Harmar Mobility AL030の取扱説明書

16ページ 1.26 mb
ダウンロード

ページに移動 of 16

Summary
  • Harmar Mobility AL030 - page 1

    M OB I LI TY M O B I L I T Y M O B I L I T Y AL010 MICRO SCOOTER LIFT AL030 POWER TOTE MANUAL WHEELCHAIR LIFT INST ALLA TION GUIDE & OWNER'S MANUAL AL010 Micro Scooter Lift AL030 Power T ote for Manual Wheelchairs Congratulations on your new lift purchase. The Micro Scooter Lift and Power T ote are two of the easiest and most trouble free ...

  • Harmar Mobility AL030 - page 2

    Section 1 - Unpacking the Lift Your Universal Out side Lift was factory pre-assembled to require little assembly before installation. Box contents should include: AL010 - Micro Scooter Lift LIFT BODY HARDWA RE PAC K AL030 - Manual Wheelchair Lift LIFT BODY HITCH ADAPTER and S tabilizer HARDWA RE PAC K Each AL010 is packaged standard with a standard ...

  • Harmar Mobility AL030 - page 3

    Section 2 - Wiring the Vehicle Important Note: IMPROPER WIRING IS THE #1 CAUSE OF PROBLEMS IN THE OPERATION OF A VEHICLE LIFT . FOLLOW THE WIRING INSTRUCTIONS CAREFULLY Located in the hardware package is the vehicle wiring harness. The harness is manufactured to, and complies with the SAE J1128 requirements. The wire harness is approximately 23 ft. ...

  • Harmar Mobility AL030 - page 4

    Section 3 - Vehicle Preparation T o install the lift on a vehicle, it must be capable of accepting a hitch. If you are unsure about the hitch required, there are different places for you to check. Hitch Shops - Check your local area for shops that specialize in trailer hitches. They will normally have in stock the hitch that would be required for u ...

  • Harmar Mobility AL030 - page 5

    Measure from Hitch Bar to ground 5-13" 13-15" 15-17" 17-19" Section 4 - Installing the Lift ( no Swing A way option ) Your lif t will come shipped to you factory pre-assembled. T o prepare the lift for installation you must attach the lift to the Hitch Post and Hitch Adapter that are shipped with the lift (See parts list in sect ...

  • Harmar Mobility AL030 - page 6

    Measure from Hitch Bar to ground 5-12" 12-14" 14-16" 16-18" Drawings below depict a Class 3 Hitch Adapter The installation for a Class 2 is identical Move the folded lift to the rear of the vehicle with the motor box folded away from the vehicle. With assistance, carefully lift the unit up to the Swing Away and attach it using t ...

  • Harmar Mobility AL030 - page 7

    2 Push bottom of bracket 3 While holding bottom of bracket, rotate handle 4 Finish rotating handle, aligning holes 5 Install safety pin LOCKED NOT LOCKED YES NO NO Section 6 - Operating the Swing Away Option Many scooter and chair owners require access to the rear of a vehicle. T o accomplish this a Swing Away option is added to the lift installati ...

  • Harmar Mobility AL030 - page 8

    ON DOWN UP "PLA TFORM KEEPER" W EL DE D TO PL A TF O RM Section 7 - Operating the AL010 Micro Scooter Lift Insert Key and switch to "ON" position Press down on T oggle switch momentarily . Once platform has been lowered at least an inch, unfold the platform. Continue lowering to the ground. Drive scooter onto platform as shown. ...

  • Harmar Mobility AL030 - page 9

    LOADING YOUR SCOOTER ON THE LIFT Turn ON the power switch with the key furnished with your lift. Lower the platform using the UP/DOWN toggle switch. Pushing the switch downward will cause the platform to lower. Unfold the platform, then continue lowering to the ground. Release the UP/DOWN switch just as the platform reaches the ground; do not attem ...

  • Harmar Mobility AL030 - page 10

    ON DOWN UP "PLA TFORM KEEPER" NOTE: The Platform will not be allowed to unfold until the platform has been lowered at least an inch. WE LD ED TO PLAT FO RM Insert Key and switch to "ON" position Press down on T oggle switch momentarily . 1 Once platform has been lowered at least an inch, unfold the platform. Continue lowering to ...

