-
Telex ur-700 - page 1
T elex ® Operating Instructions UR-700 ...
-
Telex ur-700 - page 2
GENERAL INFORMATION The Telex Model UR-700 Receiver and associated Transmitters is a full diversity system operating within the frequency range of 690 to 725 MHz on specific pre-set frequencies. Systems consisting of the UR-700 and its companion transmitter are capable of operating on at least 5 frequencies in a TV channel simultaneously, sometimes ...
-
Telex ur-700 - page 3
Displays 1. A 5 segment LED light array for AF that aids in setting microphone gains and monitoring receiver microphone and line level outputs. Light numbers 4 and 5 have a Peak Hold feature. 2. A 1 segment LED light for RF that aids in checking the transmitter and monitoring for the possibility of initial interference. 3. A 2 segment LED array tha ...
-
Telex ur-700 - page 4
UR-700 Receiver Specifications Frequency Range . . . . . . . . . . . . . . . . . . . . . . . 690-725 MHz R.F. Stability . . . . . . . . . . . . . . . . . . . . . . . . 0.005% or better Modulation Type . . . . . . . . . . . . . . . . . FM, 40 KHz nominal Type . . . . . . . . . . . . . . . . . . Single Conversion, 10.7 MHz I.F. I.F. Bandwidth . . . . ...
-
Telex ur-700 - page 5
Model HT-700 Transmitter Specifications Power Output (Terminated) . . . . . . . . . . . . . . . . . . . . 10 mW, Antenna . . . . . . . . . . . . . . . . . . . . . . . . Permanently attached. Modulation . . . . . . . . . . . . . . . . FM, +/- 40 KHz Deviation, 50 us pre-emphasis. Frequency Response (System) . . . . . . . . 50 Hz to 15000 Hz Micropho ...
-
Telex ur-700 - page 6
Model WT-700 Transmitter Specifications Power Output (Terminated) . . . . . . . . . . . . . . . . . . . . . 10 mW Antenna . . . . . . . . . . . . . . . . . . . . . . . . Permanently attached Modulation . . . . . . . . . . . . . . . . . FM, +/- 40 KHz Deviation, 50 us pre-emphasis. Frequency Response (System) . . . . . . . . 50 Hz to 15000 Hz Microp ...
-
Telex ur-700 - page 7
Figure 1 Front Panel Power Switch: When turned on, one of the diversity lights will illuminate. RF Display: A 1-segment LED Display indicates the presence of the signal from the transmitter. Diversity Display: LED’s indicate diversity operation. AF Display: A 5-segment 3 color LED Display indicates the relative modulation of the microphone. Squel ...
-
Telex ur-700 - page 8
Figure 2 Rear Panel Antenna Jacks: Two antenna jacks for posi phase diversity recep - tion. Attach an antenna to each jack. Mic Level: XLR type jack connects to balanced mic input of audio sound system (Amplifier/Mixer). Pin 1 ground, Pin 2 +, Pin 3 -. Line Level: 1/4" jack with screwdriver adjustable unbalanced audio output. Use supplied scre ...
-
Telex ur-700 - page 9
Receiver Set-up Connect the supplied AC power adapter to an AC outlet supplying 105 to 125 volts AC, 60 Hz. The 230 volt export model should connect to an AC outlet supplying 210-240 VAC, 50-60 Hz. Connect the UR-700 to your equipment: Insert the appropriate audio connector and cable into the mic or line receptacle on the rear of the UR-700. Insert ...
-
Telex ur-700 - page 10
Figure 4 HT-700 HT-700 Power and Mute Switches: Located on the bottom of the handle. Microphone Gain: Controls the gain of the audio circuit to prevent under or over modulation. Set-Up NOTE: Do not use carbon-zinc batteries. 8.4 volt Ni-Cad batteries may be used but will yield shorter run times. Unscrew the handle and install a 9 volt alkaline batt ...
-
Telex ur-700 - page 11
Figure 5 WT-700 WT-700 Power and Audio Switches: Located on the top of the case. Microphone Gain: Controls the gain of the audio circuit to prevent under or over modulation. Microphone Jack: wired as follows: Pin 1 Ground Pin 2 Mic Pin 3 +5 volt bias Pin 4 +5 volt bias fed through a 3K ohm resistor for 2 wire electrets. -10- ...
