AT&T TL-210 WHの取扱説明書

12ページ 0.12 mb
ダウンロード

ページに移動 of 12

Summary
  • AT&T TL-210 WH - page 1

    USER ’ S MANU AL Pa r t 2 AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones. © 2000 Advanced American Telephones. All rights reserved. Printed in China. 850005208 Issue 2AT&T 12/00 TRIMLINE ® Memor y T elephone 210 Please also read Part 1 — Important Product Information. ...

  • AT&T TL-210 WH - page 2

    T ABLE/DESK INST ALLA TION This telephone includes a 7-foot line cord with a modular plug on each end. Use this cord to connect the telephone to a modular jack. 1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location. Reinst ...

  • AT&T TL-210 WH - page 3

    W ALL INST ALLA TION 1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location. 2 Reverse handset tab To install the telephone on a wall jack, you must reverse the small tab beneath the directory card. This tab holds the hands ...

  • AT&T TL-210 WH - page 4

    3 4 Install telephone base on wall jack Hold the base up next to the wall jack, and plug in the line cord (Figure 3). Then push the base against the wall jack and down until it is held securely by the mounting studs. NOTE: If you cannot fit the base onto the wall jack, remove the four non-slip pads. 5 Set DIAL mode switch Refer to Step 4 in “Tabl ...

  • AT&T TL-210 WH - page 5

    4 OPERA TION Redial This telephone stores in memory the last phone number dialed. However, if the phone is unplugged from the line jack for 30 minutes or more, redial memory will be lost. The redial memory can accept numbers up to 31 digits long. The number will remain in memory until you change it by dialing another telephone number. To dial the s ...

  • AT&T TL-210 WH - page 6

    5 Mute While on a call, press to mute the microphone. The other party cannot hear you, but you can hear the other party. Press again to return to two-way conversation. Ringer V olume The RINGER volume switch allows you to turn the telephone ringer OFF, or set it to ring at LO or HI volume. You can dial or answer calls normally when the ringer is of ...

  • AT&T TL-210 WH - page 7

    6 T emporar y T one Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some tone-activated computer systems (e.g., telephone banking). To change from pulse (rotary) to tone dialing during a call: 1 Dial a telephone number with the DIAL switch set to DP (p ...

  • AT&T TL-210 WH - page 8

    7 MEMOR Y DIALING Memory Features This telephone can store up to 13 different phone numbers, each up to 21 digits long. Numbers will remain stored in memory unless you erase or change them by entering other numbers. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a hal ...

  • AT&T TL-210 WH - page 9

    One-T ouch Dialing Three numbers can be stored in one-touch memory locations . You can dial these numbers by pressing one of the buttons marked with an emergency symbol ( , or ). To program numbers into memory 4 Enter telephone number. You will hear a click when each button is pressed. 5 Press 6 Hang up after the number is entered correctly. 7 Repe ...

  • AT&T TL-210 WH - page 10

    Speed Dialing Ten telephone numbers can be stored in standard speed-dialing locations. You can dial any of these numbers by pressing two buttons. To program numbers into memory 1 Lift the handset. 2 Press . 3 Press . 4 Enter a digit (0-9) for the memory location where the number is to be stored. 5 Enter telephone number. You will hear a click when ...

  • AT&T TL-210 WH - page 11

    10 IN CASE OF DIFFICUL TY If you have difficulty operating this phone, try the suggestions below. For Customer Service, visit our website at www.telephones.att.com or call 1 800 222-3111. Please retain your receipt as your proof of purchase. No Dial Tone • Make sure all plugs are connected properly. Inspect the line cord connections at the modula ...

  • AT&T TL-210 WH - page 12

    11 Telephone Does Not Ring • Make sure the RINGER volume switch is not set to OFF . • You may have inadvertently turned off the ringer. Press , , , . • If there are several other phones on the same line, try disconnecting some of the other telephones. Having too many telephones can also create problems such as low ringer volume or impaired qu ...

メーカー AT&T カテゴリー Telephone

AT&T TL-210 WHのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- TL-210 WHの取扱説明書
- AT&Tの製品カード
- パンフレット
- またはAT&T TL-210 WHの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、AT&T TL-210 WHの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、AT&T TL-210 WHの取り付け説明書、サービスマニュアル、簡易説明書、またはAT&T TL-210 WHのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、AT&T TL-210 WHの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

AT&T TL-210 WHデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAT&T TL-210 WHを使用するのを助ける技術的文書のことです。説明書は通常、全てのAT&T TL-210 WHユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

AT&Tの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. AT&T TL-210 WHの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAT&T TL-210 WHの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。AT&T TL-210 WHに関してこのドキュメントで見つけることができる全てのヒントの目次
3. AT&T TL-210 WHデバイスの基本機能を使うにあたってのヒント。 AT&T TL-210 WHのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。AT&T TL-210 WHに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAT&T TL-210 WHのメーカー/サービスへの連絡先に関する情報。

AT&T TL-210 WHについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAT&T TL-210 WHの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAT&T TL-210 WHで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)