Unisys UDS 1491の取扱説明書

24ページ 0.74 mb
ダウンロード

ページに移動 of 24

Summary
  • Unisys UDS 1491 - page 1

    UDS 1491 Printer Setup Guide UNISYS © 2005 Unisys Cor poration. All rights reserved. Print ed i n USA August 200 5 6895 9691– 000 ...

  • Unisys UDS 1491 - page 2

    NO WARRANTIES OF ANY NATURE ARE EXTENDED BY THIS DOCUMEN T. Any product or related information described herein is only furnished pursua nt and subject to th e terms and conditions of a duly execute d agreement to purchase or lease equipment or to license software. The only warranties made by Unisys, if any, with respect to th e products described ...

  • Unisys UDS 1491 - page 3

    2 UDS 14 9 1 Check the contents: 1. Printer 2. Ribbon c a rtridge 3. Po wer Cable 4. CD with online User and Setup Gui d e 5. Setup Guide ...

  • Unisys UDS 1491 - page 4

    UDS 1491 3 1. 2. 1. Grasp tabs (1) and open acc ess cov er (2). 2. Remo ve printhead shipping retainer . ...

  • Unisys UDS 1491 - page 5

    4 UDS 1491 1. 2. 3. 1. Grasp tabs (1) and re mov e the paper separator . 2. Remove protecti ve material. Replace the paper separator . 3. Remov e protecti ve material from the pull-up rolle r assembly (2). ...

  • Unisys UDS 1491 - page 6

    UDS 1491 5 1. W ith access cov er open, grasp printhead (1) and slide to center . 2. Remov e ribbon cartridge from packaging. ! Important! Leav e the clear plastic ribb on shield ( 2 ) on the cartridge. ...

  • Unisys UDS 1491 - page 7

    6 UDS 1491 1. Hold ribbon cartridge as sho wn with knob (1) up and ribbon shield (2) facing platen (3). 2. Fit groo ves on sides at back end of cartridge ov er pins on ribbon plate (4). ...

  • Unisys UDS 1491 - page 8

    UDS 1491 7 1. Lo wer front of car tridge o ve r printhead (1) until it snaps into pla ce. 2. T urn knob (2) clockw ise to take up ribbon sl ack. ...

  • Unisys UDS 1491 - page 9

    8 UDS 1491 Set the headgap le ve r (1) for the number of sheets i n the forms you are using from 1-4. Use setting 5 for en v elopes or extra-thick paper . Adjust setting for the best print quality . ...

  • Unisys UDS 1491 - page 10

    UDS 1491 9 1. Make sure both printer and computer are OFF . 2. Plug interface cable into printer port. Plug other e nd into computer . ! P arallel cable must be shield ed, no lo nger than 6 ft (1.8m), and IE EE 1284-compatib le. Parall el USB ...

  • Unisys UDS 1491 - page 11

    10 UDS 1491 1. 2. 1. Plug po wer cord into printer . Pl ug other end into a grounded outlet. 2. T urn the printer on. PO WER light (1) comes on and ALARM light (2) comes o n because paper is not loaded. ...

  • Unisys UDS 1491 - page 12

    UDS 1491 11 1. 2. 3. 1. Mov e the paper le ver (1) to “REAR” position. 2. Grasp the paper separa tor (2). Lift slightly then slide back. 3. Pi vot forward and rest gently against the roller assembly . ...

  • Unisys UDS 1491 - page 13

    12 UDS 1491 1. Abov e view is from rear . Locate tractors. Pull up on tra ctor lock le vers (1) to release tractors. 2. Position right-hand tractor for width of paper . See paper size r efer ence marks on printer . 3. Open the t ractor covers (2). This action raises the paper separ ator . ...

  • Unisys UDS 1491 - page 14

    UDS 1491 13 Pull paper and place first tw o holes on each side over tractor pins (1). ! Equal number of pa per holes must be engaged on each tractor to ensure pro per paper feed. ...

  • Unisys UDS 1491 - page 15

    14 UDS 1491 1. Close right tractor cove r (1). 2. Push do wn on lock le ver (2) to lock tractor . ...

  • Unisys UDS 1491 - page 16

    UDS 1491 15 1. Position left tractor so that paper holes are centered on pins and paper is not stretched or too loose which could cause jams. Close tractor cover (1). 2. Push do wn on lock le ver (2) to lock tractor . ...

  • Unisys UDS 1491 - page 17

    16 UDS 1491 1. Replace the paper se parator . Make sure the marks (1) a re aligned. 2. Swing ov er the wire paper feed guide (2) to rest on roller assembly . ...

  • Unisys UDS 1491 - page 18

    UDS 1491 17 Push FF/LO AD button. Paper feeds into printer and ALARM light goes out. ! F or instru ctions on loading single sheet paper , see the User’s Guide on the CD. ...

  • Unisys UDS 1491 - page 19

    18 UDS 1491 Setting the T op of Form (TOF) Position The factory default setting for the T op of Form (TOF) (where the printing should begin) is one inch do wn from the top of the page. The first line prints at the red line on the plastic paper shield (1). Y our software may print the f irst lin e of print abov e or belo w where TOF is set. Y ou may ...

  • Unisys UDS 1491 - page 20

    UDS 1491 19 Using a Compatible Driver Note: See your software documentation for information on how to select a printer driver. The drivers below are listed by decr easing compatibility with your printer. Use one as close to the top of the list as possible. Epson LQ • Epson L Q 870/1170 • Epson L Q 80/1000 • Epson L Q 2500 IBM Proprinter • I ...

  • Unisys UDS 1491 - page 21

    20 UDS 1491 See the On-Line Us er ’ s Guide The c om p l e t e on - l i ne Us e r’s Guide i s pr o vi d e d on the CD. Y o u need Adobe Acrobat Reader to view the guide. Consult the User's Guide for information on • operating your printer • menu selections • problem solving • maintenance and service. ...

  • Unisys UDS 1491 - page 22

    21 UDS 1491 Serv i ce and Support I f you ne e d f urther a ss i stan c e or h a v e q u e st i ons, see our w e b site: http://www.unisys.com I n t he U. S . call 1-800-328-0440 In Canada call 1-800-387-6181 24 hours a da y , 7 d a ys a w e ek ...

  • Unisys UDS 1491 - page 23

    . ...

  • Unisys UDS 1491 - page 24

    *68959691-000* 68959691-000 ...

メーカー Unisys カテゴリー Printer

Unisys UDS 1491のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- UDS 1491の取扱説明書
- Unisysの製品カード
- パンフレット
- またはUnisys UDS 1491の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Unisys UDS 1491の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Unisys UDS 1491の取り付け説明書、サービスマニュアル、簡易説明書、またはUnisys UDS 1491のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Unisys UDS 1491の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Unisys UDS 1491デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがUnisys UDS 1491を使用するのを助ける技術的文書のことです。説明書は通常、全てのUnisys UDS 1491ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Unisysの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Unisys UDS 1491の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははUnisys UDS 1491の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Unisys UDS 1491に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Unisys UDS 1491デバイスの基本機能を使うにあたってのヒント。 Unisys UDS 1491のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Unisys UDS 1491に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるUnisys UDS 1491のメーカー/サービスへの連絡先に関する情報。

Unisys UDS 1491についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもUnisys UDS 1491の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがUnisys UDS 1491で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)