Alto Contractor Dieselの取扱説明書

16ページ 0.18 mb
ダウンロード

ページに移動 of 16

Summary
  • Alto Contractor Diesel - page 1

    CONTRACT OR DIESEL Instruktionsbog ............................. 1 - 12 Instruksjonsbok ............................. 13 - 24 Instruktionsbok ............................. 25 - 36 DA SV NO Instruction manual ........................ 37 - 48 Betriebsanleitung .......................... 49 - 60 Manual d ’Instructions.................... 61 - 72 Geb ...

  • Alto Contractor Diesel - page 2

    37 Congratulations! We’d like to say, “Thank You” for choosing the CONTRACTOR DIESEL. This instruction ma- nual is provided with your new High Pressure Washer to ensure that you obtain the best results, in the safest manner, with your new machine. IMPOR T ANT This machine is a High Pressure Washer, capable of producing 2600 psi (180 bar). Rea ...

  • Alto Contractor Diesel - page 3

    38 1.0 Safety E N 11. The machine must not be used in surroundings with risk of fire or explosion. 12 . Exhaust from engine and burner contains poisonous carbon monoxide gases. Avoid inhalation of exhaust gases. Never run the machine in a closed garage or confined area. 13. To prevent fire hazards and to provide adequate ventilation, keep the engin ...

  • Alto Contractor Diesel - page 4

    39 2.0 Motor Protection Device 3.0 Ke y photo’s E N The diesel engine is equipped with a protection device called ”Oil Alert”, which stops the engine if the oil level is insufficient. If this occurs, check the engine for leaks, and after making sure the machine is level, refill it to the proper level. The engine can then be restarted. (See dr ...

  • Alto Contractor Diesel - page 5

    40 4. 0 Application E N 6.0 Accessories E N ALTO’s diesel powered high pressure washers can be used for all outdoor cleaning jobs for which steam, hot or cold water is used. Detergents can be used (see section 8.5) 4 .1 Handling and T ransport When handling the machine with a fork lift truck, be sure the forks extend completely under the machine ...

  • Alto Contractor Diesel - page 6

    41 a Inlet quick-connector b Water filter c High pressure pump d Unloader/regulator (recycling valve) e Flow switch f Throttle valve g Flow switch h Burner coil i Temperature sensor j Outlet quick-connector k Spray handle I Double spray lance m Fuel tank ”Jerry-can” n Burner fuel filter o Fuel pump p Magnetic solenoid valve q Fuel nozzle r Blow ...

  • Alto Contractor Diesel - page 7

    42 Functional description E N 7. 4 Spray lance The double spray lance is fitted with 2 nozzles, a high pressure nozzle and a low pressure nozzle. When the pressure adjustment valve (pos. 27) is completely closed only the high pressure nozzle is used. Both the high pres- sure nozzle and the low pressure nozzle are used when the pressure adjustment v ...

  • Alto Contractor Diesel - page 8

    43 8.0 Connections E N 8 . 4 Suction Mode The machine is self priming, when used from a tank or stream, etc. The inlet hose must be filled with water before starting up. The self priming height depends on the water temperature. Max. self priming height of 5 m (17 ft) is reached with cold water (up to 8°C/47°F). Foreign material in the water suppl ...

  • Alto Contractor Diesel - page 9

    44 9 .0 Operating instructions E N d ) Start the machine, if stopped, and activate the spray handle to start the burner. IMPORTANT: For safety reasons it is important that instruction (a), above, always be followed! Note: If the engine stops immediately after having been started up, it should be checked whether the throttle control is set at idle s ...

  • Alto Contractor Diesel - page 10

    45 10.0 Storage/frost proofing 11.0 Model tag It is advisable to store the machine in a frost proof place between operations. If this is not possible the machine should be protected in the following way: 1. Disconnect the inlet hose. Remove the lance (pos. 29) and empty it of water. 2. Ensure that the thermostat is set in the blue field, and start ...

  • Alto Contractor Diesel - page 11

    46 12.0 Maintenance E N 2. ENGINE OIL CHANGE Refer to the Ruggerini engine manual for break- in and normal operating oil change requirements. Carry out first oil change after i0 hours of operation and then every 100 hours. Not less than once every six months, however. NOTE: Protect the environment by properly disposing of used pump and engine oil. ...

  • Alto Contractor Diesel - page 12

    47 Maintenance E N 13.0 W arranty E N 5. Leave the machine for 20 minutes. 6. Start the machine and pump the used solution into a container for proper disposal. 7. Immediately connect a fresh water supply and turn it on. 8. Start the machine, let it work for 5-10 minutes, until all the scale remover is out of the system. 9. If necessary, repeat the ...

  • Alto Contractor Diesel - page 13

    14.0 T r oubleshooting E N Fault Cause Repair The engine fails to start Insufficient diesel supply Refill diesel tank. Battery run down Recharge the battery*) Fuse blown Exchange fuse. See section 3.0. The pump is frozen Let the pump thaw. Working pressure too high Nozzle partly blocked Clean the nozzle. See section 12.6. Working pressure Valve for ...

  • Alto Contractor Diesel - page 14

    ...

  • Alto Contractor Diesel - page 15

    ...

  • Alto Contractor Diesel - page 16

    AL T O Danmark A/S Industrikvar teret DK-9560 Hadsund T el.: +45 7218 2100 www .alto-online.dk Printed in Denmar k Copyright © 2003 AL TO Danmark A/S 6229952 (02.2003) ...

メーカー Alto カテゴリー Pressure Washer

Alto Contractor Dieselのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Contractor Dieselの取扱説明書
- Altoの製品カード
- パンフレット
- またはAlto Contractor Dieselの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Alto Contractor Dieselの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Alto Contractor Dieselの取り付け説明書、サービスマニュアル、簡易説明書、またはAlto Contractor Dieselのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Alto Contractor Dieselの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Alto Contractor Dieselデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAlto Contractor Dieselを使用するのを助ける技術的文書のことです。説明書は通常、全てのAlto Contractor Dieselユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Altoの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Alto Contractor Dieselの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAlto Contractor Dieselの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Alto Contractor Dieselに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Alto Contractor Dieselデバイスの基本機能を使うにあたってのヒント。 Alto Contractor Dieselのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Alto Contractor Dieselに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAlto Contractor Dieselのメーカー/サービスへの連絡先に関する情報。

Alto Contractor Dieselについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAlto Contractor Dieselの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAlto Contractor Dieselで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)