Sangean DT-300の取扱説明書

17ページ 1.67 mb
ダウンロード

ページに移動 of 17

Summary
  • Sangean DT-300 - page 1

    ...

  • Sangean DT-300 - page 2

    1 5 3 6 7 8 9 11 12 13 14 2 4 10 2 ...

  • Sangean DT-300 - page 3

    3 Location Of Controls W elcome to SANGEAN W orld of Listening. To ensure proper operation please familianrize yourself with These instructions before using your new receiver. Location of Controls V olume Control--------------------------------------------------------- LCD Display------------------------------------------------------------ Lock swi ...

  • Sangean DT-300 - page 4

    1 2 3 4 5 6 7 8 9 A B C D E F I J K L 4 G H ...

  • Sangean DT-300 - page 5

    5 Display Icons Band Selected/ PM---------------------------------------------------------- Timer / (Alarm)-------------------------------------------------------------- FM Stereo lndicator--------------------------------------------------------- System Lock----------------------------------------------------------------- Low Battery--------------- ...

  • Sangean DT-300 - page 6

    Battery Installation The battery cover is located on the back of the unit. Slide the cover in the direction of the arrow to gain access to the battery compartment insert 2 AAA(UM-4) batteries into the compartment.Make sure that batteries are positioned in accordance with the diagram located below batteries in battery compartment. Replace cover . No ...

  • Sangean DT-300 - page 7

    7 3 8 13 14 8 8 Setting Time When batteries are installed for the first time the LCD display time digit will flash indicating that the time needs to be set. The clock can be set with the power off but the lockswitch must be off. T o set time press Time Set Button for more then 2 seconds until hour digit flashes. While hour digit is flashing use T i ...

  • Sangean DT-300 - page 8

    8 13 14 14 9 9 LCD will return to real time and Standby Set icon will appear in display . A buzzer will sound when set time is reached and will continue for at least 3 mimutes or until it is stopped by pressing the Power On/Off Button. Short T erm Alarm Set This receiver is equipped with a short term 1-180minute timer.T o set timer Press the Alarm ...

  • Sangean DT-300 - page 9

    9 RADIO OPERA TION Antenna/Earphone Use The earphone cord acts as an antenna during reception of FM/TV/Weather Band(DT -300/300V/300VW)channels and should be extended as much as possible to improve sensitivity . Insert the earphone into the earphone jack for earphone operation . When listening with the built-in speaker the enclosed pig tail trailin ...

  • Sangean DT-300 - page 10

    V olume Control The volume may be adjusted by using the V olume Control Adjustment T uning the Radio Band Frequency Antenna AM 520-1710kHz/ Internal-Rotate radio for best 522-1629kHz reception FM 87.5-108MHz External-Make sure earphone or pig tail antenna is inserted into earphone jack. TV CH.2-13(VHF) External-Make sure earphone or (DT -300V/DT -3 ...

  • Sangean DT-300 - page 11

    WX CH.0-9 External-Make sure earphone or pigtail antenna is inserted into Earphone jack A.Scan T uning Turn on the radio by pressing On/Of f Button . Select the desired band by pressing Band Selection Button Press and hold the Tuning Control Button or for more than 1/2 second . The radio will start to scan and will stop at the first active station. ...

  • Sangean DT-300 - page 12

    12 13 14 5 11 8 11 13 14 until the desired station is reached or pressing and holding the T uning Control or until the station is reached. C. Setting Presets Manually Turn on receiver by pressing On/Of f Button .Select desired band by pressing Band Selector Button .Tune to the desired station using the Manual or Scan Tuning Method as described abov ...

  • Sangean DT-300 - page 13

    13 11 11 5 8 12 13 14 station is selected to take its place. When the memory is full for a particular band pressing the Memory Selection Button will cause all the positions to flash. In this case,select the desired position. press the Memory Selection Switch and the original station will be eliminated and the new station will take its place. D.Sele ...

  • Sangean DT-300 - page 14

    5 8 11 12 11 5 8 On/off Button .Select desired band by pressing Band Select or Button . Press Memory Button . Memo will flash in display. Press Select Button for move than 2 seconds until auto/memo appears and flashes in display. press memory Button again. The receiver will automatically begin to scan and set memory preset positions. It will dlimin ...

  • Sangean DT-300 - page 15

    15 Note: If the Select Cursor points at the frequency the Tuning Control Up/Down Button will continue to change frequency within the band selected. If the Selector Cursor points at the position digits for the memory presets the Tuning Control Up/Down Button and will select the memory presets. G .Deleting Memory Positions If The memory is full or yo ...

  • Sangean DT-300 - page 16

    16 9 7 3 3 Mono/Stereo Button Monaural or Stereo headphone reception may be selected durning FM reception by alternately pressing the Mono/Stereo Button The Speaker On/OffSwitch must be in the Off Lock Switch To Prevent accidental changing of any of the radio settings move the Look Switch to the locked position. When engaged in the locked position ...

  • Sangean DT-300 - page 17

    Specification T ype: FM- Stereo (Via earphone) AM- Standard (mono) TV Band (Mono Ch,2-13 VHF) DT -300V/VW W eather Band (WX) (Mono Ch. 0-9) DT -300VW Earphone jack: 3.5 mm mini-plug 16 or 32 ohm impedance (Stereo) Output Power: 50 mW (10 THD) via built-in speaker Speaker: 1.1inch diameter ,4ohm impedance Batteries: 3 volt(AAA/UM-4 size) x 2 Dimensi ...

メーカー Sangean カテゴリー Portable Radio

Sangean DT-300のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- DT-300の取扱説明書
- Sangeanの製品カード
- パンフレット
- またはSangean DT-300の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Sangean DT-300の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Sangean DT-300の取り付け説明書、サービスマニュアル、簡易説明書、またはSangean DT-300のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Sangean DT-300の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Sangean DT-300デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがSangean DT-300を使用するのを助ける技術的文書のことです。説明書は通常、全てのSangean DT-300ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Sangeanの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Sangean DT-300の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははSangean DT-300の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Sangean DT-300に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Sangean DT-300デバイスの基本機能を使うにあたってのヒント。 Sangean DT-300のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Sangean DT-300に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるSangean DT-300のメーカー/サービスへの連絡先に関する情報。

Sangean DT-300についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもSangean DT-300の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSangean DT-300で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)