-
Nissan 2010 Frontier - page 1
Q UI C K REF EREN C E GUID E 2010 FRON T I E R ...
-
Nissan 2010 Frontier - page 2
*See your Owner’s Manual for more information. L OW TIR E PR ESS UR E WARN IN G LIG HT HEADLIGHT AND TURN SIGNAL CONT ROL TR IP CO MP UTER I NSTRU ME NT B RI GHTN ES S CO NTROL/TR IP C HANG E BUTTON WI ND SH IE LD WI PE R /W ASH ER SWITCH STEE RI NG WH E EL SWITCH FOR AU DIO CO NTROL/ BLU ET OOTH ® (if so equipped) CR UI SE CO NTROL M IR ROR C O ...
-
Nissan 2010 Frontier - page 3
T AB LE OF C O NTE NT S Remote Keyless Entry System (if so equipped). ......................... 2 Automatic Door Locks ............................................... 2 W indshield W iper/W asher Switch. .................................... 3 Headlight and T urn Signal Control .................................... 3 Steering W heel Switches for Audi ...
-
Nissan 2010 Frontier - page 4
R E M O TE K EYLE SS E NTR Y SY STE M (if so equipped) LOCK DOOR S Press the button to lock all doors. U N L OCK D OORS Press the button once to unlock the driver’s door only . Press the button again within 5 seconds to unlock all doors. US I NG TH E P AN IC ALAR M Press and hold the button for longer than 0.5 seconds. The panic alarm will sound ...
-
Nissan 2010 Frontier - page 5
3 WI N D S H I E LD WI PE R/WASH E R SWIT CH The ignition switc h must be in the ON position to activate the windshield wipers. Move the lever to the following positions to operate the windshield wipers: 1A Intermittent (I NT) – Front wipers operate intermittently and can be further adjusted by twisting the time control ring 1B . 02 Low Speed (LO ...
-
Nissan 2010 Frontier - page 6
STE E R I N G WH E E L SWITCHE S FOR A U D IO CONTR OL/ B LU ETOO TH ® (if so equipped) Press the MOD E button to turn the radio system on. T o choose Preset A, B, C, CD, AUX or X M ® (if so equipped) press MOD E repeatedly. The tuning up or down switch can be used to perform the following: •Pushthe switch for less than 1.5 sec ...
-
Nissan 2010 Frontier - page 7
5 MAN U AL CLI MA TE CONTROL 01 F AN SPE E D CONTR OL DIAL T urn the fan speed control dial to the left (slow) or right (fast) to control fan speed. 02 TE M PERA TU RE CONTR OL D IAL T urn the temperature control dial for the desired temperature. T urn the control dial to the left for cold air or right for hot air . 03 AI R FL OW CONTROL B UTTONS P ...
-
Nissan 2010 Frontier - page 8
6 FM / AM /XM ® * RAD I O WITH CD CHANG ER (if so equipped) 01 PR E SET A·B·C B UTTON Press the PR E SET A·B·C button until you reach the desired setting. The radio is equipped with three separate banks, each with six station presets. Y ou may store any combination of FM, AM or X M ® radio presets on eac h bank. 02 S E EK/TRACK B UTTON T o sc ...
-
Nissan 2010 Frontier - page 9
7 04 SCAN/ R PT B UTTON Press the SC AN/RP T button to stop at each broadcasting station (FM, AM or X M ® ) for 5 seconds. Pressing the button again during this 5-second period will stop scan tuning and the radio will remain tuned to that station. If the SC AN/RP T button is not pressed within 5 seconds, scan tuning moves to the next station. 05 C ...
-
Nissan 2010 Frontier - page 10
8 CLOCK SET/AD J USTM ENT Press and hold the D I SP CLOCK button until it beeps. The hours will start flashing. Press the C A T/ F OLDE R or S E E K/TRACK buttons to adjust the hours. Press the D I SP CLOCK button to switch to the minute adjustment. Press the C A T/ F OLDE R or S E E K/TRACK buttons to adjust the minutes. Press the D I SP CLOCK bu ...
