under cold tap water . Do not use soap or detergent. Do not use the ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 8
Position hood on top of nozzle base. T urn nozzle over . Replace 2 short screws at the back of nozzle and 2 long screws at the front. Replace brush roll cover (G) over agita- tor brush roll. Replace 3 short screws. Lift up end of agitator brush roll. Remove old belt from agitator pulley (I) and replace with new belt. Lettering on belt must be visib ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 9
9 Continued ➟ 3-16 Agitator brush roll r eplacement When to replace Disconnect cleaner from electrical outlet. When agitator brush roll brushes ar e worn, the brush roll should be replaced. T o check condition of brushes, move edge of a card acr oss bottom plate while turning brush roll. T o maintain cleaning effectiveness, r eplace brush roll if ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 10
10 3-21 E C 3. Remove agitator including end plates (C) and discard. 4. Inspect belt to ensure that it is in good condition. If belt is cracked, gouged or broken, r eplace it (see follow- ing section). 5. Insert brush roll through belt and position belt over gear teeth (D) on brush roll. 3-22 6. With curved ends down, slide end plates (C) of brush ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 11
11 Problem: Cleaner won’t run Problem: Cleaner suction low Problem: Agitator brush roll won’t run Problem: Nozzle won’t pick up Possible cause Possible solution • Not “ON” at hand grip. • T urn “ON” at hand grip. • Not firmly plugged in. • Plug unit in firmly . • No voltage in wall plug. • Check fuse or breaker . • Blown ...
-
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzle - page 12
Full One Y ear W arranty (Domestic Use) Y our HOOVER® appliance is warranted in normal household use, in accordance with the Owner’ s Manual against original defects in material and workmanship for a period of one full year from date of purchase. This warranty pr ovides, at no cost to you, all labor and parts to place this appliance in correct o ...
Hoover WindTunnel Bagless Canister Cleaner with Powered Nozzleについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもHoover WindTunnel Bagless Canister Cleaner with Powered Nozzleの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHoover WindTunnel Bagless Canister Cleaner with Powered Nozzleで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。