TP-Link MC110CSの取扱説明書

20ページ 3.37 mb
ダウンロード

ページに移動 of 20

Summary
  • TP-Link MC110CS - page 1

    User Guide MC100CM MC110CS Fast Ethernet Media Converter MC111CS MC112CS WDM Fast Ethernet Media Converter ...

  • TP-Link MC110CS - page 2

    ...

  • TP-Link MC110CS - page 3

    COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other bra nds and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative su ...

  • TP-Link MC110CS - page 4

    FCC STATEMENT This equipment has been tested and found to co mply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to prov ide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequenc y energy and, if no ...

  • TP-Link MC110CS - page 5

    Any changes or modifications not expressly approved b y the party responsible for compliance could void the user’s authority to op erate the equipment. CE Mark Warning This is a class B product. In a dom estic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. ...

  • TP-Link MC110CS - page 6

    CONTENTS Package contents ........................................................................... 1 Chapter 1 Introduction ............................................................... 2 1.1 Overview of the Converter .......................................... 2 1.2 Conventions ................................................................ 3 ...

  • TP-Link MC110CS - page 7

    1 Package contents The following items should be found in your package: ¾ One Converter ¾ One AC-DC Power Adapter (D C9V/600mA) ¾ One Us er Guide Note: Make sure that the package contains the above items. If an y of the listed items are damaged or missing, please contact your distributor. ...

  • TP-Link MC110CS - page 8

    2 Chapter 1 Introduction Thank you for choosing the MC100CM/MC110CS Fast Ether net Media Converters or the MC111CS/MC112CS WDM Fast Ethern et Media Convert ers ! 1.1 Overview of the Con verter MC100CM and MC110CS are Fast Ethernet Media Converters. MC111CS and MC112CS are WDM Fast Ethernet Media Converters, which adopt WDM (Wavelength Divi sion Mul ...

  • TP-Link MC110CS - page 9

    3 1.2 Conve ntions The Converter mentioned in this guide stands for Fast Ethernet Media Converters or the WDM Fast Ethernet Media Converters without any explanation. The TP port mentioned in this Us er Manual stands for the TX port without any explanations. Note: The four converters are sharing this User Guide. The differences between them please r ...

  • TP-Link MC110CS - page 10

    4 ¾ Connectors : RJ-45, SC. ¾ Network Cables : Cat.5 Twisted-Pair (below abbreviated as TP), 1300nm 62.5/125, 50/125 um Single-mode/Multi-mode fiber. Model NO. Interface Transmission Distance Transmission Media Output Center Wavelength MC100CM RJ45--SC 2km Multi-mode Fiber, TP 1310nm MC110CS-20 RJ45--SC 20km Single-mode Fiber, TP 1310nm MC110CS-4 ...

  • TP-Link MC110CS - page 11

    5 Name Status Indication On Power on PWR Off Power off On The Link Fault Pass Thr ough function enable. LFP Of f The Link Faul t Pass Through f unction disa ble. On There’s a valid link. Flashing The converter is receiv ing or transmitting data from the fiber optic conne ctor. FX Link/Act Off There’s no valid lin k. On The TP port is connecte d ...

  • TP-Link MC110CS - page 12

    6 1.5.2 Switch ¾ TP_AUTO : The TP port operates in Auto-Negotiation mode; ¾ TP_DIS : The TP port operates in FOR CE mode; ¾ TP_100M : The TP port operates in 100Base-Tx; ¾ TP_10M : The TP port operates in 10Base-T mod e; ¾ TP_FDX : The TP port operates in Full-Duplex mode; ¾ TP_HDX : The TP port operates in Half-Duplex m ode; ¾ LFP_OFF : The ...

  • TP-Link MC110CS - page 13

    7 The Mode Of The Device Switc h TP:AUTO; LFP ON TP_AUTO, TP_100M, TP_FDX, LFP_ON TP:AUTO; LFP OFF TP_AUTO, TP_100M, TP_FDX, LFP_OFF TP:FORCE,100M,FULL; LFP ON TP_DIS, TP_100M, TP_FDX, LFP_ON TP:FORCE,100M,FULL; LFP OFF TP_DIS, TP_100M, TP_FDX, LFP_OFF TP:FORCE,100M, HALF; LFP ON (TP_DIS or TP_AUTO), TP_100M, TP_HDX, LFP_ON TP:FORCE,100M, HALF; LFP ...

  • TP-Link MC110CS - page 14

    8 With the Link Fault Pass Throu gh function enabled (optional with switch LFP), TP port and FX port of the same converter will inform each other the fault link status so that when one side of the link fails, the other side will force the link to shut dow n as soon as noticed. The procedure will be illustrated as shown below. If link fail happens o ...

  • TP-Link MC110CS - page 15

    9 Chapter 2 Installation Guide 2.1 Fast Ethernet Media Converter 1. The SC fiber connector of MC 100 CM transmits/receives data by 1310nm short wave laser on multi-mode fiber. 2. The SC fiber connector of MC 110CS transmits/receives data by 1310nm short wave laser on single-mode fiber. Transmits and receives data on different fibers Note: You have ...

  • TP-Link MC110CS - page 16

    10 Transmits and receives data on the same fiber Note: You have to use MC111CS and MC112CS at the same time to cooperate. ...

  • TP-Link MC110CS - page 17

    11 Chapter 3 Configuration In order to achieve the aim of ef fectively expanding a Fast Ethernet network, you can use the converte r like the following examples: 1. Place two converters back to back between the following end devices. Note: You should use two MC100CM Media Converters or two MC110CS Media Converters, or one MC111CS and one MC112CS to ...

  • TP-Link MC110CS - page 18

    12 3.1 Inst allation Procedure Use a fiber cable to connect two c onverters, or connect a converter with a 100Base-FX Device. 1. Connection of a Converter and a 10/100Base-TX Device (HUB or Switch). • Make sure that the length of the Cat.5 t wisted pair cable between the 10/100Base-TX devic e and the converter is less than 100 meters. • Connect ...

  • TP-Link MC110CS - page 19

    13 Appendix: Specifications Standard IEEE 802.3 / IEEE 802.3u Connector 1 SC fiber optic; 1 RJ45 jack Cat.5 Twisted Pair:100m Multi-mode Fiber Optic: 2km Max. Distance Single-mode Fiber Optic: 20/40/60km Operation: 0ºC ~ 40ºC Temperature Storage: -40ºC ~ 70ºC Storage: 5% ~ 90% RH Non-condensing Humidity Working: 10% ~ 90% RH Non-condens ...

  • TP-Link MC110CS - page 20

    14 7106503725 ...

メーカー TP-Link カテゴリー Network Card

TP-Link MC110CSのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- MC110CSの取扱説明書
- TP-Linkの製品カード
- パンフレット
- またはTP-Link MC110CSの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、TP-Link MC110CSの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、TP-Link MC110CSの取り付け説明書、サービスマニュアル、簡易説明書、またはTP-Link MC110CSのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、TP-Link MC110CSの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

TP-Link MC110CSデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがTP-Link MC110CSを使用するのを助ける技術的文書のことです。説明書は通常、全てのTP-Link MC110CSユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

TP-Linkの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. TP-Link MC110CSの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははTP-Link MC110CSの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。TP-Link MC110CSに関してこのドキュメントで見つけることができる全てのヒントの目次
3. TP-Link MC110CSデバイスの基本機能を使うにあたってのヒント。 TP-Link MC110CSのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。TP-Link MC110CSに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるTP-Link MC110CSのメーカー/サービスへの連絡先に関する情報。

TP-Link MC110CSについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもTP-Link MC110CSの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがTP-Link MC110CSで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)