-
Sony SU-W210 - page 1
W all-Mount Bracket © 2004 Sony Corporation SU-W210 4-095-518- E1 (2) Operating Instructions • This W all-Mount Bracket is designed for use with the Sony KL V -SG21M1 LCD Color TV . ...
-
Sony SU-W210 - page 2
2 Thank you for purchasing this product. For Customers Sufficient expertise is required for installing this product, especially to assure the strength of the wall. Be sure to entrust the attachment of this product on the wall (Step 1 to Step 3 in “Installation”) to qualified service personnel and pay adequate attention to safety during the inst ...
-
Sony SU-W210 - page 3
3 Caution • This Wall-Mount Bracket is only for the specified Sony LCD Color TVs. Do not use the bracket with a TV whose operating instructions do not specify the use of this bracket. • Be especially careful not to drop the TV when you install it high on a wall. Installation For the installation, have ready eight commercially available mounting ...
-
Sony SU-W210 - page 4
4 Step 2: Decide the installation location Decide the location on the wall to install the TV. Then, place bracket A on the installation location and mark the four screw holes on the wall using a pencil. Before marking the location of the holes, make sure that the distance between the upper edge of bracket A and the ceiling is 15 cm or more, and tha ...
-
Sony SU-W210 - page 5
5 Step 3: Secure bracket A to the wall 1 Insert four of the screws you prepared at the positions marked in Step 2 (page 4). Do not tighten the screws completely for the moment. Keep a space of 2 to 3 mm from the wall. 2 Press bracket A to the wall and slide it down. Then fully tighten the four screws on the wall. 3 Insert four of the screws you pre ...
-
Sony SU-W210 - page 6
6 Step 4: Attach bracket B to the TV Before attaching bracket B , remove the rear cover of the TV and disconnect all the cables from the TV. See the Operating Instructions for the KLV-SG21M1 for details on detaching the rear cover. 1 Remove the five screws and detach the TV stand from the TV. To protect the LCD panel surface from possible damages, ...
-
Sony SU-W210 - page 7
7 2 Align the four holes on bracket B to the corresponding holes on the rear panel then secure the bracket to the TV using four of the five screws you removed previously. Note Keep the remaininig screw for future use. Use it to secure the stand to the TV again. Step 5: Connect the cables 1 Connect the cables. Bundle the cables and secure them with ...
-
Sony SU-W210 - page 8
8 Step 6: Attach brackets C , D , and E to the TV 1 Attach bracket C of the desired angle to bracket B . Insert the hooked part of bracket C into bracket B as illustrated below. Confirm that both sides of bracket C are outside bracket B , and secure them firmly with two of the supplied screws. There are three types of bracket C , each with a differ ...
-
Sony SU-W210 - page 9
9 2 Attach bracket D to bracket C , and secure them firmly with two of the supplied screws. Place bracket D onto bracket C as illustrated below, and secure them with the two screws. 3 Attach bracket E to bracket C , and secure them firmly with two of the supplied screws. Slide the shaft of bracket E into the notches of bracket C as illustrated belo ...
-
Sony SU-W210 - page 10
10 Step 7: Secure the TV to the wall 1 Hook bracket E on bracket A . Notes • Hold the TV firmly. Be especially careful when you secure the TV in a high place. • Do not release the TV until you confirm that bracket E is firmly secured to bracket A at three locations. Bracket E Bracket A Wall ...
-
Sony SU-W210 - page 11
11 2 Insert the locking rod. The locking rod can be inserted from either side. The illustration below shows an example of how to insert the locking rod from the right side. 1 Insert the longer side of the locking rod into the holes on bracket E . 2 Insert the curved side of the locking rod into the hole on bracket A . Hold and press the locking rod ...
-
Sony SU-W210 - page 12
12 Detaching the TV from the Wall-Mount Bracket Remove the locking rod from brackets A and E , then detach the TV from the Wall-Mount Bracket. Locking rod 1 3 2 ...
-
Sony SU-W210 - page 13
13 Specifications Bracket mass: Approx. 1.6 kg Supportable weight: Approx. 12 kg Design and specifications are subject to change without notice. Value varies depending on the angle of bracket C . Bracket C angle 0° 55 mm 5° 63 mm 10° 71 mm 280 mm 168 mm ...
-
Sony SU-W210 - page 14
...
-
Sony SU-W210 - page 15
...
-
Sony SU-W210 - page 16
Printed in China ...
Sony SU-W210についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもSony SU-W210の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSony SU-W210で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。