Pelco EH8100 Seriesの取扱説明書

12ページ 0.18 mb
ダウンロード

ページに移動 of 12

Summary
  • Pelco EH8100 Series - page 1

    ® INSTALLATION/OPERATION C1407M-G (12/04) EH8100 Series Pressurized Camera Enclosure ...

  • Pelco EH8100 Series - page 2

    2 C1407M-G (12/04) Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Pelco EH8100 Series - page 3

    C1407M-G (12/04) 3 Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way , such as power - supply cord or plug is damaged, liquid has been spil ...

  • Pelco EH8100 Series - page 4

    4 C1407M-G (12/04) Description Enclosures in the EH8100 Series are sealed and pressurized. They will accept CCD cameras with fixed focal length or motorized zoom lenses. The enclosures are wired for lenses with preset capabilities. MODELS EH8104 4-inch diameter , 17-inch length, two 20-watt heaters EH8106 6-inch diameter , 20-inch length, two 40-w ...

  • Pelco EH8100 Series - page 5

    C1407M-G (12/04) 5 Figure 1. EH8100 Series Enclosure - Rear View Figure 2. EH8100 Series Enclosure - Wiring Diagram SCHRAEDER VALVE SPIRAL RETAINING SPRING RETAINING SPRING END PRESSURE RELIEF VALVE T-HANDLE GROUND STUD AC NEUT AC LINE THERMOSTA T HTR * HTR * PP ZOOM PP FOCUS PP COM PP +5V LENS COM ZOOM FOCUS IRIS NOTES: Consult the manual section ...

  • Pelco EH8100 Series - page 6

    6 C1407M-G (12/04) MATING CONNECTOR ASSEMBLY To assemble the 16-pin mating connector , perform the following steps: 1. Discard the white plastic sleeve that is included with the connector assembly . Thread the cable through the compression nut/strain relief and connector shell. 2. Prepare the cabling by doing the following: Control Cable a. Strip t ...

  • Pelco EH8100 Series - page 7

    C1407M-G (12/04) 7 RECHARGING THE ENCLOSURE Y ou may use your own charging equipment or Pelco’ s EH8000RKIT to recharge the enclosure. If you are using your own equipment, adjust the regulator for an output pressure of 12 psi (83 kPa). If you are using the EH8000RKIT , it uses a regulator with a fixed, nonadjustable output pres- sure of 12 psi ( ...

  • Pelco EH8100 Series - page 8

    8 C1407M-G (12/04) Servicing DISASSEMBLY 1. Disconnect the power from the enclosure. 2. Remove the mating connector from the rear of the enclosure by turning the outer ring counterclockwise until a click is felt; then pull the mating portion of the connector off. Y ou may elect to remove the enclosure from its mount, which will make the disassembly ...

  • Pelco EH8100 Series - page 9

    C1407M-G (12/04) 9 Specifications Electrical Input V oltage 120 V AC (230 VAC optional) for heaters Power Requirements 40 watts (EH8104) 80 watts (EH8106) Connector 16-pin receptacle with jam nut Mating Connector MS-type connector (supplied) Maximum Cable Distances Distances are given in feet; values in parentheses are meters EH8104 All Others 12 ...

  • Pelco EH8100 Series - page 10

    10 C1407M-G (12/04) Environmental Ambient Operating T emperature -40° to 122°F (-40° to 50°C) (with heater) Vibration 5 to 60 Hz with 0.082-inch total travel (15 g’ s at 60 Hz). From 60 to 1,000 Hz, 5 g’ s rms with random vibration Altitude Sea level to equivalent of 10,000 feet Acoustic Noise Operates in 150 dB acoustic noise environments ...

  • Pelco EH8100 Series - page 11

    PRODUCT WARRANTY AND RETURN INFORMA TION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products and the following fixed camera mode ...

  • Pelco EH8100 Series - page 12

    ® W orldwide Headquarters 3500 Pelco W ay Clovis, California 93612 USA USA & Canada T el: 800/289-9100 Fax: 800/289-9150 International T el: 1-559/292-1981 Fax: 1-559/348-1120 www .pelco.com ISO 9001 United States | Canada | United Kingdom | The Netherlands | Singapore | Spain | Scandinavia | France | Middle East ...

メーカー Pelco カテゴリー Security Camera

Pelco EH8100 Seriesのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- EH8100 Seriesの取扱説明書
- Pelcoの製品カード
- パンフレット
- またはPelco EH8100 Seriesの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Pelco EH8100 Seriesの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Pelco EH8100 Seriesの取り付け説明書、サービスマニュアル、簡易説明書、またはPelco EH8100 Seriesのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Pelco EH8100 Seriesの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Pelco EH8100 Seriesデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがPelco EH8100 Seriesを使用するのを助ける技術的文書のことです。説明書は通常、全てのPelco EH8100 Seriesユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Pelcoの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Pelco EH8100 Seriesの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははPelco EH8100 Seriesの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Pelco EH8100 Seriesに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Pelco EH8100 Seriesデバイスの基本機能を使うにあたってのヒント。 Pelco EH8100 Seriesのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Pelco EH8100 Seriesに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるPelco EH8100 Seriesのメーカー/サービスへの連絡先に関する情報。

Pelco EH8100 Seriesについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもPelco EH8100 Seriesの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPelco EH8100 Seriesで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)