-
Audiovox AMP-610 - page 1
Ow Ow Ow Ow Ow ne ne ne ne ne r's r's r's r's r's Manual Manual Manual Manual Manual Model AMP-610 500 W att Stereo Amplifier ...
-
Audiovox AMP-610 - page 2
INDEX Specifications .............................................................................1 Precautions ................................................................................2 Installation Instructions ................................................................3 Controls and Indicators......................................... ...
-
Audiovox AMP-610 - page 3
HIGH PERFORMANCE STEREO AMPLIFIER This power amplifier has been designed to provide high quality performance with a minimum of maintenance. However, it's performance will only be as good as the care and quality of components with which it is installed. We therefore advise that you read these instructions very carefully to familiarize yourself ...
-
Audiovox AMP-610 - page 4
PRECAUTIONS 1. Although this unit is designed with built-in self-protection circuits, there may be a possibility of damage if it is not wire d correctly. Please follow the wiring instructions carefully for the type of system being used. 2. The last lead to be connected is the wire to the positive ( + ) terminal of the battery. Connect this wire onl ...
-
Audiovox AMP-610 - page 5
INSTALLATION INSTRUCTIONS INSTALLATION DIAGRAM 1. Select a mounting area where the amplifier will have sufficient air circulation for proper cooling. Inadequate air circulation will cause the temperature of the amplifier to rise and will trigger the thermal protection mode. 2 . Place the amplifier on the mounting surface and mark the locations of t ...
-
Audiovox AMP-610 - page 6
2 3 4 1 6 5 8 2 CONTROLS AND INDICATORS 7 9 -4- ...
-
Audiovox AMP-610 - page 7
1 Power Indicator/Protection Mode LED The Power Indicator LED will light to indicate that the unit is connected to the battery and that the Remote Turn-On terminal is receiving +12 volts, thus turning o n the amplifier. This LED illuminates red to indicate that the self-protection circuits have been activated and have shut off operation of the a mp ...
-
Audiovox AMP-610 - page 8
4 High Level Input Connection If the car stereo does not provide low-level outputs, the amplifier may be connected via the speaker (high-level) outputs from the stereo. Wire the speaker leads from the car stereo to the 5-pin adaptor harness as shown in the diagram (shielded cable is not required for this application) and plug the connector into the ...
-
Audiovox AMP-610 - page 9
The wiring of your amplifier will depend on the system and speakers you are using but will either be a stereo, mono, or mixed- mono application. The following pages illustrate the input and output wiring for both types. Please refer to the appropriate diagrams for the system configuration you are using. The power and speaker wire connections for th ...
-
Audiovox AMP-610 - page 10
-8- USE THIS INPUT WIRING WITH OUTPUT WIRING ON PAGE 9 4-CHANNEL AND MIXED-MONO INPUT WIRING DIAGRAM LOW-LEVEL RCA OUTPUT S HIGH-LEVEL (SPEAKER) OUTPUTS CAR STEREO LEFT REAR + RIGHT REAR + RIGHT FRONT + GREEN WHITE BLACK BROWN GRAY CH1 CH2 CH3 CH4 IMPORTANT USE EITHER HIGH-LEVEL OR LOW-LEVEL INPUTS, NOT BOTH. RCA TYPE SHIELDED CABLES (NOT INCLUDED) ...
-
Audiovox AMP-610 - page 11
-9- LEFT FRONT SPEAKER SPEAKER IMPEDANCE 4-CHANNEL MODE : 2-8 OHMS MIXED-MONO MODE : 4-8 OHMS RIGHT REAR SPEAKER RIGHT FRONT SPEAKER LEFT REAR SPEAKER USE THIS OUTPUT WIRING WITH INPUT WIRING ON PAGE 8 4-CHANNEL AND MIXED-MONO OUTPUT WIRING DIAGRAM USE #10 GAUGE WIRE (SEE TEXT) CONNECT THIS WIRE LAST EXISTING SCREW OR BOLT CLEAN PAINT, RUST, DIRT O ...
-
Audiovox AMP-610 - page 12
-10- USE THIS INPUT WIRING WITH OUTPUT WIRING ON PAGE 11 3-CHANNEL INPUT WIRING DIAGRAM CAR STEREO LOW-LEVEL RCA OUTPUTS MONO OR SUB-WOOFER GREEN WHITE BLACK BROWN GRAY RCA TYPE SHIELDED CABLES (NOT INCLUDED) IMPORTANT USE EITHER HIGH-LEVEL OR LOW-LEVEL INPUTS, NOT BOTH. TO CH1 TO CH4 TO CH2 LEFT RIGHT CHASSIS GROUND ON RADIO HIGH-LEVEL (SPEAKER) O ...
-
Audiovox AMP-610 - page 13
-11- AUTO-ANTENNA LEAD USE #10 GAUGE WIRE (SEE TEXT) CAR STEREO CONNECT THIS WIRE LAST EXISTING SCREW OR BOLT CLEAN PAINT, RUST, DIRT OR GREASE FROM AREA FOR GOOD CONNECTION GROUNDED METAL SECTION OF VEHICLE 12 VOLT VEHICLE BATTERY CHASSIS GROUND USE THIS OUTPUT WIRING WITH INPUT WIRING ON PAGE 10 LEFT SPEAKER CH1 / CH2 MIXED-MONO SPEAKER OR SUB-WO ...
-
Audiovox AMP-610 - page 14
HIGH-LEVEL (SPEAKER) OUTPUTS CAR STEREO USE THIS INPUT WIRING WITH OUTPUT WIRING ON PAGE 13 2-CHANNEL MONO (BRIDGED) INPUT WIRING DIAGRAM LOW-LEVEL RCA OUTPUTS RIGHT LEFT IMPORTANT USE EITHER HIGH-LEVEL OR LOW-LEVEL INPUTS, NOT BOTH. CHASSIS GROUND ON RADIO TO CH1 TO CH4 RCA TYPE SHIELDED CABLES (NOT INCLUDED) -12- RIGHT REAR + LEFT REAR + RIGHT FR ...
-
Audiovox AMP-610 - page 15
USE THIS OUTPUT WIRING WITH INPUT WIRING ON PAGE 12 2-CHANNEL MONO (BRIDGED) OUTPUT WIRING DIAGRAM LEFT SPEAKER OR SUB-WOOFER 4 - 8 OHMS RIGHT SPEAKER OR SUB-WOOFER 4 - 8 OHMS EXISTING SCREW OR BOLT CLEAN PAINT, RUST, DIRT OR GREASE FROM AREA FOR GOOD CONNECTION GROUNDED METAL SECTION OF VEHICLE -13- USE #10 GAUGE WIRE (SEE TEXT) CONNECT THIS WIRE ...
-
Audiovox AMP-610 - page 16
AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (a ...
Audiovox AMP-610についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもAudiovox AMP-610の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAudiovox AMP-610で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。