Dynacord 315の取扱説明書

24ページ 3.27 mb
ダウンロード

ページに移動 of 24

Summary
  • Dynacord 315 - page 1

    P o w erSub 315 1000 W A T TS POWERED SUBWOOFER 2x500 W A T TS SA TELLITE SPEAKER OUTPUTS Owner‘s Man ual | Bedienungsanleitung ...

  • Dynacord 315 - page 2

    2 INHAL TSVERZEICHNIS WICHTIGE SICHERHEITSHINWEISE ....................... 3 WICHTIGE SERVICEHINWEISE ....................... 3 BESCHREIBUNG ....................... 4 AUSP ACKEN & GARANTIE ....................... 4 QUICK ST ART ....................... 5 BEDIENELEMENTE ....................... 6 LEFT INPUT / RIGHT INPUT ....................... 6 ...

  • Dynacord 315 - page 3

    WICH TIGE SIC HERHEITS HINWEIS E 1. Lesen Sie diese Hinweise. 2. Heben Sie diese Hinweise au f. 3. Beachten Sie alle W arnungen. 4. Richten Sie sich nach den Anweisungen. 5. Betreiben Sie das Gerät nicht in unmittelbare r Nähe von W asser . 6. V erwenden Sie zum Re inigen de s Ge rätes au sschließ lich ein trocken es T uch. 7. V erdecken Sie ke ...

  • Dynacord 315 - page 4

    4 BESCHREIBUNG Herzlichen Glückwunsch! Sie haben sich mit dem PowerSub 315 von Dynacord für einen aktiven Subwoofer modernster T echnolo- gie entschieden. Der aktive 15“ Subwoofer PowerSub 315 mit vier integrierten Digitalendstufen mit einer Gesamtleistung von 2000W wurde speziell zum schnellen und einfachen Aufbau von Subwoofer-Satelli- ten-Sy ...

  • Dynacord 315 - page 5

    5 QUICKST ART Achtung: Nach dem Aufbau der Anlage schalten Sie zuerst das Mischpult ein und schieben Sie die Masterfader am Mischpult auf den untereren Anschlag. Anschliessend können Sie den PowerSub 315 einschalten und mit den Ausgangsfadern die ge- wünschte Lautstärke einstellen. Ungewollt könnten Sie sonst bei eingeschalteter Signalquelle se ...

  • Dynacord 315 - page 6

    6 LEFT INPUT , RIGHT INPUT Elektronisch symmetrische Eingänge zum Anschluss an hochpegelige Signalquellen wie z.B. Mischpult- ausgänge. Der Anschluß kann dabei wahlweise über Klinken- oder XLR-Stecker vorgenommen werden. Um etwaigen externen Brumm-, oder Hochfrequenzein- streuungen vorzubeugen, sollte die Signaleinspeisung bevorzugt über hochw ...

  • Dynacord 315 - page 7

    7 X-OVER Mit diesem Schalter können Sie die T rennfrequenz zwischen dem Sub- woofer und den Mittel-Hochton Satellitenboxen verändern. Die Werks- einstellung ist 100Hz und besonders für 12“ Satellitenboxen geeignet. Für T opteile mit 10“ oder 8“ Lautsprechern ist die 160Hz Einstellung vorteilhaft um eine mechanische Überlastung der kleine ...

  • Dynacord 315 - page 8

    8 POWER Netzschalter zum Ein- und Ausschalten des Gerätes. Der Netzschalter ist beleuchtet, wenn der PowerSub 315 eingeschaltet ist. Sollte der Schalter nach dem Einschalten nicht leuchten, prüfen Sie zuerst ob das Netzkabel angesteckt und verriegelt ist. Ist dies der Fall und trotzdem keine Funktion vorhanden, kontaktieren Sie bitte ihren Fachh? ...

  • Dynacord 315 - page 9

    Notes ...

  • Dynacord 315 - page 10

    10 CONTENTS IMPORT ANT SAFETY INSTRUCTIONS ....................... 1 1 IMPORT ANT SERVICE INSTRUCTIONS ....................... 1 1 DESCRIPTION ....................... 12 UNP ACKING & WARRANTY ....................... 12 QUICK ST ART ....................... 13 CONTROLS ....................... 14 LEFT INPUT / RIGHT INPUT ....................... 14 ...

  • Dynacord 315 - page 11

    IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructi ons. 3. Heed all warnin gs. 4. Follow all instructio ns. 5. Do not use this appa ratus near water. 6. Clean only with a dry cloth. 7 . Do not cover any ve ntilation openings. Install in accordance with the manufacturer’ s instruct ions. 8. Do not install near heat s ...

  • Dynacord 315 - page 12

    12 DESCRIPTION Congratulations! With buying a Dynacord PowerSub 315 you have chosen a state-of-the-art active subwoofer that employs most advanced technology . The active 15” subwoofer PowerSub 315 with four integrated digital power amps provides total output power of 2000W and has been designed for the quick and easy set-up of subwoofer satellit ...

