Cisco 6503の取扱説明書

19ページ 0.64 mb
ダウンロード

ページに移動 of 19

Summary
  • Cisco 6503 - page 1

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 1 of 19 White P aper High A vailability for the Cisco Catalyst 650 0 S eries Switc hes Figure 1 The Cisco Catalyst 6500 Series WS-6503, WS-C6506, WS-C6509, WS-C6509-NEBS, and WS-C6513 Overview Cisco ...

  • Cisco 6503 - page 2

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 2 of 19 redundancy . For more detail on high-a vailability network designs, refer to the white paper , Gigabit Campus Design , at: http://www .cisco.com/en/US/partner/netsol/ns340/ns394/ns147/ns17/ n ...

  • Cisco 6503 - page 3

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 3 of 19 The changes to the switching mode are done automatically , depending on the hardware installed. No specific configuration is necessary on the SFM for typical operation. The current switchin ...

  • Cisco 6503 - page 4

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 4 of 19 Example 2: Classic and Fabric-Enabled System The following output is from a configuration with dual supervisor engines, one SFM, one classic line card in slot 3, and two fabric-enabled line ...

  • Cisco 6503 - page 5

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 5 of 19 Redundant Supervisor Engines As previously mentioned, the High A vailability feature on the Cisco Catalyst 6500 Series provides lo w-impact, stateful switchov er between redundant supervisor ...

  • Cisco 6503 - page 6

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 6 of 19 disabling port channels (PagP), and turning trunking of f for ports to which workstations are directly attached, the fast switchov er time can be reduced to approximately 10 seconds. In a liv ...

  • Cisco 6503 - page 7

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 7 of 19 T able 1 shows protocols and features for high a v ailability as of Cisco Catalyst OS version 7.5 that are supported, compatible, and incompatible. For a current list of the features that are ...

  • Cisco 6503 - page 8

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 8 of 19 Both supervisor engines run a synchronizing operation to allow for transfer of this data. When a database entry is updated on the activ e supervisor engine, the synchronizing operation places ...

  • Cisco 6503 - page 9

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 9 of 19 The image synchronization feature of Cisco Catalyst OS provides software consistenc y between supervisor engines, but it does not allow for softw are upgrades without taking the system offli ...

  • Cisco 6503 - page 10

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 10 of 19 http://www .cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_1982.htm Cisco Catalyst OS Image Upgrade Procedur e Based on the discussion abov e, the following procedure is recomm ...

  • Cisco 6503 - page 11

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 11 of 19 10. Reset the standby supervisor engine. Sup-A> (enable) reset 2 The standby supervisor engine reboots with the new Cisco Catalyst OS image, remains in standby mode, and does not af fect ...

  • Cisco 6503 - page 12

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 12 of 19 Dual Router Mode DRM is the original MSFC configuration for redundant supervisor engine or MSFC configurations. In this mode, both MSFCs are activ e routers on the network. Having tw o act ...

  • Cisco 6503 - page 13

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 13 of 19 The following commands enable MSFC config-sync: MSFC-Sup-15 (config)# redundancy MSFC-Sup-15 (config-r)# high-availability MSFC-Sup-15 (config-r-ha)# config-sync W ith config-sync, all con ...

  • Cisco 6503 - page 14

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 14 of 19 For these scenarios, SRM is no w av ailable. Single Router Mode SRM is provided as an option for customers who wish to implement redundant supervisor engines or MSFCs in a system with only o ...

  • Cisco 6503 - page 15

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 15 of 19 The same IP and Media Access Control (MA C) addresses are used for the designated router , whether or not the MSFC is the designated router . The MSFC that is chosen as the designated router ...

  • Cisco 6503 - page 16

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 16 of 19 SRM and IP Multicast W ith SRM, the VLAN interfaces on the nondesignated router are in a down state. Even after a f ailover , these interfaces will not mov e into an up state until the super ...

  • Cisco 6503 - page 17

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 17 of 19 DRM hostname DRM ! redundancy high-availability config-sync ! interface Vlan20 ip address 10.20.1.3 255.255.255.0 alt ip address 10.20.1.2 255.255.255.0 standby ip 10.30.1.4 standby priority ...

  • Cisco 6503 - page 18

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 18 of 19 disabled, the power a v ailable to the system is the combined power of the po wer supplies. Note that in this configuration, if one supply fails, the system might not ha ve enough power to ...

  • Cisco 6503 - page 19

    Corporate Headquarters Cisco Systems, Inc. 170 W est T asman Drive San Jose, CA 95134-1706 USA www .cisco.com T el: 408 526-4000 800 553-NETS (6387) Fax: 408 526-4100 European Headquarters Cisco Systems International BV Haarlerbergpark Haarlerbergweg 13-19 1101 CH Amsterdam The Netherlands www-europe.cisco.com T el: 31 0 20 357 1000 Fax: 31 0 20 35 ...

メーカー Cisco カテゴリー Switch

Cisco 6503のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 6503の取扱説明書
- Ciscoの製品カード
- パンフレット
- またはCisco 6503の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Cisco 6503の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Cisco 6503の取り付け説明書、サービスマニュアル、簡易説明書、またはCisco 6503のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Cisco 6503の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Cisco 6503デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがCisco 6503を使用するのを助ける技術的文書のことです。説明書は通常、全てのCisco 6503ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Ciscoの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Cisco 6503の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははCisco 6503の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Cisco 6503に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Cisco 6503デバイスの基本機能を使うにあたってのヒント。 Cisco 6503のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Cisco 6503に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるCisco 6503のメーカー/サービスへの連絡先に関する情報。

Cisco 6503についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもCisco 6503の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCisco 6503で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)