  • Harmar Mobility AL030 - page 11

    Section 8 - Operating the AL030 Power T ote for Manual Wheelchairs LOADING YOUR WHEELCHAIR ON THE LIFT Turn ON the power switch with the key furnished with your lift. Lower the platform using the UP/DOWN toggle switch. Pushing the switch downward will cause the platform to lower. Unfold the platform, then continue lowering to the ground. Release th ...

  • Harmar Mobility AL030 - page 12

    Loosen nuts here Slide arm up or down tube Tighten after adjustment Section 9 - Adjusting the AL010 and AL030 N O I S N E T T S U J D A N O I S N E T T S U J D A N O I S N E T T S U J D A N O I S N E T T S U J D A LIFT SHOULD HOLD WHEELCHAIR FIRMLY WITH THE PLA TFORM FULLY RAISED ( RAISED UNTIL MOTOR RA TCHETING IS HEARD ) LIFT SHOULD HOLD SCOOTER ...

  • Harmar Mobility AL030 - page 13

    Section 10 - Safety & Maintenance SAFETY : Caution: Keep hands away from PINCH POINTS. As with most mechanical objects, the hinge point of a moving part creates a pinch point. Be sure to not to stick fingers or extremities at or near these points. Inspect the condition of your lift often. If any parts are worn or damaged DO NOT USE THE LIFT . I ...

  • Harmar Mobility AL030 - page 14

    Section 11 T roubleshooting guide The lift does not operate Check the power supply. The wiring harness ( both wires ) must be run directly to the battery . Attaching the black ( ground ) wire to the frame of the vehicle is NOT considered a reliable ground. Run the lift from a shop battery and not through the vehicle wiring harness. If this solves t ...

  • Harmar Mobility AL030 - page 15

    ITE M # DESCRIP TIO N PART # 1 SWIT CH PLAT E ALA12055 2 TOGGLE SWITCH ALA12010 3 KEY SWIT CH ALA12015 4 MOTOR COVER ALA12050 5 ACTUATOR ALA10010 6 OUT ER T UBE - AL01 0 ALA0103 7 HOLD DOW N ARM - A L010 ALA010017 8 HOLD DOW N FOOT ALA18020 9 INNER TUBE AL010 / A L030 ALA0300 10 HITCH POST ALA129 11 CLASS 2 HI TC H AD APTER AL126 12 CLASS 3 HI TC H ...

  • Harmar Mobility AL030 - page 16

    16 15 14 + KEYSWITCH ACTUATOR 12V POLE REVERSING SWITCH BATTERY TRAILER PLUG MOTOR COVER LIGHT B R OW N CIRCUIT BREAKER VEHICLE HARNESS ITE M # DESCRI PTI ON PART # 1 SWIT CH PLAT E ALA12055 2 TOGGLE SWITCH ALA12010 3 KEY SWIT CH ALA12015 4 MOTOR COVER ALA12050 5 ACTUATOR ALA10010 6 OUT ER T UBE - AL0 30 ALA0303 7 HOLD DOW N ARM - AL0 30 ALA0305 8 ...

メーカー Harmar Mobility カテゴリー Mobility Aid

Harmar Mobility AL030のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- AL030の取扱説明書
- Harmar Mobilityの製品カード
- パンフレット
- またはHarmar Mobility AL030の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Harmar Mobility AL030の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Harmar Mobility AL030の取り付け説明書、サービスマニュアル、簡易説明書、またはHarmar Mobility AL030のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Harmar Mobility AL030の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Harmar Mobility AL030デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがHarmar Mobility AL030を使用するのを助ける技術的文書のことです。説明書は通常、全てのHarmar Mobility AL030ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Harmar Mobilityの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Harmar Mobility AL030の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははHarmar Mobility AL030の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Harmar Mobility AL030に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Harmar Mobility AL030デバイスの基本機能を使うにあたってのヒント。 Harmar Mobility AL030のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Harmar Mobility AL030に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるHarmar Mobility AL030のメーカー/サービスへの連絡先に関する情報。

Harmar Mobility AL030についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもHarmar Mobility AL030の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHarmar Mobility AL030で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)