-
Telex ur-700 - page 12
Set-Up NOTE: Do not use carbon-zinc batteries. 8.4 volt Ni-Cad batteries may be used but will yield shorter run times. Open the battery door and install a 9 volt alkaline battery. Be sure the battery polarity matches the diagram inside the battery holder. Close the battery door. Insert the microphone plug into the connector. Do not turn on at this ...
-
Telex ur-700 - page 13
The RF light on the receiver should now be illuminated. Turn on the audio (mic) switch. Speak into the microphone and adjust its gain so that the Audio Meter on the receiver just illuminates the 0 (or yellow) light on the loudest sounds. If necessary, vary the line level on the back of the receiver to suit your equipment. Walk the transmitter throu ...
-
Telex ur-700 - page 14
The diversity antenna system operates most efficiently when the two antennas are separated as much as possible. The antennas should be mounted so that they are at least 6 feet (2 meters) apart for best results. They should be at least 2 feet (60 cm) from nearby objects. Accessories for remote antenna mounting are listed in the back of this manual. ...
-
Telex ur-700 - page 15
Figure 7 Antenna Placement with Accessory Brackets and Cables If possible, do not mount the brackets on a wall. See Figure 7 for bracket and antenna placement. Antenna Connection Attach the two antenna cables to the back of the UR-700. Be sure the connectors are tightened securely. Route the cable to the antennas and attach in the same manner. -14- ...
-
Telex ur-700 - page 16
Installing Rack Mounts The UR-700 is supplied with rack mounts for both double and single mounting in a 19" equipment rack. For single mounting, the long and short rack “ears” are used. For dual mounting, use the short “ears and the mid brackets from two UR-700’s. Figure 8 Assembly of Rack Mount Assembly To assemble the rack mount to t ...
-
Telex ur-700 - page 17
Double Mounting: Align the mid brackets (Item No. 2) with the holes on the adjacent sides of each unit. Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining holes. Tighten all screws securely. Place the two assemblies side by side with the mid brackets together. (The left brack ...
-
Telex ur-700 - page 18
ACCESSORIES AND REPLACEMENT PARTS Model AB-2 Combination Antenna Bracket with hardware and 10 foot (3 meter) coaxial cable TNC Connectors. Use with Model CAL-5 Antenna. Order No. 71138000 AC Power Supplies 120 V olt, 60 Hz 730131 230 V olt, 50 Hz U.K. 730103-1 230 V olt, 50 Hz Euro. 730104-1 1/4 Wave Replacement Antenna Part No. 879010 Model CLA-5 ...
-
Telex ur-700 - page 19
Model ALP-450 450-900 MHz Directional Log Periodic Antenna includes mounting hardware and 10 foot (3 meter) coaxial cable with TNC Connectors. 9 1/2" long x 11" high. Unique forward coverage pattern increases signal gain up to 5 db. Covers all frequencies and increases range. Order No. 71147000 Model UAD-2 Four Way Antenna Splitter Order ...
-
Telex ur-700 - page 20
FCC INFORM ATION The TELEX Receiver UR-700 is authorized under Part 15 of the Federal Communication Commission. Licensing of TELEX equipment is the user’s responsibility and licensability depends upon the user’s classification, and frequency selected. TELEX strongly urges the user to contact the appropriate telecommunications authority before o ...
-
Telex ur-700 - page 21
CUSTOMER SERVICE INFORM ATION If your receiver or transmitter should need servicing under the warranty, please contact: Customer Service Department TELEX COMMUNIC ATIONS, INC. 8601 East Cornhusker Highway, P.O. Box 5579, Lincoln, Nebraska 68505-5579 U.S.A. Phone: (402) 467-5321 or 465-7021 FAX: (402) 467-3279 All claims of defect or shortage should ...
-
Telex ur-700 - page 22
PN 801347 APRIL 1998 TELEX COMMUNICATIONS, INC. 8601 East Cor nhusker Highway w P.O. Box 5579 w Lincoln, Nebraska 68505-5579 ...
Telex ur-700についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもTelex ur-700の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがTelex ur-700で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。