-
Nissan 2010 Frontier - page 11
9 VE H I CLE D YNAM IC CONTROL (VD C) OFF SWITCH (if so equipped) The V ehicle Dynamic Control (VD C) system monitors driver inputs and vehicle motion. Under certain conditions, it controls braking and engine out put to he lp imp rov e tr act ion or ha ndl ing. VDC ma y n eed to be tem por ari ly shut off if you are trying to free a vehicle stuck i ...
-
Nissan 2010 Frontier - page 12
10 H I LL ST ART AS S I ST (if so equipped) The hill start assist system automatically keeps the brakes applied to help prevent the vehicle from rolling backwards in the time it takes the driver to release the brake pedal and apply the accelerator when the vehicle is stopped on a hill. The maximum holding time is 2 seconds. Hill start assist will o ...
-
Nissan 2010 Frontier - page 13
11 S EA T B E L T W AR N I N G LIG HT AN D CH I ME T he light and chime remind you to fasten your seat belts. The light illuminates whenever the ignition switc h is placed in the ON or ST ART position and remains illuminated until the driver’s seat belt is fastened. At the same time, the chime sounds for appro ximately 6 seconds unless the driver ...
-
Nissan 2010 Frontier - page 14
FOLD FLA T FR ONT P AS S E NG E R SEA T T o fol d the fron t-pas seng er’s seatb ack flat for extra storage length when transporting long items: Slide the seat to the rearmost position. Lift up on the recline lever 0 1 , located on the outside edge of the seat, and fold the seatback forward as far as it will go. Lift up on the latch 0 2 lo cated ...
-
Nissan 2010 Frontier - page 15
13 FOLD I NG TH E R EAR B E N CH S EA T (Crew Cab Model only) FOLD I NG TH E S EA TBACK DOWN: T o fold the rear bench seatback down to access the jacking tools, pull up on the straps 0 1 located on the outer edge of the seatbacks and fold the seatbac k forward. FOLD I NG TH E S EA T BASE U P T o fold the rear bench seat base up to access the under- ...
-
Nissan 2010 Frontier - page 16
NOTE: Garage door openers (manufactured after 199 6) have “rolling code protection. ” T o program a garage door opener equipped with “rolling code protection, ” you will need to use a ladd er to get to t he ga rage door open er mo tor to be able to acces s the “smart or learn” program button. PR OGR AMMIN G Y OUR H OMEL INK ® UN IVE R ...
-
Nissan 2010 Frontier - page 17
15 B LU ETOO TH ® HAN D S-FR E E PH ON E SY STE M (if so equipped) W ith an overhead microphone and sound transmitted through the audio system speakers, the Bluetooth ® Hands-free Phone System utilizes Bluetooth ® wireless technology and voice recognition to provide hands-free cellular phone communication. S Y STEM O PE RA TI N G TI PS Close all ...
-
Nissan 2010 Frontier - page 18
16 CONN EC TING PROCEDU RE NOTE: T he vehicle must be stationary when connec ting the phone. 1. Press the button on the steering wheel. The system announces the available commands. 2. S ay “Connect Phone. ” 3. The system acknowledges the previous command and announces the next set of available commands. S ay “ Add phone. ” 4. Initiate conne ...
-
Nissan 2010 Frontier - page 19
HOW T O SA Y N U M B E R S N IS SAN voice recognition permits numbers to be spoken in a variety of ways. S ay “zero” or “oh” for “0. ” Example: 1-8 00-662-6200 – S ay “one eight zero zero six six two six two oh oh. ” S ay “pound” for “#. ” Say “st ar” for “*” (available when using the “Call Phone Number” then ? ...
-
Nissan 2010 Frontier - page 20
Nissan, the N issan Br and Sym bol, “ SH IFT_” tagl ine, Z and Nissan model names are Niss an trademarks. © 20 1 0 Nissan North America, Inc. QR 0 E 0 D 40 U 1 Printing: March 2010 (12) ...
Nissan 2010 Frontierについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもNissan 2010 Frontierの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがNissan 2010 Frontierで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。