Abocom CWB1000の取扱説明書

19ページ 1.14 mb
ダウンロード

ページに移動 of 19

Summary
  • Abocom CWB1000 - page 1

    IEEE802.11b 11Mbps CompactFlash Card Quick Installation Guide M73-APO01-560 ...

  • Abocom CWB1000 - page 2

    REGULATORY STATEMENTS FCC Certification The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established certain rules governing the use of electronic equipment. Part15, Class B This device complies with Part 15 o f FCC rules. Operation is subject to the following two conditions: 1) This device ...

  • Abocom CWB1000 - page 3

    SOFTWARE INSTALLATION FOR WINDOWS CE3.0 Connect your PDA to your PC. Make sure you have the Microsoft ActiveSyn c Utility installed on your PC to make an active connection. Caution : DO NOT insert the Wireless CompactFlash Card into the PDA BEFORE installing the co nfiguration utility. 1. Insert the device driver C D into the CD-ROM drive. 2. Open ...

  • Abocom CWB1000 - page 4

    - 3 - 4. Clic k Next to contin ue. 5. Clic k OK . 6. Clic k Finish . ...

  • Abocom CWB1000 - page 5

    - 4 - 7. You can now i nsert the Wi reless CompactFlash Card into the PDA. Then use the Se ttings on your Windows CE to configure the network settings. ...

  • Abocom CWB1000 - page 6

    HARDWARE INSTALLATION For PDA Insert the Wireless CF card into the Windows CE-based PDA by aligni ng the Wireless CF card toward the CF slot. For Notebook PC Note : This section is only for users who had CF to PCMCIA Adapter. Pleas e refer to the manual for more details. 1. Plug the Wireless C F card into the PCMCI A Adapter. The Wireless CF card i ...

  • Abocom CWB1000 - page 7

    NETWORK CONNECTION FOR WINDOWS CE3.0 Once the driver has been installed, you must make some changes to your network settin gs. 1. Go to Start Æ Settings Æ Connections . Click on Network Adapters . 2. Highlight PRISM 11Mbps Wireless LAN Adapter , click Properties . - 6 - ...

  • Abocom CWB1000 - page 8

    - 7 - 3. ~ Use server-assigned IP address If your network suppor ts DHCP, select Use server-assigned IP address . The IP address and other information will be automatically assigned. T hen click ok . ~ Use server-assigned IP address If your ne twork does not support DHCP, select Use specific IP address . You may need to enter the IP address and oth ...

  • Abocom CWB1000 - page 9

    - 8 - 4. A message as below may appear saying you must remove and re -insert the Wireless CompactFlash Card to have the change s take affect. Click OK . ...

  • Abocom CWB1000 - page 10

    CONFIGURATION UTILITY FOR WINDOWS CE3.0 After installing the Wireless Com pactFlash Card’s driver successf ully, go to Start Æ Programs . Click on PRISM Sett ings , the Network Status icon will appear in the task bar. Network Status Icon & Icon Menu The Status Icon Icon Link Status Green indicates a strong link. Yellow indicates a w eak link ...

  • Abocom CWB1000 - page 11

    - 10 - Icon Menu After clicking on the icon, the icon menu as displayed below will prompt you to configure the Wireless CompactFlash Card. Items Description Wireless Radio On Wireless Radio Off These two items al lows you to enable or disable the wireless radio. Remove Status Icon… Removes the U tility icon from the PDA’s system tray. Each time ...

  • Abocom CWB1000 - page 12

    - 11 - All settings are categorized into 5 tab s: Link Configuration Encryption Site Survey About Link The Link tab provides you the statu s of the Wireless CompactFlash Card. Item Description State It displays the connection state of the Wireless CompactF lash Card with the wireless network. ...

  • Abocom CWB1000 - page 13

    Item Description Current Channel It displays the s elected chan nel that is currently used. (There are 14 channels available, depends on the country.) Enable Radio / Disable Radio Click this button to enabl e/disable the wireless radio. The Wireless CompactFlash Card will connect/disconnect with the wireless network. Rescan Search for all available ...

  • Abocom CWB1000 - page 14

    - 13 - Item Description Profile Name Saves values for all previous setting parameters. The default values contain the parameters configured at installation. Once the demands for switching between different networking environments are requ ired, you can also set the additional profiles to eliminate the co nfiguration time. To save the current parame ...

  • Abocom CWB1000 - page 15

    Item Description Network Type It displays the type of BSS. Access Point: allows the Adapter to communicate with a wired network which employing an A ccess Point. Peer-to-Peer: allows PC-to-PC, station-to-station communication without employing an Access Po int. Peer-to-Peer Channel To communicate with oth er Wireless CompactFlash Card, you must sp ...

  • Abocom CWB1000 - page 16

    - 15 - Item Description Encryption (WEP) WEP is a data privac y mechanis m based on a 64-bit/128-bit shared key algorithm. Under the drop-down box, you can choose to have WEP encryption Disabled , 64 bit , or 128 bit . Create Keys with Passphrase A Passphrase can be entered t o generate four keys used for WEP. For the easiest configuration, the Pas ...

  • Abocom CWB1000 - page 17

    - 16 - Key 1: Key 2: Key 3: Key 4: This setting is the configur ation key used in accessing the wireless network via WEP encryption. Use WEP Key The default key field can be used for specifying which of the fo ur encryption ke ys to transmit data on the wireless network. Apply Click Apply to activate th e settings. You must use the same value/phras ...

  • Abocom CWB1000 - page 18

    - 17 - Site Survey The Site Survey tab shows all the available Access Points or Peer-t o-Peer types and their features. Item Description Network Name The name must be identical fo r all devices and points attemptin g to connect to the same network. BSSID A set of wireless stations is r eferred to as a Basic Service Set (BSS). Computers in a BSS mus ...

  • Abocom CWB1000 - page 19

    Item Description WEP Encryption It displays the status of WEP Encryption. Signal Level It displays the signal strength of the connection between the Wireless CompactFlash Card and the Access Point it connects. Rescan Search for all available n etworks. Clicking on the button, the de vice will start to rescan and list all available sites. Connect To ...

メーカー Abocom カテゴリー Network Card

Abocom CWB1000のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- CWB1000の取扱説明書
- Abocomの製品カード
- パンフレット
- またはAbocom CWB1000の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Abocom CWB1000の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Abocom CWB1000の取り付け説明書、サービスマニュアル、簡易説明書、またはAbocom CWB1000のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Abocom CWB1000の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Abocom CWB1000デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAbocom CWB1000を使用するのを助ける技術的文書のことです。説明書は通常、全てのAbocom CWB1000ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Abocomの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Abocom CWB1000の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAbocom CWB1000の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Abocom CWB1000に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Abocom CWB1000デバイスの基本機能を使うにあたってのヒント。 Abocom CWB1000のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Abocom CWB1000に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAbocom CWB1000のメーカー/サービスへの連絡先に関する情報。

Abocom CWB1000についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAbocom CWB1000の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAbocom CWB1000で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)