-
Honeywell TH3110D - page 1
Installation Guide TH3110D Non-programmable Digital Thermostat ...
-
Honeywell TH3110D - page 2
Product Application This thermostat provides electronic control of 24 V A C single-stage heating and cool- ing systems, or 750 mV heating systems. System T ypes • Gas, oil, or electric heat with air conditioning • W arm air , hot water , high-efficiency furnaces, heat pumps, steam, gravi- ty • Heat only • Heat only with f an • Cool only ? ...
-
Honeywell TH3110D - page 3
PRO TH3110D Non-programmable Digital Thermostat 1 Install the thermostat about 5 feet (1.5m) above the floor in an area with good air circulation at average temperatur e. Do not install in locations where the thermostat can be af fected by: • Drafts or dead spots behind doors and in corners • Hot or cold air from ducts • Sunlight or radiant h ...
-
Honeywell TH3110D - page 4
Installation Guide 2 Pre-installation checklist Package contents Check to make sure y our package includes the f ollowing items: • PR O TH3110D digital thermostat (wallplate attached to back) • Operating manual • W all anchors and mounting screws (2 eac h) • AA alkaline batteries (2) Required tools & supplies • No. 2 Phillips screwdri ...
-
Honeywell TH3110D - page 5
PRO TH3110D Non-programmable Digital Thermostat 3 Remove the w allplate from the ther- mostat as shown at left, then f ollow directions below f or mounting. 1 Pull wires through wire hole. 2 P osition wallplate on wall, level and mark hole positions with pencil. 3 Drill holes at marked positions as shown below , then tap in supplied wall anchors. 4 ...
-
Honeywell TH3110D - page 6
Installation Guide 4 Wiring 1 Loosen screw terminals, insert wires into terminal block, then re- tighten screws. 2 Push e xcess wire back into the wall opening. K eep wires in shaded area as shown at left. 3 Plug the wall opening with non- f lamma ble insulation to pr event drafts from affecting thermostat operation. T erminal Designations W W Heat ...
-
Honeywell TH3110D - page 7
PRO TH3110D Non-programmable Digital Thermostat 5 T ypical 1H/1C system: 1 transformer T ypical 1H/1C system: 2 transformers 1 Power supply . Provide disconnect means and overload pr otection as required. 2 Factory-installed jumper . Remove for 2-transformer systems only . 3 Use either O or B terminals for changeover valve. 4 Use a small piece of w ...
-
Honeywell TH3110D - page 8
Installation Guide 6 • G G a a s s o o r r O O i i l l : : For gas or oil heating systems, leave the f an operation switc h in this factor y-set position (This setting is for systems that control the fan in a call f or heat.) • E E l l e e c c t t r r i i c c o o r r H H e e a a t t P P u u m m p p : : Change the switc h to this setting for hea ...
-
Honeywell TH3110D - page 9
PRO TH3110D Non-programmable Digital Thermostat 7 AC Power The thermostat can be powered by 24 V A C power , or by batter ies. T o wire the thermostat for A C power , connect the common side of the cooling transf or mer to the “C” terminal as shown at left. I I m m p p o o r r t t a a n n t t : : Remove R/Rc jumper f or 2-transf or mer systems ...
-
Honeywell TH3110D - page 10
1 0 Installation Guide 8 1 5 9 14 15 System type Heating cycle rate (CPH: cycles/hour) Compressor cycle rate (CPH) T emperature display Compressor protection 0 Gas, oil or electric heat with air conditioning 1 Heat pump (5 minute compressor of f time in heating and cooling) 5 For gas or oil furnaces of less than 90% efficiency 1 For steam or gravit ...
-
Honeywell TH3110D - page 11
PRO TH3110D Non-programmable Digital Thermostat 9 10 0 T est 10 30 70 Heating system Cooling system Thermostat information (for refer ence only) 0 Heat and fan turn off. 1 Heat turns on. Fan also turns on immediately if Fan Operation Switch is set to Electric Heat/Heat Pump (see page 6). 0 Compressor and fan turn off. 1 Compressor and fan turn on. ...
-
Honeywell TH3110D - page 12
Installation Guide 10 Inside Set T o 75 75 Heat On Cool On ° ° Replace Batt Quick refer ence to display screen Current inside temperatur e Low battery warning T emperature setting System status On when “calling” for heating or cooling; flashes when waiting for compressor r estart Quick refer ence to controls Digital display screen T emperatur ...
-
Honeywell TH3110D - page 13
PRO TH3110D Non-programmable Digital Thermostat 11 In case of difficulty If you hav e dif ficulty with your thermostat, please tr y the sugg estions below . Most problems can be corrected quickl y and easily . Display is blank • Check circuit br eaker and reset if necessary . • Make sure heating & cooling power switches ar e on. • Make su ...
-
Honeywell TH3110D - page 14
Installation Guide 12 Accessories Please contact your distributor to order accessories. Cover plate assembly ............................................Part Number 50002883-001 (Used to cover marks left by old thermostats.) Specifications T emperature Ranges • Heat: 40° to 90°F (4.5° to 32°C) • Cool: 50° to 99°F (10° to 37°C) Operating ...
-
Honeywell TH3110D - page 15
...
-
Honeywell TH3110D - page 16
Honeywell International Inc. 1985 Douglas Drive North Golden V alley , MN 55422 http://yourhome.honeywell.com Automation and Control Solutions Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. ® U.S. Registered T rademark. © 2005 Honeywell International Inc. Patents pending. All rights reserved. 69-1846 • 0 ...
Honeywell TH3110Dについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもHoneywell TH3110Dの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHoneywell TH3110Dで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。