Smeg GCS70XGの取扱説明書

17ページ 0.62 mb
ダウンロード

ページに移動 of 17

Summary
  • Smeg GCS70XG - page 1

    Contents 21 1 INSTRUCTIONS FOR SAFE A ND PROPER USE ____________________ 22 2 POSITIONING OF THE HOB ____________________________________ 24 3 ELECTRICAL CONNECT ION ____________________________________ 26 4 GAS CONNE CTION ___________________________________________ 27 5 ADAPTATION TO DIFFER ENT TYPES OF GAS _____________________ 29 6 FINAL OPER A ...

  • Smeg GCS70XG - page 2

    Introduction 22 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKING HOB. ALSO KEEP THE SERIES OF NOZZLES SUPP ...

  • Smeg GCS70XG - page 3

    Introduction 23 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST NOT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE HOB. DO NOT PUT PANS WITHOUT PERFECTLY SMOOT ...

  • Smeg GCS70XG - page 4

    Instructions for the installer 24 2 POSITIONING OF THE HOB The following operation requires build i ng and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such a s masonry, metal, solid wood or plastic lamina ted woo d as long as they are heat resistant (T 90°C). Never use sil ...

  • Smeg GCS70XG - page 5

    Instructions for the installer 25 In case of installation on a holl ow compartment with doors, a separating panel has to be pl aced under the hob. Ke ep a minimum distance of 10 mm between the bottom of the unit an d the pa nel surface. The panel has to be easily removable to allow acces s in the event of technical service. ...

  • Smeg GCS70XG - page 6

    Instructions for the installer 26 3 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on t he plate located under the casing. Do not remove this plate for any reason. The plug on th e end of the supply cable and the wall socket must be the same type and conform to the curr ent electrical syste ...

  • Smeg GCS70XG - page 7

    Instructions for the installer 27 4 GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and conforming to the provisions defined by standard regulations in force. To facilitate connection, fitting A on the re ar of the appliance may be adjusted laterally. For this pur pose, loosen hexagon nut B , ...

  • Smeg GCS70XG - page 8

    Instructions for the installer 28 4.1 Connection to LPG Use a pressure regulator and m ake the connection to the tank according to the provisions of standar ds regulations in force. Make sure that feed pressure conforms to t he l evels shown in the tab le in paragraph “5.2 Regulation for LPG”. 4.2 Ventilation of rooms The hob may be installed o ...

  • Smeg GCS70XG - page 9

    Instructions for the installer 29 5 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, disconn ect the appliance from the electrical socket. The hob has been inspected for G20 (2H) natural gas at a pressure of 20 mbar. For functioning with other types of gas the nozzles must be replaced and the primary air adju ...

  • Smeg GCS70XG - page 10

    Instructions for the installer 30 5.2 Regulation for LPG Loosen screw A and push supp ort B all the way. Use a double hea d wrench to remove nozzle C and assemble the suitable one, following the instructions indicated in the re ferenc e charts, with respect to the type of gas to use. The screwing torque of the nozzle should never exceed 3 Nm . Repo ...

  • Smeg GCS70XG - page 11

    Instructions for the installer 31 5.3 Regulation for natural gas The hob has been inspected for G20 (2H) natural g as at a pressure of 20 mbar. To allow the unit to work with thi s type of gas, perform the same operations described i n paragraph “ 5.2 Regulation for LPG”, but choose the nozzles and regulate the primary air for natural gas, as s ...

  • Smeg GCS70XG - page 12

    Instructions for the installer 32 6 FINAL OPERATIONS Having carried out the abov e adjustments, reassemble t he appliance following, backwards, the instructions in paragraph “ 5.1 Removing the hob”. 6.1 Regulation of minimum for natural gas Replace the components on the burner an d slide the knobs on the gas tap pin s. Light the burner and set ...

  • Smeg GCS70XG - page 13

    Instructions for the installer 33 6.3 Arrangement of burners on hob Burners 1. Auxiliary 2. Semirapid 3. Rapid 4. Rapid large 5. Ultra rapid 6. Double crown 7. Fish pan 8. Ultra rapid 9. Double crown 6.4 Lubrication of gas taps After a while, the gas tap may become hard to turn or lock. If this happens, it has to be cleaned inside and re-greased. T ...

  • Smeg GCS70XG - page 14

    Instructions for the user 34 7 USING THE HOB Before turning on the burners, make sure that the bur ner rings, caps and grids have been fitted cor rectly. In the ultrarapid burner, notch A must be aligned wit h pin B . Grid C (where available) is int ended for use with woks (Chinese p ans). Adapter D comes only with open gr ids models and is intende ...

  • Smeg GCS70XG - page 15

    Instructions for the user 35 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottome d, even pans must be used, with covers and proportional in size to the burners (see paragraph “ 7.3 Diameter of the pans”). To avoid overcooking or dam age to the surface to p or to the glass (where ava ...

  • Smeg GCS70XG - page 16

    Instructions for the user 36 8 CLEANING AND MAINTENANCE Never use a steam jet to clean the appliance. Before any intervention, disconnect the power supply of the applia nce. 8.1 Cleaning Clean the cooking top regularl y every time you use it, obviously after it has cooled. 8.1.1 Regular daily cleaning of the hob In order to clean and preserve the s ...

  • Smeg GCS70XG - page 17

    Instructions for the user 37 8.2 Cleaning of cooking hob components CAUTION: do not wash these components in a dishw asher. In normal use of the hob, the stai n less steel burner caps and pa n- stands tend to be burnishe d by the high temperature. Cl ean these parts using very fine abrasive sponges or simil ar commercial products. Then use a specif ...

メーカー Smeg カテゴリー Range

Smeg GCS70XGのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- GCS70XGの取扱説明書
- Smegの製品カード
- パンフレット
- またはSmeg GCS70XGの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Smeg GCS70XGの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Smeg GCS70XGの取り付け説明書、サービスマニュアル、簡易説明書、またはSmeg GCS70XGのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Smeg GCS70XGの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Smeg GCS70XGデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがSmeg GCS70XGを使用するのを助ける技術的文書のことです。説明書は通常、全てのSmeg GCS70XGユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Smegの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Smeg GCS70XGの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははSmeg GCS70XGの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Smeg GCS70XGに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Smeg GCS70XGデバイスの基本機能を使うにあたってのヒント。 Smeg GCS70XGのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Smeg GCS70XGに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるSmeg GCS70XGのメーカー/サービスへの連絡先に関する情報。

Smeg GCS70XGについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもSmeg GCS70XGの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSmeg GCS70XGで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)