  • Dynacord 315 - page 13

    13 QUICKST ART Caution: After system installation is complete, make sure to  rst power on the mixing console and to position the master faders at their lowest setting before switching the power of the PowerSub 315 to On. Use the output faders to establish the desired volume setting. Otherwise, switching and power-on noise or the high level audio ...

  • Dynacord 315 - page 14

    14 LEFT INPUT , RIGHT INPUT Electronically balanced inputs for the connection of high-level signal sources, like for example mixer outputs. Connecting signal sources via phone or XLR-type plug is equally possible. However , to avoid possible external hum and RF-interference, using high quality , high-performance shielded audio cables with XLR- type ...

  • Dynacord 315 - page 15

    15 X-OVER This switch lets you control the X-over frequency between subwoofer and Mid-High-range satellite cabinets. The factory setting (100Hz) is ideally suited for 12” satellite speaker systems. The 160Hz setting matches top cabinets and protects the 10” or 8” transducers’ diaphragms from mechanical overload. When employing top cabinets ...

  • Dynacord 315 - page 16

    16 POWER Mains switch to power ON/OFF the unit. The mains switch lights when the PowerSub 315 is powered on and operational. If, after power on, the switch does not light, make sure the mains cord is correctly plugged in and locked in place. If the cord is correctly connected and operation is still not possible, contact your dealer . MAINS IN Mains ...

  • Dynacord 315 - page 17

    17 Abmessungen / Dimensions (in mm) Speci cations PowerSub 315 Ampli er PowerSub 1000 W / 8 Ohms (switchable to 2 x 500 W / 4 Ohms) Ampli er Power MID-HIGH 2 x 500 W / 4 Ohms SPL 1W/1m 99 dB Max. SPL 1m (calculated) 129 dB Sub T ransducer LFS 1008 (364 853) Switchable X-Over Frequencies 80 Hz, 100 Hz, 160 Hz Dimensions W x H x D 464 x 601 ...

  • Dynacord 315 - page 18

    18 BLOCK DIAGRAM ...

  • Dynacord 315 - page 19

    19 Cabinet Ty pes : A mp lifiers : Controllers : Cables : 2x D 12, 1x Pow erSub 31 5, 1x Sub 115 - 2x 4 -pole long, 1 x 4-pole short Horizontal Coverage : Total A mp Power : Ty pical Distance : Options : 2x 8 0° 2x 5 00W + 1000W = 2000W 15 to 20 m 2x PC L 1500 Comments : - A ccessories : Configurations : A CTIVE 2-W AY D-LITE Musicians, Small Club ...

  • Dynacord 315 - page 20

    20 Cabinet Ty pes : A mp lifiers : Controllers : Cables : 2x D 12, 1x Pow erSub 31 5, 2x Sub 115 - 2x 4 -pole long, 2 x 4-pole short Horizontal Coverage : Total A mp Power : Ty pical Distance : Options : 2x 8 0° 2x 5 00 W + 1000 W = 2000 W 15 to 20 m 2x BS 5 0 Comments : 4x D 12 (two o n each side) A ccessories : Configurations : A CTIVE 2-W AY D- ...

  • Dynacord 315 - page 21

    21 Cabinet Ty pes : A mp lifiers : Controllers : Cables : 2x D 12, 2x Sub 115 Powe rMate 10 00-2 2x 4 -pole long, 2 x 4-pole short Horizontal Coverage : Total A mp Power : Ty pical Distance : Options : 2x 8 0° 2x 7 00W = 1400W 15 to 20 m 2x PC L 1500 - Comments : - one ad ded Top or one ad ded Sub can A ccessories : Configurations : FULLRA NGE be ...

  • Dynacord 315 - page 22

    22 NOTES ...

  • Dynacord 315 - page 23

    23 References in accordance with FCC, EN 61000-3-2:2000, EN 61000-3-1 1:2000, EN 55103-1:1997. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated i ...

  • Dynacord 315 - page 24

    DYNACORD 12000 Portland Avenue South, Bur nsville, MN 55337, USA Europe, Africa, and Middle East only. For customer orders, contact Customer Service at: Phone: +1 952/844-4051, Fax: +1 9 52/884-0043 + 49 9421-706 0 Fax: +49 9421-706 265 Asia & Pacific on ly. For customer orde rs, contact Customer Service at: www.dynacord.com +65 6571 2534 Fax: ...

メーカー Dynacord カテゴリー Speaker

Dynacord 315のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 315の取扱説明書
- Dynacordの製品カード
- パンフレット
- またはDynacord 315の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Dynacord 315の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Dynacord 315の取り付け説明書、サービスマニュアル、簡易説明書、またはDynacord 315のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Dynacord 315の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Dynacord 315デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがDynacord 315を使用するのを助ける技術的文書のことです。説明書は通常、全てのDynacord 315ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Dynacordの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Dynacord 315の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははDynacord 315の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Dynacord 315に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Dynacord 315デバイスの基本機能を使うにあたってのヒント。 Dynacord 315のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Dynacord 315に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるDynacord 315のメーカー/サービスへの連絡先に関する情報。

Dynacord 315についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもDynacord 315の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDynacord 315で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)