-
Zanussi ZWI 71201 WA - page 1
EN User manual Washing Machine ZWI 71201 WA ZWI 71401 WA ...
-
Zanussi ZWI 71201 WA - page 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Person ...
-
Zanussi ZWI 71201 WA - page 3
not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from ho- ses and their connections after the installation. • If the appliance is installed in a loca ...
-
Zanussi ZWI 71201 WA - page 4
Product description 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adju stable fe et 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the ...
-
Zanussi ZWI 71201 WA - page 5
1 3 2 4 5 6 7 9 10 8 1 Programme selector dial 2 SPIN reduction button 3 OPTIONS button 4 PREWASH button 5 EASY IRON button 6 EXTRA RINSE button 7 START/PAUSE button 8 DELAY START button 9 DOOR LOCKED pilot light 10 Display Programme selector dial, spin sp eed button and available options Programme Selector Dial It allows you to switch the applianc ...
-
Zanussi ZWI 71201 WA - page 6
Delay Start The programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Door locked pilot light The pilot light 9 illuminates when the programme starts and indicates if the door c an be opened: • light on: the door cannot be opened. The machine is working or has stopp ...
-
Zanussi ZWI 71201 WA - page 7
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment Synthetics 5–6–7 60° - 30° Main wash - Rinses Maximum spin speed at 900 rpm Max. load 3 kg - Reduced load 1.5 kg Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses. ...
-
Zanussi ZWI 71201 WA - page 8
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Deterg ent Compartment Specials 14–Jeans 40° Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 3 kg With this programme it is possible to wash items like trou- sers, shirts or jackets in denim and also jersey real ...
-
Zanussi ZWI 71201 WA - page 9
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment 17–Mini 30’ Main wash - Rinses Maximum spin speed at 700 rpm Max. load 3 kg Quick washing programme for cotton and synthetic items which are lightly soiled or only need freshening up. Extra 18–Rinse ...
-
Zanussi ZWI 71201 WA - page 10
Helpful hints and tips Sorting out the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, wool- lens. Before loading the laundry Never wash whites and coloureds together. Whites may lose their whiteness in the wash. New colo ...
-
Zanussi ZWI 71201 WA - page 11
• you are washing a small load • the laundry is lightly soiled • large amounts of foam form during washing. Degrees of water hardness Water hardness is classified in so-called “degrees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply com- pany, or from your local authority. If ...
-
Zanussi ZWI 71201 WA - page 12
Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment or in the appropriate com- partment if the selected programme/option it requires (see more details in "D etergent dispenser drawer"). If required, pour fabric ...
-
Zanussi ZWI 71201 WA - page 13
Important! • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the wash- ing machine to PAUSE by pressing button 7 and wait a few minutes before opening the door. After you have closed the door, press the same ...
-
Zanussi ZWI 71201 WA - page 14
External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispens er drawer The washing powder and additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch down- wards and by pulling it out. Flush it out under a tap, to remove any traces of acc ...
-
Zanussi ZWI 71201 WA - page 15
Put the cap back on the emergency emptying hose and place the latter back in its seat. Replace the filter int o the pump by inserting it cor- rectly into the special guides. Screw the pump cover firmly by turning it clockwise. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never rem ...
-
Zanussi ZWI 71201 WA - page 16
• replace the emergency emptying hose in its seat after having plugged it; • screw the pump cover again and close the door. Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ...
-
Zanussi ZWI 71201 WA - page 17
Problem Possible cause/Solution The machine does not empty a nd/or does not spin: The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. • Clean the drain filter. An option or a programme that ends with the water still in the tub or a that eliminates all the spinning phases has been selected. • S ...
-
Zanussi ZWI 71201 WA - page 18
Problem Possible cause/Solution The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The support feet have not been adjusted • Check the correct levelling of the appliance. The laundry is not evenly distributed in the drum. • Red istri bute th e la undry . Maybe ...
-
Zanussi ZWI 71201 WA - page 19
Water supply pressure Minimum Maximum 0,05 MPa 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1200 rpm (ZWI71201WA) 1400 rpm (ZWI71401WA) Consumption values Programme 1) Energy consumption (KWh) 2) Water consumption (litre) 2) White Cottons 90 °C 2.2 72 Cottons 60 °C 1.35 67 Cottons 40 °C 0.85 67 Synthetics 40 °C 0.55 42 Delic ates 40 °C ...
-
Zanussi ZWI 71201 WA - page 20
Unscrew the three bolts with the supplied spanner. Slide out the relevant plas- tic spacers. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is no ...
-
Zanussi ZWI 71201 WA - page 21
The other end of the inlet hose which connects to the appliance can be turned as showe d in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to ...
-
Zanussi ZWI 71201 WA - page 22
If the outlet spigot has not been used before, remove any blanking plug that may be in place. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see above) to prevent waste from the s ink enter - ing the appliance. If you intend to drain the hose from the machine into a sink, make sure that the si ...
-
Zanussi ZWI 71201 WA - page 23
A 600 596 555 170 75 176,5 416 100 60 818 min. 820 min. 560 When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped. B 1 2 3 7 5 6 4 8 Caution! Do not remove the screw 8 ! Prepara ...
-
Zanussi ZWI 71201 WA - page 24
D 4 6 8 Caution! Do not remove the screw 8 ! d) Counter-magnet (6) The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, it is neces- sary to screw the counter-magnet (6) (steel disk + rub- ber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the applia ...
-
Zanussi ZWI 71201 WA - page 25
Drill four fixing holes see Fig. G Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to al- low a small strip of beading to be fitted in front of the appliance feet. Graphic H 600-605 490 5 x 25 x 605 Hardwood strip 5 mm x 25 mm Fix the b ...
-
Zanussi ZWI 71201 WA - page 26
26 www.zanussi.com ...
-
Zanussi ZWI 71201 WA - page 27
27 www.zanussi.com ...
-
Zanussi ZWI 71201 WA - page 28
www.zanussi.com/shop 132929830-A-502011 ...
Zanussi ZWI 71201 WAについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもZanussi ZWI 71201 WAの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがZanussi ZWI 71201 WAで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。