Graco Inc. 3245の取扱説明書

12ページ 0.81 mb
ダウンロード

ページに移動 of 12

Summary
  • Graco Inc. 3245 - page 1

    This manual contains IMPQRTAfflT WARNINGS and INOTRUCTIQMS READ AND RETAIN FOR REFERENCE Pressure Washer P/N 800-066 SERIES A 3200 psi7220 bar) OPERATING PRESSURE 3400 psi (235 bar) MAXIMUM WORKING PRESSURE i GRACQ IN@. P.Q. %QX I'M1 MUNNIEAPOLDS, MN 5544GV444 OCOPYRIGHT 1984 GRACO INC. ...

  • Graco Inc. 3245 - page 2

    iNJECT!ON HAZARD penetrate the skin and cause extremely serious Fluids under high pressure from spray or leaks can injury. including the need for amputation. NEVER point the spray gun at anyone or any part of the body. NEVER put hand or fingers over the spray tip. NEVER try to stop or deflect leaks with your hand or body. ALWAYS have the tip guard ...

  • Graco Inc. 3245 - page 3

    FUEL LINE I roN'oFFSW'TcH r-CHOKE RING the unit. Refer to the engine instruction booklet provided with Install Hose and Spray Gun Connect the spray hose to the spray gun by inserting the pin at the end of the hose into the quick the fluid outlet in the same way. disconnect coupler on the gun. Connect the hose to Cleaning Accessories For s ...

  • Graco Inc. 3245 - page 4

    startup Before starting, be sure to readthe safety warnings and setup instructions. Check the oil and gasoline levels. Turn on the water supply. Trigger the gun. Open the by-pass valve located on the pump. Open vent on fuel iank cap. Connen fuel line from tank to engine fuel coupling. Prime gas line by squeezing to the start position. bulb in line ...

  • Graco Inc. 3245 - page 5

    PROBLEM En ine Will Not Start Oraard To Start. Engine Misses Or Lacks Power Low Pressure 'ump runs extremely rough, xessure low. Nater kaka e from under he manifold! Nater in pump crankcase. ~~ :requent orprematurefailure )f the packmg. ;trong surging at the inlet ischarge side. nd low pressure on the " ! " I I " 1 I I I I I t ...

  • Graco Inc. 3245 - page 6

    6 801-644 ...

  • Graco Inc. 3245 - page 7

    REF. PART NO. NO. DESCRIPTION QTY DESCRIPTION QlV REF. PART NO. NO. 1 800-130 GUN ASSEMBLY, see pans 32 801-137 KEY, pulley 1 33' 800-083 GAS TANK ASSEMBLY, see 1 2 '801-640 TIP. 0005 MEG, 1 /4 thd. 3 '801-667 TIP,'1505 MEG. 1/4 thd. 1 1 parts drawing/list page 8 34 '801-569 QUICK COUPLE, male 1 4 800-059 PUMP ASSEMBLY, see ...

  • Graco Inc. 3245 - page 8

    PARTS DRAWING Gas Tank Assembly, PARTS LIST Gas Tank Assembly, 800-083 REF. PART NO. NO. DESCRIPTION 1 801-577 TANK, gas QTY 2 801-578 CAP 1 3 801 -579 FUEL LINE KIT 1 1 Order parts by name and series letter of the assembly for which you are ordering, 1 PARTS DRAWING Unloader Assembly, 800-1 22 3000 PSI (207 bar) Max. , / i 4 3 2 13 PARTS LIST Unlo ...

  • Graco Inc. 3245 - page 9

    NOTE Hose, Quick Couplers with Gun Assembly -See & Spray Tips not included Pressure Washer Assembly Parts Drawing/List. page 6. 7. SERVICE Gun, Cartridge Replacement 1. Press access pin (1 4) from gun handle and remove access plate (16) by sliding plate backwards. Remove cartridge (5) from housing (6) by using a 19 mm socket wrench. 2. Check ...

  • Graco Inc. 3245 - page 10

    SERVICE pump (Refer to Parts drawing, Page 11) NOTE: Two sizes of metric wrenchesare necessary for servicing the pump; M13 and M30. Valves: 1. Remove the hex plug (5)from manifold(6)using M30 wrench. 2. Examine O-ring (4) under plug and replace if cuts or distortion exist. 3. Remove valve unit and O-ring (3) from cavity NOTE: Valve unit may comeapa ...

  • Graco Inc. 3245 - page 11

    PARTS DRAWING UNLOADER ASSEMBLY PACKING.& RETAINER (Three kits needed for entire pump.) KIT 801 -487 PLUNGER REPAIR Includes: KIT 801 -474 REF. Includes: NO. QTY. 801 -473 801 -486 NO. am. 8 2 Includes: Includes: 12 .3 9 1 REF. NO. an. . NO. 13 an. 17 3 10 1 11 3 8 6 18 3 19 3 1 20 1 REF. PARTS LIST Pump Assembly, 800-059 REF. PART REF. PART NO ...

  • Graco Inc. 3245 - page 12

    ACCESSORIES (Must be purchased separately) CHEMICAL INJECTOR KIT 800-117 For injecting harsh cleaning chemicals downstream WATER SANDBLASTER 800-120 For abrasive cleaning of stubborn dirt and paint. from pump. Spray tip not included in kit. BACK FLOW PREVENTOR 801-133 SANDBLASTER SPRAY TIP 801-667 supply. Install upstream from pump. Prevent back-up ...

メーカー Graco Inc. カテゴリー Pressure Washer

Graco Inc. 3245のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 3245の取扱説明書
- Graco Inc.の製品カード
- パンフレット
- またはGraco Inc. 3245の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Graco Inc. 3245の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Graco Inc. 3245の取り付け説明書、サービスマニュアル、簡易説明書、またはGraco Inc. 3245のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Graco Inc. 3245の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Graco Inc. 3245デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがGraco Inc. 3245を使用するのを助ける技術的文書のことです。説明書は通常、全てのGraco Inc. 3245ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Graco Inc.の取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Graco Inc. 3245の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははGraco Inc. 3245の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Graco Inc. 3245に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Graco Inc. 3245デバイスの基本機能を使うにあたってのヒント。 Graco Inc. 3245のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Graco Inc. 3245に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるGraco Inc. 3245のメーカー/サービスへの連絡先に関する情報。

Graco Inc. 3245についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもGraco Inc. 3245の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがGraco Inc. 3245で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)