-
Electrolux FI22/10SA - page 1
user manual Fridge-Freezer FI22/10FA FI22/10SA ...
-
Electrolux FI22/10SA - page 2
Electrolux. Thinking of you. Share more of our thinki ng at www.electrolux.com Contents Safety information 2 Operation 4 First use 4 Daily use 4 Helpful hints and tips 6 Care and cleaning 6 What to do if… 8 Technical data 10 Installation 10 Environmental concerns 14 Subject to change without notice Safety information In the interest o f your safe ...
-
Electrolux FI22/10SA - page 3
• It is dangerous to alter the specifications or modify this product in any way. Any dam- age to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthen ed. 2. Ma ...
-
Electrolux FI22/10SA - page 4
by a qualified electrici an or competent per- son. • This product must be serviced by an au- thorized Service Cent re, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone lay er, in either its refrigerant circuit or insulation materials. The appliance shall not be d ...
-
Electrolux FI22/10SA - page 5
partment let the app liance run at least 2 hours on the higher s ettings. If large quantities of food are to be stored, remove all drawers and baskets from appli- ance and place food on cooling shelves to obtain the best performance. Warning! Make sure th at foods do not exceed the load limit stated on the side of the upper section (where applicabl ...
-
Electrolux FI22/10SA - page 6
Helpful hints and tips Hints for energy saving • Do not open the door frequently or leave it open longer than ab solutely necessary. • If the ambient temperat ure is high and the Temperature Regulator is set to low tem- perature and the appliance is fully loaded, the compressor may run continuously , causing frost or ice on the evaporator. If t ...
-
Electrolux FI22/10SA - page 7
charging must theref ore only be carried out by authoriz ed technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with luke- warm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. Importa ...
-
Electrolux FI22/10SA - page 8
4. When defrosting is completed, dry the in- terior thorou ghly and keep the scraper for future use. 5. Switch on the appliance. 6. After two or t hree ho urs, reload the pre- viously removed food into the compart- ment. Warning! Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical devi ...
-
Electrolux FI22/10SA - page 9
Problem Possible ca use Solution The product temperature is too high. Let the product temperat ure de- crease to room temperature before storage. The room temperature is too high. Decrease the room temperature. Water flows on the rear plate of the refrig erator. During the automati c defrosting process, frost defrosts on t he rear plate. This is co ...
-
Electrolux FI22/10SA - page 10
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "In- stallation". 3. If necessary, rep lace the defective door gaskets. Contact the Service Center. Technical data Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 20 h The technical informatio n are situated in the rating pl ...
-
Electrolux FI22/10SA - page 11
Door reversibility The door of the applia nce opens to the right. If you want to open the door to the left, do these steps before you install the appliance: 1. Loosen and remove the upper pin. 2. Remove the upper door. 3. Remove the spacer. 4. Loosen the middle hinge. 5. Remove the lower door. 6. Loosen and remove the lower pin. On the opposite sid ...
-
Electrolux FI22/10SA - page 12
1 2 2. Adjust the applia nce in the niche. The lower hinge cover (in the accesso- ries bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Open the door. Put the lower hinge cover in position. 44mm 4mm 3. Attach the appliance to the niche with 4 screws. I 4. Push the sealing strip between the ap- pliance an ...
-
Electrolux FI22/10SA - page 13
Attach the hinge cove rs (E) to the hinge. B E E D C 7. Connect the applian ce laterally to the kitchen furniture sidewall: a) Loosen the screws of the part (G) and move the part ( G) till the fur niture sidewall. b) Tigh ten the screws of the part (G) again. c) Attach the part (H) to the part (G). G H 8. Disconnect the part s Ha, Hb, Hc and Hd Ha ...
-
Electrolux FI22/10SA - page 14
Put together the app liance door and the furniture door and mark the holes. Ha Hb 8 mm 12. Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the door where the nail must be fitted (K). Ha K 8 mm 13. Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and th e applian ...
-
Electrolux FI22/10SA - page 15
electrolux 15 ...
-
Electrolux FI22/10SA - page 16
212715131-0 0-13102009 www.electrolux.com ...
Electrolux FI22/10SAについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもElectrolux FI22/10SAの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがElectrolux FI22/10SAで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。