-
StarTech.com ARMPIVOTE - page 1
Manual Revision: 06/19/2014 For the most up-to-date information, please visit: www.startech.com ARMPIVOTE *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr .startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.sta ...
-
StarTech.com ARMPIVOTE - page 2
Instruction Manual FCC C ompliance Statement This equipment has been tested and f ound to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules . These limits are desig ned to provide reasonable protection against harmful interference in a residential installation. This equipment generates , uses and can radiate ...
-
StarTech.com ARMPIVOTE - page 3
Instruction Manual i T able of C ontents Introduction ............................................................................................ ii Packaging Conten ts ................................................................................................................................. ii Product Diagram ............................... ...
-
StarTech.com ARMPIVOTE - page 4
Instruction Manual ii Introduction Packaging C ontents 13 Plastic Gasket Cushion Qty .2 ...
-
StarTech.com ARMPIVOTE - page 5
Instruction Manual 1 P roduc t Diag ram ...
-
StarTech.com ARMPIVOTE - page 6
Instruction Manual 2 Installation Desk / Grommet Mounting The Monitor Arm can be clamped to a desk / table, or mount ed through a grommet hole. Instructions for both will be provided in the steps below . 1. Desk / Grommet Clamp: Remove the L eft Cover and insert the L Plate portion of the Clamp (4) into the base of the P ole (3) before replacing th ...
-
StarTech.com ARMPIVOTE - page 7
Instruction Manual 3 2. Desk Clamp: Attach the bottom portion of the Clamp (4) to the L Plate, then plac e the Clamp (4) opening around the edge of your desktop in y our desired location and tighten by hand to secure . Ensure that the Clamp is making full contact with the desk surface. Grommet Clamp: Place the L Plat e through the grommet hole of y ...
-
StarTech.com ARMPIVOTE - page 8
Instruction Manual 4 Attaching the Display 1. Carefully place your displa y face down on a protective surface to access the mounting points. 2. Depending on the depth of the mounting holes on your display , attach the display to the Gas Spring Arm (1) using either the M4x12mm (11) screws, or the M4x25mm (12) screws with spacers (10). Tighten using ...
-
StarTech.com ARMPIVOTE - page 9
Instruction Manual 5 Attaching the Gas Spring Arm Assembly 1. Slide the Extension Arm (2) down onto the P ole (3) . 2. Slide the Gas Spring Arm (1) onto the Extension Arm (2). 3. Place the Cov er and Bolt (9) ont o the Gas Spr ing Arm (1) and press the bolt do wn to secure the two arms together . ...
-
StarTech.com ARMPIVOTE - page 10
Instruction Manual 6 Note: When attaching cables and routing thr ough the cable management channels, ensure that you leav e enough slack to avoid stretching / pulling out the cables when moving the arm. 1. Connect your cables to your display and position the moun ting arm in its fully extended position to ensure that the cables you ar e using are l ...
-
StarTech.com ARMPIVOTE - page 11
Instruction Manual 7 4. Use the Cable Clip (7) to secure the displa y cables to the pole. W ARNING! For ced movement of the L CD Arms or Mount Brackets without loosening the screws may damage the pr oduc t or the mounted displa ys. Always support your display from underneath when making any adjustments to the L CD Arms or Mount Brackets to avoid da ...
-
StarTech.com ARMPIVOTE - page 12
Instruction Manual 8 T o increase / decrease the tilt resistance, adjust the set scr ew located on the side of the Mount Bracket joint, using the 6mm Allen Wrench (6). T o increase / decrease the Gas Spring Arm resistance, adjust the set screw located a t the elbow of the articulating arm, using the 4mm Allen W rench (5). ...
-
StarTech.com ARMPIVOTE - page 13
Instruction Manual 9 Specications W eight Capacity 11 lbs (5 kg) Max Display Size 24” VESA Compatibility 75 x 75 mm and 100 x 100 mm Maximum Extension 22.05 in (560mm) Maximum Mounting Surface T hick ness 2.95 in (75 mm) ...
-
StarTech.com ARMPIVOTE - page 14
Instruction Manual 10 T echnical Suppor t StarT ech.com’ s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your pr oduc t, visit ww w .star tech.c om/suppor t and access our compr ehensive selection of online tools, documentation, and downloads. For the la test dri ...
-
StarTech.com ARMPIVOTE - page 15
Hard-to-nd made easy . At StarT ech.com, that isn ’t a slogan. It ’ s a promise. StarT ech.com is your one-stop source for every connectivity par t you need. F rom the latest technology to legacy products — and all the parts that bridge the old and new — we can help you nd the parts that connect your solutions. We make it easy t o loc ...
StarTech.com ARMPIVOTEについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもStarTech.com ARMPIVOTEの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがStarTech.com ARMPIVOTEで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。